If two resistors with resistance 6.0 Q and 8.0Q are connected in series with 12.0 volt source, then find the overall current in circuit. A 0.86 A B 0.56A C 0.22A D 1.24A

Q: Q2) Design a clamper to perform the function indicated in Figure (2), and calculate the time…

A:

Q: 1. The reverse bias diodes a. D1 only b. D2 only c. Everything d. None 2. The close circuit is a. R1…

A: Given data, Circuit diagram is given as,

Q: 30 as the Q-factor of the circuit increases, better increase, worse O decrease, better O decrease,…

A: In this question we will write about Q factor and selectivity relation....

Q: Q.9 Find all static error constant for a unity feedback system with feedforward transfer function…

A:

Q: Q2/Suggest a LTI system to convert the input from r(t) = A cos(t), to output equal to c(t) = 2A…

A: given here input of a LTI system is r(t) = A sin(t) and output is c(t)=2A sin(t) here we have to…

Q: Q3-a: A signal x[n] has the following DTFT Determine the DTFT of the following signals: 1) x[n+1].…

A:

Q: Two wire transmission line whose cross section is illustrated below. Each wire is having a diameter…

A: Given data, Wire diameter is 2 m, The distance between both the conductor is 8 m, The value of the…

Q: The voltage at the sending side (source) of a transmission line is 1 KV (Vs = 1 KV). The voltage at…

A:

Q: 79 To reduce the effect of a voltmeter upon thencircuit under test, we should decrease the…

A: To minimize the voltmeter loading, we can use  an instrument with a high internal resistance.

Q: Where push-buttons are being used in our daily lives? State some examples.

A: Given: Push button

Q: Fill-in Questions: 1. The forward voltage across a silicon diode in a normally working circuit is V.…

A: Diode: Diode is basically a p-n junction device which has the property of conducting current in only…

Q: A 2 kVA, 380/210 V, Single phase transformer has a leakage impedance of (0.02 + j 0.05) per unit.…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: 4. The switch has been open for a long time before closing at t = 0. Find v(t) and dv/dt for t > 0+.…

A: Given circuit :

Q: Explain the definitions of three sets of sequence components. Take voltages or currents for example,…

A: Three sets of sequence components: The power system fault causes an unbalanced condition of…

Q: Q.5/45-5) Marks: A- A hovering vehicle control system is represented by two state variables, and…

A:

Q: In a parallel resonant circuit there is practically no difference between the condition for uni…

A: An Q factor is a dimensionless parameter it is used for calculating the energy lossess in the…

Q: Vs Rsig CG V₁ G RG O Draw the equivalent circuit. DD Ro S Rs Cs RL Vo

A:

Q: 12V D1 R1 1k RRR D2

A:

Q: Q2. Put (T) for true sentences and (F) for fouls one of all the following sentences and (correct the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 7 A

A:

Q: 2. Determine the AVSH, AVSL, BW. SHOW YOUR SOLUTIONS V2 R5 >4kQ 20V R2 >40KQ Q1 C3 R1 2N2222A R4 R3…

A: For small signal BJT Amplifier the value of capacitor consider as short circuit as at input AC…

Q: Q1: Simplify the block diagram shown in Fig. (1), then obtain the closed-loop transfer functions…

A:

Q: Q.3: A 18kVA, 200/600V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

A: Note: As per the policy we can solve only 3 sub parts of a single question, please re-upload the…

Q: 1. Find the value of current i₁, 12, 13 for the circuit shown in the Fig.Q01 (i) and Fig.Q01 (ii) 12…

A:

Q: Determine the size of capacitor in uf necessary to increase the power factor to 0.90 if the load has…

A: It is asked to determine the size of the capacitor in μF, that is required to increase the power…

Q: QI/Compute and sketch the impulse response of the LTI system whose step response is: 012

A: Given data: The given figure of step response is shown below,

Q: Control system If an electrical network has three energy-storage elements, is it possible to have a…

A: Control system is the set of the mechanical and electrical device to regulate and it provide the…

Q: Q.3: A 18kVA, 200/600V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 8. A 3-bit count sequence is shown for a counter (Q2 is the MSB). The sequence is a.…

A: Answer:b) 0-1-3-2-6-7-5-4-0(repeat)

Q: Assume an amplifier has a midrange voltage gain of 22. Expressed in dB, this is 13.4 dB 3 dB 40.3 dB…

A: Given: An amplifier has a mid range voltage gain of 22.

Q: Q.3: A 18kVA, 200/600V, 50-Hz, single-phase transformer, the open and short circuit tests data are…

A: Given data is shown below. O.C test : 200V,3.5A,600W S.C test : 15V,30A,400W i.…

Q: Q3:- For the capacitor of Fig-3- a. Determine the capacitance. b. Determine the electric field…

A: We need to find out capacitance and electric field and charge for given capacitor

Q: Q3] find the current of the resistance 2422 if the value of the source is:V1= 2.6sin(100nt- 58) volt…

A:

Q: What is the main function of transistor and zener diode in the circuit below? Transistor Rectifier…

A: For the above given electrical circuit we need to justify functions of each element.

Q: For the circuit shown below, in order to find the value of Vo

A:

Q: WYE TO (ZAB Given: ZA= 11-j10.22 ZB 13+j12_2 2 Zc : 15 tj 142 : VL 360 + Phase sequence VAB - 360…

A: Given: Consider the following figure: ZA=11-j10 ΩZB=13+j12 ΩZC=15+j14 Ω  Line voltage: VL=360 V…

Q: A coit of 40 turns is wound uniformly round a cast steel ring with 0.2A current flow as shown in…

A: Given:  Number of turns N=40Current I=0.2 AA=40 cm2S=2000 At/Wb Required: Magnetic flux Density B of…

Q: (a) (b) (c) (d) 75 V 7.5 [e-401 + e 7.5e-50t - e 7.5[e-401 e 7.5 [e-501 + e (+ -50% ⁰1 Ju(t) A of…

A: Laplace transform is used to the solve the differential equation and it simple the linear…

Q: 5.2 Express the following periodic signals in exponential Fourier series. (a) x₂(t) = A + A₁cos(wt +…

A:

Q: Vi R1 ww 10kQ [R2 >10KQ R5 mw 10kQ [R3 -10k R4 >10KQ R6 ww 10 ΚΩ Vo

A: Operational Amplifier voltage gain:

Q: Q2/ Obtain the equivalent resistance Rab for the circuit in Fig. and use it to find current i. 12.50…

A: For the above given electrical circuit we need to calculate the value of equivalent resistance and…

Q: Vi R1 ww 10kQ [R2 >10KQ R5 mw 10k [R3 -10k R4 >10KQ R6 ww 10k Vo

A: Voltage gain:

Q: Find the equation of that streamline that passes through the point P (1, 4, −2) -8x 4x² in the field…

A: dydx = EyEx = 4x2y2-8xydydx = -x2y2y×dy = -x×dxy2 = -x22+c ............1it passes through P1,4,-2So…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 30°, through a…

A:

Q: Two 11000/400 V, transformers are operated in parallel to share a load of 250 KVA at 0.85 power…

A: Solution -  Given,Transformer rating = 11000/400 VTotal load =250 KVAPF =0.85 laggingA. For 100…

Q: The switch in the following circuit has been opened for a long time. It is closed at t = 0.…

A: In this question,  We need to determine the voltage across the resistance 2 ohm We know, voltage…

Q: State the different types of a push button (explain briefly each), and also give examples where it…

A: The solution is provided in the following section.

Q: Is the impulse response of the system BIBO stable or not?

A: (5) The impulse response of the system is given as h(n) = 3(-1/4)n u(n-1) The impulse response is a…

Q: Describe the series and shunt input connections of a feedback amplifier.

A:

Q: The nature of the graph between the speed and field current of DC shunt motor is O Linear O Straight…

A: In this question we will find relation between speed and field current of dc shunt motor...

Current Division Method

The generalized current divider formula is given by the following relation below,