Answered: What is the value of the current when…

Engineering

Electrical Engineering

What is the value of the current when the voltage is at its positive peak?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: An AC circuit includes two sections AB and BC in series. The section AB consists of two branches in…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…

Q: a) Design the circuit and sketch the waveform and the phasor diagram of voltage and current in i.…

Q: In the figure, the capacitor is initially uncharged and R the switch (S) is closed at t = 0. (a)…

A: Transient Transient represent sudden change in the state of a network or circuit which are indicated…

Q: A steady current of 3 A is flowing through an inductor with 60 volts across it. Find the Inductance…

A: Given: VL=60 VI1=3 AI2=0 A∆t=200 msec

Q: 1. The variation of current through a 30mH inductor is shown in the figute. Eed the Sketch the graph…

Q: A resistor and a capacitor are connected in series across a 150V AC supply. When the frequency is…

A: It is given that: V=150 VAt frequency of 40 Hz: I1=5 AAt frequency of 50 Hz: I2=6 A

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…

Q: a. As capacitor charges, describe the behavior of: i.current with time ii. the voltage across the…

A: As we know that as capacitor charges the voltage across capacitor increases and at steady state it…

Q: 1. The waveforms x, y, and z are connected to the circuit presented in the figure below. Assuming…

A: This question requires timing diagram of the circuit and truth table of SR flip flop

Q: (c) ) Consider the RL (resistance/inductance) circuit with a voltage v(t) applied as shown in Figure…

Q: A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V…

Q: The initial rate of current rise in an RL circuit is 300 amp per sec when 120 volts is suddenly…

A: This question belongs to circuit theory . It is based on the property of opposition by inductor in…

Q: Find the equivalent inductance between terminals A and B in the following figure. Assume no mutual…

A: If three inductors of inductance L are connected in parallel then equivalent inductance is L/3. If…

Q: If the ripple voltage of this circuit is to be no more than 4V, determine analytically what…

Q: For the given figure below, the source voltage is V, = 220 V(constant time), and the load inductance…

A: Vs=220V L=220μH

Q: An AC circuit includes two sections AB and BC in series. The section AB consists of two branches in…

A: According to the question, the given circuit is shown below: Given the voltage across branch AB is…

Q: Given the following find: The reactive power dissipated by the source is (in Vars) The apparent…

Q: Q1 How is the initial current through a bulb affected by putting a capacitor in series in the…

A: 1) When one places a capacitor in a circuit containing a light bulb and a battery, the capacitor…

Q: A voltage of 200 V is applied to a series circuit consisting on a resistor, an inductor and a…

Q: Initial conditions for the circuit below: switch is open and capacitor is uncharged. Determine the…

A: GIVEN: R1=4ΩR2=4ΩR3=5ΩR4=3ΩV=10V FIND: initial and steady state current through…

Q: Why do the waveform of the pair resistors meet in the x-axis? Where do they actually meet? Explain…

A: The given waveform is,

Q: An inductor is connected in parallel with a 6540 resistor and a function generator. The applied…

A: Let current through the resistor be IR and current through the inductor is IL and I be total source…

Q: This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in…

A: Capacitor: It is an element used to store electrical energy in the electrical field. A capacitor is…

Q: 4. A RC series circuit is composed of a resistor of resistance 50 ohms and a capacitor of…

A: The voltage across the capacitor is given as Thus the voltage can be written as

Q: For the circuit shown in figure below, the switch has been opened for a long time and then at t=0…

Q: - The independent current source in the circuit generates zero current for t 0. 100 mH a) Sketch…

A: we have given; in circuit the independent current source genrates 0 current where pulse 10te-5tAfor…

Q: Describe the resulting waveforms when the capacitors (initially 20uF and then replaced with 100uF)…

A: The output waveforms are as shown below,

Q: A pure inductance of 1.273mH is connected in series with a pure resistance of 30ohms. If the…

Q: Assume that you are constructing a certain ac circuit on bread board during your lab session. An…

A: Given circuit is R - L series circuit. Given values are =

Q: A series circuit consisting of 17ohm resistance and 20mH inductane is connected across a 220V(RMS)…

A: The solution is given below

Q: Find the phasor voltage Vab between points A and B in the figure.

Q: If the maximum value of the welding voltage in the circuit in the figure is Vm = 150 V and the…

A: Given: Vm=150V Frequency f =50 Hz Inductance L=150 mH Resistance R=5 ohm

Q: The following circuit has a voltage across the load of 18V, a peak-peak ripple voltage of 318mV,…

A: Given With capacitor V0(cap)=18 V Peak to peak ripple voltage Vrpp=318 V To find output voltage…

Q: An L-R series circuit consists of an inductor with inductance, L, connected in series with a…

A: KVL equation in the loop will beE=LdIdt+RIdIdt+RLI=1LE-----1Generalized 1st order differential…

Q: 4. A series RL circuit has an EMF of 50V, a resistance of 5 ohms, an inductance of 15 henry.…

A: In this question, Find the current in the circuit after t>6s. Find the voltage across the…

Q: CK

Q: Q2/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: The solution can be achieved as follows.

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Given data The RMS voltage 20 V The maximum positive amplitude is 10 V maximum negative amplitude -5…

Q: Which of the following is true about all series ac circuits?(a) The voltage across any circuit…

A: It is given that:

Q: Assume that a voltage of 16 V is applied to a 47-Ω load resistor that is connected in series with a…

Q: In a circuit where the total voltage is defined by 200sin (300t + 45degrees) V, what is the period…

A: The given voltage expression is written as: v(t)=200sin(300t+45°)V This is the standard expression…

Q: A certain circuit is in steady state. It is composed of a resistor R = 40kΩ in series with an…

A: Given data, The value of resistance is R = 40 kΩ. The value of inductor is L = 1 mH. The value of…

Q: An alternating current bridge is arranged as follows: The arm BC and DA consists of non-inductive…

Q: Urgent. In the circuit shown in the figure, the RL load is connected to a 20V source when switch K…

A: As the switch is connected to the dc voltage source so the inductance will be shorted .

Q: A 1,000-W electric motor is connected to a sourceof 120 Vms, 60 Hz, and the result is a lagging pf…

A: A 1000-W electric motor is connected to 120 Vrms having 60Hz frequency. Part (A):- To calculate the…

Q: 5- Find circuit. the values 20K Ind when switch is in positia た= When switch isin position 2. Assume…

Q: Construct a Circuit using a resistor and an inductor that has the following Amplitude vs. Frequency…

A: The Amplitude vs. Frequency plot is as shown below:

Q: A certain circuit is in steady state. It is composed of a resistor R = 40kN in series with an…

A: The circuit with the given elements is shown in the figure below. The time-constant of the circuit…

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

100%

An alternating current flowing through a circuit has a maximum value of 70A, and
lags the applied voltage by 600
. The maximum value of the voltage is 100V, and both
current and voltage waveforms are sinusoidal. What is the value of the current when
the voltage is at its positive peak?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship between the applied circuit voltage and the circuit current? The applied voltage lags the circuit current. The phase shift between the circuit voltage and current changes with time. The applied voltage is in phase with the circuit current. The applied voltage leads the circuit cur Previous Page Next Page Page 2 of 10
7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform will havephase shift * 180 deg O deg 45 deg O 90 deg 8. Why do we say the "voltage across" or "the voltage with respect to?" Why can't we just say voltage? * Voltage is a measure of electric potential difference between two electrical points. O It's an electrical cliche. The other point could be negative or positive. None of the above.
A voltage of 6 cos(100rt) V is fed as y-input to a CRO. The waveform seen on the screen of the CRO is shown in the figure. The Y and X axes settings for the CRO are respectively
1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.
The peak-to-peak alternating potential difference across a 150 2 resistor is 339 V. The r.m.s. current in the resistor is?
a. individal current b. voltage source
A 100mH pure inductance is connected in a parallel with a 40ohms resistor. What is the power drawn if the voltage is 220volts and 60hz?
A series circuit consists of a 66.4 microfarad capacitor and variable resistor. For what two values of resistance will the power taken by the circuit be 172. 8 W, if the impressed 60 Hz emf is 120 V?
AC Circuits Sine-wave generator f- 25 kHz V₁ = 3.0 V VR 888 100 mH Figure 6-Test Circuit 3. Using a two-channel oscilloscope, measure the peak-to-peak voltage VR across the resistor and the peak-to-peak voltage VL across the inductor. Measure the voltage across the inductor using the difference technique described in a previous experiment. Record the voltage readings in Table 2. VL 10 k 1 XL Table 2- Measured and Calculated Values (f = 25 kHz) ZT
A direct current (DC) of 4A flows into a previously uncharged 20 uF capacitor for 3 ms. Determine the voltage between the plates. OA. 500 V O B. None of the given answers OC 600 V O D. 200 V
What is the equivalent resistance ?? and what is the total inductance ??
QUICK A 100 µF capacitor in series w/ a 50-ohm resistance is connected suddenly across a 125-volt DC supply. What is the voltage in the capacitor after 10 ms? 79 V 100 V 108 V 125 V