If the carrier signal is Vc (t) = Ve Sin (Wst). And the information signal is used to generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 12 KHz, modulation index m = 0.5 and the spectrum frequency for AM is shown figure: 6 6 -100-6fm -100 -100+6fm 100-6fm 100 100+6fm KHZ | 1- determine W, Wm, fm. fe 2- draw the AM wave in time domain 3. determine Vm. Vc 4 dotorming th ohm (1 0)

If the carrier signal is Vc (t) = Ve Sin (Wst). And the information signal is used to generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 12 KHz, modulation index m = 0.5 and the spectrum frequency for AM is shown figure: 6 6 -100-6fm -100 -100+6fm 100-6fm 100 100+6fm KHZ | 1- determine W, Wm, fm. fe 2- draw the AM wave in time domain 3. determine Vm. Vc 4 dotorming th ohm (1 0)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

1. Calculate the total power of AM signal (par-A). 2. Calculate the bandwidth of AM signal (part-A). 3. Draw the spectrum of AM signal (part-A). DC Vmax Vmin m 3v 1.4 0.25 0.7 2v 1 0 1 1v 0.8 -0.36 1.94
An AM transmitter antenna current is measured with no modulation and found to be 2.6 amperes. With modulation, the current rises to 2.9 amperes. The percent modulation is asnwer: 70% i just need the solution
Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This modulator is used to transmit audio signals containing frequencies in the range of 100 Hz to 15 kHz. The narrowband is supplied with a carrier of frequency fl-0.1 MHz by crystal- controlled oscillator also ß-0.2, a second crystal- controlled oscillator supplied a sinusoidal wave of frequency 9.5 MHz to the mixer. The system Carrier frequency at the transmitter output, fc-100MHz Minimum frequency deviation, Af-75, find nl and n2? f(t) NBFM Freq. Multiplier 1 Oscillator1 Fig. (1) Mixer Oscillator2 Freq. Multiplier 2 frm(t) n1=72, n2=47 O n1=73, n2-48 O n1=75, n2=50 n1=77, n2=52 O n1=76, n2=51 O
Explain the differences between Angle and Amplitude modulation. Both techniques positive and negative Talk about its features.
If the carrier signal is Ve (t) = Ve Sin (Wst). And the information signal is used to generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 12 KHz, modulation index m = 0.5 and the spectrum frequency for AM is shown figure: 6 -100-6fm -100 -100+6fm 100-6fm 100 100+6fm KHZ | 1- determine Wc. Wm, fm. fe 2- draw the AM wave in time domain 3. determine Vm. Vs 4-determine the power at carrier of the antenna resistance one ohm (1 2) 5- Write the AM equation with all values.
3: Compare with aid of figures and equations between the Frequency Modulation (FM) and Phase Modulation (PM). Then draw the FM and PM signals.
If the carrier signal is Vc (t) = Ve Sin (Wst). And the information signal is used to generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 12 KHz, modulation index m = 0.5 and the spectrum frequency for AM is shown figure: 6 6 -100-6fm -100 -100+6fm 100-6fm 100 100+6fm KHZ | 1- determine Ws. Wm, fm. f. 2- draw the AM wave in time domain 3. determine Vm. Vc 4-determine the power at carrier of the antenna resistance one ohm (1 2) 5- Write the AM equation with all values.
The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The x-axis is in time while the y- axis is the amplitude of the AM signal. If the peak voltage level of modulating and 1v and signal respectively, determine the modulating index. the carrier are 2V 2 1.5 1 0.5 -0.5 -1 -1.5 -2 0.005 0.01 0.015 0.02 0.025 0.03 0.035 0.04 0.045 0.05 Time (s)
Deter mine the modulation and instantenous frequency of signal $ (t) = A Cos ClotT tīt') at t=0 %3D
For the given circuit below, the RF generator is set to EXT MOD, 500kHz. RF GEN 500KHZ R1 2702 R2 10K ELECTRONIC VOM 0.0047pF a) What is this circuit? b) Is there an RF signal across R2? c) Draw the expected signal waveform across R1 d) Draw the expected signal waveform across R2 e) What is the expected frequency of the signal across R2?
If the carrier signal is Vs (t) = Ve Sin (Wst). And the information signal is used to generate AM wave Vm (t) = Vm Sin (t), the AM Bandwidth is equal to 10 KHz, modulation index m = 0.6 and the spectrum frequency for AM is shown figure: 4 41 -100-5fm -100 -100+5fm 100-5fm 100 100+5fm KHZ 4-determine the power at carrier of the antenna resistance one ohm (1 2) 5- Write the AM equation with all values.
At two distinct places, a signal is measured. At the first point, the power is P1, and at the second point, it is P2. The decibel level is zero. This denotes