certain non - resistive inductor of L = 150mH is connected across a lossless capacitor of C = 450microfarad. If the combination is connected across a 230V variable frequency supply, determine the resonance frequency

certain non - resistive inductor of L = 150mH is connected across a lossless capacitor of C = 450microfarad. If the combination is connected across a 230V variable frequency supply, determine the resonance frequency

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 4RQ: A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant...

See similar textbooks

Related questions

Q: An angle-modulated by the equation: QFM(t) = 10 cos (Oct + 2 sin 2000лt). a) Write expressions for…

A: Only one frequency component of the baseband or message signal is used in single-tone modulation.…

Q: Sketch the Bode plots for 50 jas Но) (jar + 4)(jas + 10)

A: Write the given transfer function,

Q: For the Civcuit showni. O Derive an equation For suitable Calue of AL that give Yesonance at tuo…

A: Part (1): The capacitive reactance is given by:

Q: For the electric circuit shown in figure below, find the value of the average total power at…

A: At Resonance means:- Xl=Xcwl=1wcl=1w2c =1106×1×10-3 =10-3H

Q: How to draw bode plot?

Q: The gap between two neighboring spectral components in a sampled signal exist if we choose sampling…

A: The gap between two neighbouring spectral components in a sampled signal exist if we choose samfling…

Q: A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulating frequencies equal to…

Q: What is the bandwidth occupied by a frequency modulated sinusoidal carrier with a modulation index…

A: In the question What is the bandwidth occupied by a frequency modulated sinusoidal carrier with a…

Q: Q3: A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulating frequencies equal…

A: From the question the carrier frequency Fc=2.5 GHz Modulating…

Q: For an AM superheterodyne receiver, station A with RF signal of 1000 kHz uses high side injection to…

A: As per company guidelines we can solve only first three sub parts kindly post another question…

Q: r,() = 4sin (2-200) - 6cos(2x400 +#), sketch the frequency plot for the resulting AM signal and…

Q: Q1. Derive an expression for the input impedance of the equivalent network for che passive component…

Q: The carrier c(t) = A cos 2n10 (PM or FM) "' by is angle modulated the signal m(t) = 2 cos(2000nt).…

A: The answer as given below:

Q: a) An angle modulated signal with carrier frequency f. = 10MHZ is described by the equation PEM (t)…

A: Angle Modulated Signal Power = (Ac)^2/2 Ac Carrier Amplitude

Q: find out the bandwidth if the maximum signal frequency is 50khz? 2- calculate the Viltoge goin 't…

Q: Dimensions of a hollow rectangular resonator, where a>h, since it is b= 1cm ,h=2.155cm and f =8.57…

A: Given a > h b = 1 cm h = 2.155 f = 8.57 GHz

Q: A 10kHz sinusoidal is used to frequency modulate a 120kHz carrier signal; peak frequency deviation…

Q: For an FM modulator with modulation index m = 2, modulating signal Vm (t) = 5 sin (2000pit) and…

A: For an FM modulator with modulation index m = 2, modulating signal Vm(t) = 5 sin(2000πt) and…

Q: Answer the Following and provide solution. 1. The maximum frequency deviation of the carrier is ±…

A: Since there are multiple questions uploaded within the same question, therefore solving the first…

Q: 6. For an FM modulator with modulation index m = 2, modulating signal V„ (t) =V,, sin (2x2000t), and…

Q: explain how to find the resonance frequency, 3dB lower limit frequency, upper limit frequency,…

A: The given circuit is as shown below, We need to find the resonance frequency, 3dB lower limit…

Q: For the Circuit given, draw the frequency response. That is, determine the lower and upper cut-off…

Q: A 400-ohm resistor, a 20-uf capacitor, and a 0.505-henry inductor are connected in parallel and are…

A: The solution is given below

Q: 1. Consider a Transmission System comprising a single electrical cable with a bandwidth of 30MHz.:…

A: A transmission system is a system used to transmit data from one place to another and the receiver…

Q: What is the bode plot magnitude for the network function below?

Q: Q1. Derive an expression for the input impedance of the equivalent network for the passive component…

Q: Given the resonance frequency in a microwave resonator, what is the resonance mode?

A: Frequency below which attenuation occur and above which propagation occur is called cutoff…

Q: (Sn(名

A: To Draw to bode,s plot first we have to determine cutoff frequencies. which is 1 rad/sec and 10…

Q: For an AM commercial broadcast band receiver (535 kHz to 1605 kHz) with an input filter Q-factor of…

Q: Using a 15-k(ohm) resistance, design an RC high-pass filter with a breakpoint at 200-kHz.

A: Breakpoint frequency for RC high-pass filter is given by: fc=12πRC Given:fc=200 kHzR=15 kΩNow…

Q: Consider an air-filled rectangular having dimension 4cm×3cm. Then the dominant mode and number of…

A: A waveguide is a hollow metal tube which is classified in different types on the basis of the shape…

Q: A second order system with a natural frequency (wn) of 6 rad/sec and damping ratio of 0.5, the value…

A: Given, For a second order system ωn=6 rad/secζ=0.5

Q: Q3: A carrier wave of frequency 2.5 GHz amplitude is modulated with two modulating frequencies equal…

A: Modulating frequencies of the two signals are 1 kHz and 2 kHz.

Q: why do I get the self resonance graph of a inductor in a tank circuit instead of the resonance…

A: Tank circuit A coil is connected in parallel with capacitance Resojance occurs When recatance of…

Q: 3. The radiation resistance of an antenna 72 ohms, loss resistance is 8 ohms .What is the…

Q: An FM signal has a maximum frequency deviation of 1500h and a modulating frequency of 500h, its…

A: According to the question, for the given FM signal The maximum frequency deviation △f=1500 Hz…

Q: (Difficulty: *) Consider the magnitude DTFTS |X(ej")| and Y(ej")| shown below, where vertical lines…

A: X(jw)=a1δw+a2δw-π6+a3δw-π3+a4δw-π2+…

Q: A series circuit consisting of a 17-ohm resistor, a 0.075-henry inductor, and a variable capacitor…

A: In this question, We need to determine the value of capacitor C and current and voltage across the…

Q: Establish the relation between dB and dBm while measuring the power of an antenna.

A: The dBm is a logarithmic unit of power and it stands for power in decibels when the reference power…

Q: volts is applied as input voltage to a series resonant circuit consisting of a 10Ω resistor, a 60uF…

A: In this question , we will find bandwidth for series resonating RLC circuit....

Q: 2. Can we obtain a plot of X, against frequency fexperimentally?

Q: 11 0.9 0.8 0.7 与 0.6 0.5 0.4 0.3 0.2 0.1 10 /11 12 0.1 0.2 0.3 0.4 0.5 A carrier (fc = 100MHZ, A̟ =…

Q: Determine the IF Bandwidth necessary to achieve a bandwidth improvement of 16 dB for a radio…

A: Given data: Bandwidth improvement Bimprovement=16 dB RF bandwidth of the receiver BRF=16 kHz

Q: Given a control system shown in Figure 5, answer the following questions: (a) Using the asymptotic…

A: A control system is a system that controls the output to produce the desired response. A control…

Q: The number of waves in a microwave resonator, k = p01/a given as, what is the resonance mode?

Q: Calculate the bandwidth of an antenna having a cut off frequency of 110 MHz and a Q factor of 70

A: given: cut off frequency f0 = 110 MHz Q factor = 70

Q: An FM radio broadcast used a modulator with a frequency deviation sensitivity of 5KHz/V, a 2Vp – 10…

A: The solution is given below

Q: An NRZ polar code is using the following function to represent the 1 P() = sinc(rt /T,) a) Find…

A: Given the PSD of polar line code : Sy(f)=P(f)2Tb An NRZ polar code is using the following function…

Q: could you VISUALLY show how you would draw a bode plot step by step?

A: Bode Plot-Huge bandwidth systems are difficult to analyze by other frequency response analyses. For…

Question

A certain non - resistive inductor of L = 150mH is connected across a lossless
capacitor of C = 450microfarad. If the combination is connected across a 230V variable
frequency supply, determine the resonance frequency

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A tank circuit contains a capacitor and an inductor that produce 30 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277 V is connected to the circuit. What is the total circuit current at the resonant frequency?
A series circuit consisting of a 302, resistor and a 4µF capacitor is connected in parallel with a variable inductor. For what value of inductance will the circuit be in resonance if the frequency of the source is 1,200cps?
A series circuit consists of a 120V, 50HZ source, a 300 resistor, a 100mH inductance, and a variable capacitance. Find the capacitance required to create a series resonance condition at this frequency. O 202.8uF 507.12uF O 101.4uF O 676.16uF
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.
The current at resonance in a series R-L-C circuit is 0.12mA. The circuit has an induc- tance of 0.05 H and the supply voltage is 24 mV at a frequency of 40 kHz. Determine (a) the circuit resistance and (b) the circuit capacitance.
The inductance coil in the series resonant circuit is 0.2 H, and the resistance coil is 50 Q. At what capacitance value does resonance occur at 1500 kHz in this circuit? Assuming a 100 V r.m.s. e.m.f. at the source.
The current at resonance in a series L-C-R circuit is 100μA. If the applied voltage is 2 mV at a frequency of 200 kHz, and the circuit inductance is 50µH, find the circuit resistance, and the circuit capacitance.
In a series resonant circuit, a resistor of resistance 500 ohm, an inductor of inductance 4.5 henry (H) and a capacitor of unknown capacitance are present. If the resonant frequency is 20 kHz, then what will be the value of the capacitance?
A capacitance of 50microfarad and an inductance of 0.2025 Henry are connected in series. If the resistance of the circuit is negligible find the frequency at which resonance occurs
The current at resonance in a series L– C–R circuit is 100µA. If the applied voltage is 2 mV at a frequency of 200 kHz, and the circuit inductance is 50µH, find the circuit resistance, and the circuit capacitance.
The inductance coil in a series resonant circuit is 0.2 H and the resistance coil is 50 Q. What is the capacitance value in the circuit that causes resonance at a frequency of 150 KHz? The source produces an emf of 100 V r.m.s.
A series circuit consists of a reactor of 0.1 henry inductance and 5 ohms resistance and a capacitor of 25.5 μ F capacitance. Find the resonance frequency and the percentage change in the current for a divergence of 1 percent from the resonance frequency. [100 Hz, 1.96% at 99 Hz; 4.2% at 101 Hz]