How to go about approval of specification if the Employer's agent in the General Conditions of Contract (second edition, 2010) for Construction Works is not reasonable?

Q: When excavating the stratum, calculating the support axial force for multiple times will produce…

A: When excavating the stratum, Calculation of the support axial force multiple times will produce…

Q: A cana be 2-hour unit hydrograph as trapezoidal as approximated shown in figure. The unit hydrograph…

A:

Q: Find the first 3 terms in the Maclaurin series for the function f(x) = sin²x

A:

Q: Two tangents intersecting at V which is inaccessible has an angle of intersection of 30°. Two points…

A:

Q: A core cutter 15 cm in height, 10 cm in diameter, and having a mass of 1078 gm when empty is used to…

A:

Q: You’ve conducted a soil extraction on the site to have its soil profile determine, you’ve gathered…

A: Let's draw the phase diagram to proceed with the solution Let's say density of soil solid = dsolid…

Q: A rectangular beam of RCC 200 mm wide and 415 mm effective depth is reinforced with 4 bars of 20 mm,…

A:

Q: Question: Determine deflection at point D i-e @ center of member BC and slope @ B for the structural…

A:

Q: Use the conjugate-beam method and determine the displacement at D and the slope at C. Assume A is a…

A:

Q: Solve the equation using Jacobi's method until 5 iterations. 5x₁ - x₂ + 2x3 = 12 3x₁ + 8x₂ − 2x3 =…

A:

Q: 41. Determine the collapse load factor a for the propped cantilever beam ABCD shown in Figure P4.1.…

A:

Q: A plane frame structure is shown as following figure El=1. Assuming that the inflection points are…

A: Solution: Analyse using Factor Method: Calculate the girder factor 'g' at all joints by: g = ∑kc∑k…

Q: Reinforced concrete water storage tanks are going to be used to hold water with high salinity and…

A: Following is required answer :

Q: tank contains water upto a height of 1 m above the base. An immiscible liquid of sp. gr. 0.8 is…

A: Given:- The height of the water in a tank = 1 m The specific gravity of the liquid = 0.8 The height…

Q: In the Figure 5, if the Young modulus is 200 Gpa, the strain percentage in the direction of the…

A:

Q: An increase in pressure of 2 bars decreases the volume of a liquid by 0.01 percent. Find the bulk…

A: Given data- Increase in pressure ∆P=2 bars 1 bar=105 N/m2⇒∆P=2 bars =2×105 N/m2decrease in volume…

Q: In the Figure 3, if m=15 kg, 0=30°, and static coefficient of friction = 0.25, then the maximum…

A: Given data in question  Weight Angle Coefficient of friction  To find out  Frictional force

Q: Find reaction forces and all the force members with the corresponding types of force for the give…

A:

Q: 22.A column is SEN S3 m 2 m in plan as shown E EMMANUEL Fig.3. Given: DASHE 1.5 m, f ¢= 22°, CC = 60…

A:

Q: Determine the external reactions at A and F for the roof truss loaded as shown. The vertical loads…

A: Determine external reaction for support at A and F

Q: Question 1 Find reaction forces and all the force members with the corresponding types of force for…

A: Note: student must check the question again. At B point there is a concentrated load of 820 N in…

Q: A steady push on the piston in a syringe is shown in the figure causes a flow rate of 0.4 ml/sec.…

A:

Q: With the 205-lb cylindrical part P in its grip, the robotic arm pivots about O through the range-45…

A:

Q: The area of a triangular lot is needed to be computed. The sides of triangle ABC were measured as…

A:

Q: 1) The figure shows a conduit made of 1 std type K drawn copper tubing that conveys acetone at a…

A: Given :

Q: . Compute the maximum bending moment and the maximum shearing force.

A: This question is from structural analysis

Q: A centrifugal pump delivers 900 m3/hr of sea water of sp.gr.= 1.03 from a source wherethe water le…

A: Given:Discharge form the centrifugal pump(Q)=900 m3/hrQ=9003600=0.25 m3/sspecific fravity of sea…

Q: PROBLEM 1: Travelling with an initial speed of 70 km/hr, a car accelerates at 6000 km/hr² along a…

A: Answer We are given Initial speed u = 70 Km/hr Final speed v = 120 km/hr Car acceleration a = 6000…

Q: Given a pulley with a constant angular acceleration of 6 rad per sec². Compute the diameter of the…

A: Given Constant Angular Acceleration, α = 6 rad/s² Angular velocity, w = 4 rad/s Total acceleration…

Q: The beam is fabricated from two equivalent structural tees and two plates. Each plate has a height…

A: Given :

Q: A concrete dam holds 10 m of static water as shown in the figure (not drawn to the scale). The…

A:

Q: Question 3 Explain flexural stress in detail. Ensure that the most important properties are…

A:

Q: A layer of sand extends from ground level to a depth of 9m and overlies a layer of clay, of very low…

A:

Q: What is the role and obligation of the Employer's agent in the General Conditions of Contract…

A: Concept- General Conditions of Contract- A formal agreement between the buyer and the supplier, as…

Q: The built-up section made of two MC18 x 42.7 and plates shown in Figure 2. A 22-mm bolts are used…

A: Answer We are given  MC 18 x 42.7 (A = 8129 mm2 and x= 22.35 mm) Shear lag factor U = 0.85  A 36…

Q: A simply supported beam of width 100 mm, depth 150 mm and a span of 2 m carries a point load of 10kN…

A: Given data- simply supported beam-width b=100 mmdepth d=150 mm span L=2 mpoint load P= 10kN at the…

Q: Traffic on a single-lane urban street observes the following flow-density relationship:…

A: Answer We know from Greenshield's linear speed density model q = u*k q = uf*k*(1-kkj) q = capacity u…

Q: pipe containing pump and turbine has enlargement and contraction in diameter, consider all losses…

A: Apply Bernoullis theorem PAγw+vA22g+zA+HP=PBγw+vB22g+zB+HT+HLHP= head due to pumpHT=Head due to…

Q: A column footing of 1.8 mx 1.8 m is to be placed 1.5 m below ground level in a dry cohesionless…

A:

Q: Problem 2: Four 3x3x1/2 equal leg angles are laced together as shown in Figure 3 to form a column…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In a falling-head permeability test the initial head of 2.00m dropped to 0.40 m in 3h, the diameter…

A: Calculate the coefficient of permeability of soil,K=?

Q: 1/2 + VZ 1/2 + 12

A:

Q: Given four lane urban freeway, directional peak flow 1950 veh/hr. 5% truck PHF-0.9 rolling terrain…

A: Given:- Number of lanes = 4 lane The directional peak flow = 1950 veh/hr The percent of trucks = 5%…

Q: Problem 2: (a) Define: (i) specific energy (ii) Froude number For open-channel flow. What is special…

A: Disclaimer Since you have asked multiple questions, we will solve the first question for you. If you…

Q: The backfill behind a retaining wall, located above the water table, consists of a sand of unit…

A: Given data  Y = 19 KN/m3  C = 0   Φ = 38°  H = 8 m

Q: Using method of sections, find the forces in members BC, CG, GH and CH. 720 lb 1440 lb 1440 lb 720…

A:

Q: 2) In a static fluid (b) fluid pressure is zero (c) linear deformation is small (e) viscosity is…

A: 2) in a static fluid a)resistance to shear stress is small b)fluid pressure is zero  c)linear…

Q: 03 (kN/m²) 01-03 (kN/m²) u (kN/m²) 150 103 82 300 202 169 450 305 252 600 410 331

A: Given Data:σ3kN/m2150300450600σ1-σ3kN/m2103202305410ukN/m282169252331

Q: Determine the critical depth for a rectangular smooth concrete flume (n=0.013) 4.5m wide which is to…

A:

Construction Documents

Construction documents are the branch of architectural design and a vital field of the architectural process. We must not mistake the construction documents as a schematic design, wherein it involves sketching, model making, and so on. They provide guidance and instructions to the contractor or the subcontractor and they will study the architect’s building design, question the design professionals if needed, create a project manual and schedule for the successful construction of the proposed structure. Construction documentation acquires the detailed building permits and the design-build is initiated.