Answer this question. Problem 4:In this AC circuit, the resistor offers 3 kQof resistance, and the capacitor offers 4kQ of reactance. Together, their seriesopposition to alternating current resultsin a current of 1 mA from the 5 voltXc = 4 k25 VACsource:R= 3 kaHow many ohms of opposition does theI= 1 mAseries combination of resistor andcapacitor offer? What name do we giveto this quantity, and how do wesymbolize it, being that it is composed ofboth resistance (R) and reactance (X)?

Given , Resistance R = 3 kohm Capacitive reactance (Xc) = 4 kohm Source voltage (Vs) = 5 V…

How many ohms of opposition does the series combination of resistor and capacitor offer? What name do we give to this quantity, and how do we symbolize it, being that it is composed of both resistance (R) and reactance (X)?

How many ohms of opposition does the series combination of resistor and capacitor offer? What name do we give to this quantity, and how do we symbolize it, being that it is composed of both resistance (R) and reactance (X)?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Related questions

Q: A car battery has gone dead and it needs to be replaced with a large capacitor. The old car battery…

A: To solve above problem, one should know capacitors and capacitance offered by a capacitor. A…

Q: Note that the charge Q all came from the power supply through the resistor ) During the chargingthe…

Q: A resistance of 2/(t + 20) Q and inductance of 4 H are connected in series to a battery of unknown…

A: Given that R= 2/(t+20) ohm L= 4 H i1= 0 A , t1= 0sec i2= 50A , t2= 2 sec

Q: electrical circuit contains a capacitor of 11.24 microfarads and a resistor of 1124 ohms. If the…

A: The solution is given below

Q: Answer the following questions with True or False : 1- for the voltage Vab this means that the…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 78 ohms R2 = 60…

Q: Physical properties that affect inductance are: 15) ________ A) area of the coil, permeability, and…

A: Physical properties upon which inductance depends are describing as follows, Inductance relies on…

Q: For the network shown in Figure Q2(a), calculate the following i. the total charge; ii. the charge…

Q: 2. Suppose that you have a circuit that has a resistance of 6 Ohms, capacitance of 1/24 Farads, and…

Q: Using thevenin theorem, determine the charge and discharge equivalent circuits for the Figure 4a.…

Q: Using Kirchhoff's rules, find the following. (E, = 70.2 V, E, = 60.2 V, and E, = 79.2 V.) 4.00 kN d…

Q: 1. What are the electric potential values, emf and IR, in the circuit? 2. What happens to the…

A: The circuit can be made as: The circuit KVL equation can be written as: And the potential…

Q: Find the potential difference between point a and point b for the situation shown below. Here E1 =…

Q: Identify the statement from the following when the inductance can have low value. a. If the number…

A: The formula for inductance is given by, L=μN2Al where N is the number of turns, A is the area…

Q: (A + V2 B Let V2(t) = 0 volt, inductor value be 8 Henry, and current through the inductor i(0) = 2…

Q: 4- Can value of the string efficiency being equal to 100%. Explain your answer

A: As per guidelines, the first question will be answered. The expression for the string efficiency is…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 61 ohms R2 = 31…

Q: a. The potential difference across the terminals of a battery is 8.5 V when there is a current of…

A: Given that V1=8.5VI1=3000 mAV2=11VI2=2000 mA Although formula for EMF of battery is given by…

Q: the combination to the 30μF in series. Connect the

A: The capacitor store charge in its plates when we connect the capacitor across a DC voltage source,…

Q: Measurement of energy involves _________ a. resistance measurement and voltage drop b. current…

A: In this question, choose the correct option Measurement of energy involves?

Q: Q1. Why the inductive resistance WL' is much higher than the resistance R?And why the capacitive…

A: An inductor will have a low and Impedance at low frequency r and increasing impedance as the…

Q: '- A 4-A current charging a dielectric material will accumulate a charge of 24 C after 6 s. (a) True…

A: Given Data: I = 4 A t = 6 s

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 84 ohms %3D R2 = 13…

A: given r and l circuit

Q: 25. An inductance of 1 henry and a resistance of 2 ohms are connected in series with an e.m.f. of E…

Q: Q1: What factors change the time constant? Q2 : If you increase the EMF of the used power supply ,…

A: In this question we need answer the following questions.

Q: 17) (a) Find the equivalent capacitance between terminals a and b of the circuit shown below. Ceq =…

Q: A resistance of 2/(t + 20) Ω and inductance of 4 H are connected in series to a battery of unknown…

A: Apply KVL in the loop to get differential equation in terms of time t . Now differential equation is…

Q: A resistor R is connected in parallel with a 10-ohm inductive reactance. The combination is then…

Q: A string of 4 insulators has self-capacitance equal to 4 times the pin to earth capacitance.…

A: The ratio of self capacitance (c) to Pin earth capaitance (C1) is cc1=4 Suppose Xc=1 Ω XC1=4Ω…

Q: Figure 2 below shows a capacitor of capacitance C is connected in series with battery of emf, E, a…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: 5] In a circuit with a battery (V), a resistor (R) and a capacitor (C) connected in series…

A: Given, V=60 VR=50 MΩC=4 μF Here the response is step response.

Q: In the figure the ideal battery has emf 8 = 43 V, the resistances are R1 = 51 kQ and R2 = 44 kN, and…

A: (a) At time t=0 the capacitor is shorted as initially capacitor is uncharged. Thus the current…

Q: 1.) The terminal voltage of a voltage source is v = 6 sin 2t V. If the charge leaving the positive…

Q: A 150V moving iron volt meter intended for 50Hz has an inductance of 0.7H and a resistance of 3K…

A: The given instrument is a moving type iron voltmeter. The equivalent impedance of the given moving…

Q: R3 R1 R4 R2 For the circuit shown in Figure, find the charge in the capacitor in units of Micro…

A: Given ; R1 = 15ΩR2 =60ΩR3 = 35ΩR4=40ΩC =7μFε =6v We know that after a long time the capacitor…

Q: HEAT TRANSFER : INDUCTION COIL I want to know what temperature the stainless steel cylinder will…

A: Given I=31A, V=42v Cylinder material is stainless steel Stainless steel has resistivity at 20°C…

Q: Given that a single point-like charge of -40 μC is fixed at the origin, calculate the work required…

A: q1=-40μCq2=60μCr1=14cm=0.14mr2=25cm=0.25m

Q: 4. Suspension string has 3 units. Each unit can with stand a maximum voltage of 11kV. The…

A: Given: Maximum Peak Voltage, V=11kV Number of Insulator Discs, n=3 The capacitance of each joint and…

Q: Wire having length 1 cm, a cross section area 1cm.square and a sistivity 1(ohm. Meter) is connected…

A: To solve above problem, one should know about resistance calculation of a material. The resistance…

Q: R, R, Except from point A to point D, where should a student hook up a voltmeter to measure the…

Q: A string of 4 insulators has self-capacitance equal to 4 times the pin-to-earth capacitance.…

Q: An inductance of 2 henries and a resistance of 20 ohms are connected in series with an emf of E…

Q: a) Find the mathematical expression for current İ2(t)

A: Find the mathematical expression for current İ2(t) as per our guidelines we are supposed to…

Q: A load can be considered to be capacitive, resistive or inductive in nature. a) Discuss the…

Q: In a 33kV overhead line, there are three units in a string of insulators. If the capacitance between…

Q: Use your own words to define the following concepts: a) c) b) Equilibrium Density of states Fermi…

A: (a) EQUILIBRIUM: According to the equilibrium equation, there can be no net force.The object should…

Q: A. Now suppose the switches are both changed to position B, such that the capacitors and the…

A: Although Bulb 1 is turned OFF when voltage across 3 micro Farad is equivalent to the source voltage…

Q: Connect a battery to a solenoid A cylindrical solenoid 40 cm long with a radius of 2 mm has 300…

A: Given Data: l = length of solenoid = 40 cm = 0.40 m r = radius of solenoid = 2 mm = 0.002 m A = area…

Concept explainers

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.

Question

Answer this question.

Problem 4:
In this AC circuit, the resistor offers 3 kQ
of resistance, and the capacitor offers 4
kQ of reactance. Together, their series
opposition to alternating current results
in a current of 1 mA from the 5 volt
Xc = 4 k2
5 VAC
source:
R= 3 ka
How many ohms of opposition does the
I= 1 mA
series combination of resistor and
capacitor offer? What name do we give
to this quantity, and how do we
symbolize it, being that it is composed of
both resistance (R) and reactance (X)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
3. A resistor and a capacitor are connected in parallel across a 120 V DC source. Determine the voltages across the resistor and the capacitor.
A capacitor C is connected in parallel with a resistor R across a 120 V, 200 Hz supply. The supply current is 2 A at a power factor of 0.6 leading. Determine the values of C and R.
An inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series across a 36 V and 60 Hz voltage source. Find the total current a. 150 mA b. 0.164 A c. 0.2 A d. 170 mA
An alternating current flowing through a circuit has a maximum value of 70A, andlags the applied voltage by 600. The maximum value of the voltage is 100V, and bothcurrent and voltage waveforms are sinusoidal. What is the value of the current whenthe voltage is at its positive peak?
An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a resistance of 50 ohms, and the inductor has an inductance of 0.2 H. What is the impedence through the circuit?
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
What is the equivalent resistance ?? and what is the total inductance ??