Given a parallel RLC circuit comprised of the following element: 80.63-ohm resistor, ideal inductor with reactance of 65.66 ohms; and a capacitor with reactance of 16.81 ohms. Compute for reactive power in VArs given an ac voltage source of 100 cis 0 volts. Give only the absolute value

Given a parallel RLC circuit comprised of the following element: 80.63-ohm resistor, ideal inductor with reactance of 65.66 ohms; and a capacitor with reactance of 16.81 ohms. Compute for reactive power in VArs given an ac voltage source of 100 cis 0 volts. Give only the absolute value

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Ihe averoge Power to the Plant, Shoun in Fig is 2479 KW and Power factor 15 0.707 logging The…

Q: 1. A series RLC circuit illustrated below is supplied by a 120 Volts, 60 Hz source. The values for…

Q: 80 Ω Coil + V1 V. V. +

Q: A 12 volt battery is connected to a series circuit in which the inductor is 12 henry and the…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

Q: Write an expression for the output voltage for the circuit as shown if υ1 = 0.5 sin 2000πt, and υ2…

A: Expression for output voltage equation of analog multiplier

Q: The question concearns RLC circuit, i have 2 sets of data, I need to calculate Z (impedance), R…

Q: A series RLC circuit having values of ? = 250Ω, ? = 3??, and ? = 4?? is shunted across a sinusoidal…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The capacitor of external defibrillator must be loaded at 1500V, in order to generate a two-phase…

A: CAPACITOR: Any two conducting surfaces separated by an insulating material is called a capacitor od…

Q: of Rin Vin- di t) =0 dt Care fully examine the opump RLC electrical circuit given in the figure…

Q: Power factor 90 to 100% 88 to <90% 85 to <88% 80 to <85% 75 to < 80% 70 to < 75% 65 to < 70% 60 to…

A: In this question we need to find the smallest KVAR required to reduce the surcharge to 0%

Q: An electromotive force of 100 volts is applied to an RC series circuit, in which the resistance is…

Q: A circuit supplied by 8V, 50HZ, is shown in Figure C5 below, is used to find the unknown value of…

Q: An ac generator provides emf to a resistive load in a remote factory over a two-cable transmission…

A: (a) Note- There is silly mistake in the (a) part of the Question, Question should be what is the…

Q: For the Circuit shown bebow, determine the value of the complex impe dance seen by the for : Spurce…

Q: A parallel connection of a resistor, inductor and capacitor is presented in the figure below. The…

Q: 14. In the AC circuit shown, the potential difference across the capacitor and the resistor, V3D, is…

A: The solution is given below

Q: Implement the given circuit as shown using Falstad Simulation. R Find the RMS Voltage across the 15…

Q: Q.1 The expressions for the steady-state voltage and current at the terminals of the circuit seen in…

A: Need to impedance and time.for current is out of phase with voltage

Q: In the circuit as shown, assume all parameters except C are given. Find (a) the current in the…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The voltage across the circuit breaker is given by vV; = Vm (1-cos →), prove tha the maximum…

A: Given expression for voltage across circuit breaker (restriking voltage) , differentiate the…

Q: An RL circuit has a resistance of 10 ohms, an inductance of 1.5 henries, an applied emf of 9 volts,…

A: In this question, Resistance R= 10 ohm, and inductance L= 1.5H applied emf = 9V. Find the current…

Q: FN.Q3-In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R = 470 , C = 220µF and L = 65 mH. Determine…

A: The Series RLC circuit Voltage across the circuit is given. Find the current Power factor Active…

Q: A source delivers an AC voltage of the form AV = 198 sin( 51 nt), where AV is in volts and t is in…

A: Here, we have given some information about the voltage delivered by the voltage source. The maximum…

Q: A sinusoidal voltage with maximum value (336 V), and a Frequeney its value (50 Hz), was applied on a…

A: As per the guidelines given to us, we can only provide the solution of first three subpart in multi…

Q: R-C Series Circuit. In an AC series circuit containing capacitance C and resistance R. Which of the…

A: Use basic electric circuit laws and phase diagram technique. According to kvl sum of the voltages in…

Q: A possible solution for a first and second order derivatives have the same form expressed as a. At?…

Q: , reactive and apparent power consumed by the lo

A: The given load is an RL load that means the power factor of the load is lagging in nature means the…

Q: 10 2 13.263 mH 73.683 µF Figure #6 Figure #6 shows an impedance consisting of resistance, inductance…

A: (a) Write the expression for the voltage when the frequency is in third harmonics and then find the…

Q: Given that the steady-state AC circuit shown operates at a frequency of 400 rad/sec, find the…

A: To solve above problem, one should have a basic idea about the working of AC circuits. The above…

Q: (c) In an electric power system, it is given that the effective impedance of the generator station…

A: It is Given that:RS=200Ω Rl=300ΩL=250 KmVS=45 kV f=60Hz Pmax=VS2Zth

Q: Find the stFeady stete Sountio mpresponngg a,b 2 = Vs (t) %3D where Vs = lo0Cos2t + 25 Sin 2t + 2ou…

A: The equation are given as…

Q: Q1) a). A 1.5 H coil has R of 70 2. The coil is energised by e = 149 sin 314 t. obtain the…

Q: When the average real power absorbed by an impedance is zero, then the impedance is: Select one: a.…

Q: A deflection bridge shown in figure below is used to measure an unknown capacitance,Cu. The…

Q: a) What is the time domain expression for the current? b) If the load impendance is created by an…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

A: From given values find the phase angle of coil voltage . Then find the impedance if coil then…

Q: The question concearns RLC circuit, i have 2 sets of data, I need to calculate Z (impedance), R…

Q: A 90-ohm resistor, a 32 mH inductor, and a 5 uF capacitor are connected in series across the…

Q: Z6 ( RL parallel ) 132 50 0,5 0,66 184 86

A: Resistance can be calculated as, Impedance can be calculated as,

Q: 80 Ω Coil + R E L ww all

Q: A series RC circuit is driven by a voltage source step function. The voltage values across the…

A: The voltage values across the capacitor of a series RC circuit as function of time is given in the…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

A: The solution is given below.

Q: Q.9: For the circuit shown, if (it=5+3sin@t+1.5sin2@t) Amp. Write the: J22 1. Non-sinusoidal current…

A: 1. Current equation in capacitance is by current division rule- ic =j26-j8×iT…

Q: An industrial coil is modeled as a series combination of an inductance L and resistance R. Since an…

A: Use vector law of addition for the voltages.

Q: A circuit is designed with an AC source of max voltage 12 and frequency 60 Hz. The circuit has a…

Q: The resistance and inductance of a coil can be obtained by connecting the coil in series with a…

Q: 2) The amplitude of the emf in the below circuit is 150V, while the angular frequency is 60x. The…

Question

Given a parallel RLC circuit comprised of the following element: 80.63-ohm resistor, ideal inductor with reactance of 65.66 ohms; and a capacitor with reactance of 16.81 ohms. Compute for reactive power in VArs given an ac voltage source of 100 cis 0 volts. Give only the absolute value.

Note: Follow this reminder carefully. No Scientific notation. Do not round off in the middle of calculation. Use stored values.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
a) We assume that the switch is on. Calculate the reactance values and find the charging current in the circuit below. Is the circuit capacitive or inductive? Show that the voltage across the capacitance can be slightly larger than the source voltage U. (This is called the Ferranti effect and means that we can get a voltage rise beyond overhead lines with small loads. This is mostly relevant at the highest voltage levels. The frequency f is 50Hz, and assume voltage U= √2⋅24kV
low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
91)Give Short Ansaers:- a) Determine the dimensions of and Inductance. 2) Differentiiate classi Fication used c) Difine resoluticn one Capacitance between different for Absolute standards Electrical measurinents accuracys and elror example each,
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.
1. What impedance vector 0 – j22 represents:A. A pure resistance.B. A pure inductance.C. A pure capacitance.D. An inductance combined with a resistance.
What impedance vector - j25 represents:A. A pure resistance. C. A pure capacitance.B. A pure inductance. D. An inductance combined with a resistance.
please solve value of Capacitor with 0.1V Ripple. And draw output ripple waveform. Explain it one by one for me thanks..
Determine the voltage across capacitor #3 (C3)? Select one: a. 7.2 volts b. 6.36 volts c. 5.65 volts d. 4.8 volts