Given: 10ft high retaining wall backfilled with sand (c'=0, o'=32 degrees, y = 122pcf) a level ground surface and the wall moves enough to mobilize active pressures Find: The active pressure distribution on the back of the wall, the resultant force per unit width acting on the wall, the location of the force application, and the angle of the assumed failure plane V

Given: 10ft high retaining wall backfilled with sand (c'=0, o'=32 degrees, y = 122pcf) a level ground surface and the wall moves enough to mobilize active pressures Find: The active pressure distribution on the back of the wall, the resultant force per unit width acting on the wall, the location of the force application, and the angle of the assumed failure plane V

Principles of Foundation Engineering (MindTap Course List)

8th Edition

ISBN:9781305081550

Author:Braja M. Das

Publisher:Braja M. Das

Chapter12: Lateral Earth Pressure

Section: Chapter Questions

Problem 12.6P

See similar textbooks

Similar questions

At-rest: A 17-ft-high basement wall retains a backfill with y = 95 pcf, o' = 33°, c' 0 and OCR = 1.8. (a) Calculate the magnitude of the lateral thrust acting per unit length of wall: (b) Estimate the location of the lateral thrust measured from the bottom of the wall; and (c) Calculate the equivalent fluid pressure for this problem (Ans. 60 pcf). (Problem 13.2, Das and Sobhan, 2014).
A wall form 8 ft high is filled with 150 lb per cu ft concrete at a tempera- ture of 60°F. The concrete is Type I with a retarder. Concrete will be placed with normal internal vibration to a depth of less than 4 ft. The concrete rate of placement will be 10 ft per hr. 12 ft 5.3 ft P=793 lb per sq ft Top of wall
A frictionless retaining wall is shown. Consider 1m length of wall. a. Determine the total horizontal passive pressure on the backfill at the bottom of the wall. b. Determine the passive resistance on the backfill. c. Determine the location of the resultant passive force from the bottom of the wall. Please answer this asap. For upvote. Thank you in advance
"For the same problem in question 17, calculate the total active force (Pa) acting on the wall." 1 Ar Pw 4.6 m Clay 7 sat = 17kN/m³, c=23kPa, = 0 Answers: 93.7 kN 114.0 KN 140.2 kN 132.6 KN 2.8m
a. For the vertical wall shown (no GWT, no interface friction), determine and plot the Ko, active, and passive lateral stress distributions acting on the wall b.Suppose the groundwater table in Problem 1 rises to a depth of 4m below the surface (on both sides or the wall) and assume the wall Is under active loading conditions. Assume that soil above the groundwater table Is dry, and that Y sat = 20 kN/m° • Determine and plot the water pressure and at-rest lateral earth pressure acting on the wall. Show the pressure distributions separately (not combined into one distribution). wall.
Determine the active force per unit length of the wall y = 16 kN/m3 ' = 30 c' = 0 3 m Groundwater table Yat = 18 kN/m3 = 35° d = 0 3 'm
For the retaining wall and floor profile shown in the figure: a. Create the pressure distribution diagram. b. Determine if a redesign is needed by calculating the rollover safety factor . ( minimum required G.S. = 2 ) c. Determine if a redesign is needed by determining the factor of safety against slipping (minimum required G.S. = 1.5) Note: * Do not take into account the passive resistance of the infill in front of the wall in your investigations for solutions b and c. ** Take the k₁ and k₂ values as 2/3. qu=25 kN/m² 0.5m Ybeton 24 kN/m³ C1=0 kN/m² Ø₁-30° YI=18 kN/m³ 3m C₂=10 kN/m² Ø2=32⁰ Y=19 kN/m³ 7m C3=8 kN/m², Ø=30°, y₁=18.5 kN/m² 1m 1m 1m
GEOTECHNICAL ENGINEERING 2 - '21 QUIZ 5 A 6m retaining wall supports a soil with the following properties as shown below. A surcharge of 20 kPa is imposed on the ground surface. Water table is located between the interface of the 2 types of the soil. If soil above water table is dry, find: A. Total Active pressure acting on the wall per meter of its width. B. Location of the Resultant pressure from the base of the RW. C. Overturning moment caused by the active pressure acting on the wall. STRATUM Depth Gs e 1 2 m 2.50 0.65 28° 1.8 kPa 2 4 m 2.85 0.48 32° 2.4 kPa
3- A 15-ft-high retaining wall with a vertical back face retains a homogeneous saturated soft clay. The saturated unit weight of the clay is 133 lb/ft. Laboratory tests showed that the undrained shear strength, c,u, of the clay is 108 lb/ft? and ø' is 28 degrees. 1) Make the necessary calculation and draw the variation of Rankine's active pressure on the wall with depth. 2) Find the depth up to which tensile crack can occur. 3) Determine the total active force per unit length of the wall after the tensile crack occurs. Also, find the location of the resultant.
A thin 20-cm" 20-am flat plate is pulled at 1 m/s horizontally through a 3.6-mm-thick oil layer sandwiched between two plates, one stationary and the other moving at a corstant velocity of 0.3 m's, as shown. Fixed wall h, =1 mm V = 1 m/s F h2 = 2.6 mm = 0.3 m/s Moving wall The dyramic viscosity of oil is 0.027 Pa.s. Assuming the velocity in each oil layerto vary linearly (a) plot the velocity profile and find the location where the oil velocity is zero (H) determine the force that needs to be applied on the plate to maintain this motion.
Ignore the passive resistance in front of the wall and also the weight of soil on the face of the wall. (a) Check for stability of the wall with respect to sliding. (b) Check for overturning stability. (c) Does the eccentricity at the base exceed B/6? (d) What is the soil pressure beneath the toe and the heel? Sketch the pressure distribution. (e) Repeat (a) by taking into account the passive resistance in the face of the wall. (f) Comment on your results. Please solve with steps. Thanks
A retaining wall with a smooth vertical back retains a purely cohesive fill. Height of wall is 12 m. Unit weight of fill is 20 kN/m3, cohesion is 1.5 N/cm?. Assume tension cracks are developed. Mark the correct statement(s) about earth pressure. A Active thrust acting on wall is 1102.50 kN/m. Correct Option B Depth of active thrust acting on wall is 6 m. C Active thrust acting on wall is 112.39 tonne/m. Correct Option Depth of active thrust acting on wall is 3.5 m from base. Correct Option