Gear B, shown in Figure Q4, supplies 15 kW of power, while gears A , C and D withdraw 6 kW, 4 kW and 5 kW, respectively. If the shaft is made of steel with the allowable shear stress of ?????? = 75 MPa, and the relative angle of twist between any two gears cannot exceed 0.05 rad, determine the required minimum diameter ? of the shaft to the nearest millimeter. The shaft is rotating at 600 rpm.

Gear B, shown in Figure Q4, supplies 15 kW of power, while gears A , C and D withdraw 6 kW, 4 kW and 5 kW, respectively. If the shaft is made of steel with the allowable shear stress of ?????? = 75 MPa, and the relative angle of twist between any two gears cannot exceed 0.05 rad, determine the required minimum diameter ? of the shaft to the nearest millimeter. The shaft is rotating at 600 rpm.

Precision Machining Technology (MindTap Course List)

2nd Edition

ISBN:9781285444543

Author:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Publisher:Peter J. Hoffman, Eric S. Hopewell, Brian Janes

Chapter3: Job Planning, Benchwork, And Layout

Section3.1: Understanding Drawings

Problem 1RQ: Information such as tolerances and scale can be found in the________ of an engineering drawing.

See similar textbooks

Similar questions

Q6. The thin plate with four holes as shown in Figure Q6 has a mass per unit area of 33 kg/m². The radius r for each hole is 50 mm. The thin plate has the dimension of 400 mm x 400 mm and suspended at pin at A. (a) Calculate the mass moment of inertia of the thin plate with four holes about an axis passing through its mass centre G, Ig.
Determine the x, y, z components of reaction at the thrust bearing D 0 = 0°.
100 mm В A 30 mm
300 mm 300 mm Figure Q2
620 mm 125 350 mm
28 cm a? 100 cm 30° 15 cm
In this case, the applied force is always pulls upward, but the amount of force that can be applied can vary between 0-350 N (maximum). The locations of the applied force and resistance cannot be changed. Which of these statement is true? Select one: O The system could lift any resistance less than, but could not lift a resistance = 250 N. The system could lift any resistance that was 350 N. O The system could raise, but would be unable to lower a resistance.
Q1 (a) During construction of a highway bridge, the main girders as shown in Figure Q1(a) are cantilevered outward from one pier toward the next. Each girder has a cantilever length of 45 m and an I-shaped cross section with dimensions shown in the Figure Q1(a). The load on each girder (during construction) is assumed to be 9.1 kN/m, which includes the weight of the girder. (Notice that there are four girders used in the construction of the bridge). Determine the maximum bending stress in a girder due to this load.
I'm not sure how the values for the last two rows were found.
300 N 36 mm 12 mm 120 mm В 30 mm A C D 6 mm 96 mm 42 mm| 30 mm 300 N
B P. 200 mm 240 mm 60 30 KN Figure (1.15)
Ixo and Iyo of a quarter circle with a diameter of 50cm (Answer format: Ixo= , Iyo=)