For the network shown, find Y when V₂ 1 2 + Y Vo Synthesize Y as an L-C admittance. ww + s(s² + 3) 253 +5² +65 + 1 Vo Y PROB. 11.10 V2

Q: Design a transformer coupled class A amplifier with high efficiency to supply an output power of P,=…

A: Transformer coupled class A AmplifierIt is a type of electronic amplifier that uses a transformer to…

Q: The average dc voltage of a half wave rectifier circuit is _______ of the value of the peak input…

A: Rectifier converts the input AC signal to DC signal.

Q: If the inductor of the circuit in Figure 2.18 has an initial current of Io, determine the expression…

A: Given dataThe initial current passing through the inductor is.The waveforms for the current flowing…

Q: E₁ IFE Y www REE lo eeee 4. 1₂

A: Given Circuit:Line voltage Equivalent Impedance To determine:Currents

Q: For the following circuit, find the time response of the voltage at C, when excited with a unit…

A: In this questionWe need to determine the voltage across the capacitor C. We are solving this problem…

Q: a) It is desired to draw maximum power by connecting a resistor between a an b. What should be the…

A: In this questionWe need to determine the resistance across the a and b to maximum power delivered to…

Q: Q3- Find 2(+) 1 ΚΩ 150 cos (1000 t) v( i(t) + 1Η 1 ΚΩ Μ 1 ΚΩ Μ Ix 1 ΚΩ 1 με

A:

Q: in part a are you able to explain or show the steps where the j's cancel out from…

A: It is given that:

Q: Q1 (a) A sinusoid is given as v(t) = 20 Cos (50t +50°) V. Find the: (i) Amplitude. (ii) Phase angle.…

A: Function is given as,

Q: In a workshop, there is a three-phase asynchronous motor with a power of 6 HP, an efficiency of 85%,…

A: Given dataOutput power, Efficiency, Initial power factor, Final power factor, To find outWe have to…

Q: (a) In the context of semiconductors, (i) (ii) (iii) name the process that creates an extrinsic…

A: As per the our company guidelines we are supposed to answer first three subpart, kindly repost other…

Q: 1. Determine the inverse z-transform for each of the following: 1 (1+z-¹)(1-2z-¹)(1–3z−¹) (a) X(z) =…

A: it is asked to find the inverse Z transform of part C

Q: Equivalent circuit parameters of a delta connected induction motor; Its equivalent impedance is…

A: Given Circuit:Line voltage Equivalent Impedance To determine:Currents

Q: 5) Implement the following function using pass transistor logic: F = ABC + AB'C' + A'BD' + A'B'D You…

A:

Q: Consider the following signal f(t) = 5 cos(5πt) + 6 sin(257t). (a) What is the highest angular…

A:

Q: Design two single-stub (short circuit) shunt tuning networks to match a load impedance ZL-60-j80 2…

A: Solution:Load Impedance =60-j80 (ohm)Load matched =2GHzFind :Here Design Single Stub (short Circuit…

Q: Determine the insulation resistance of a single-core cable of length 3 km and having conductor…

A:

Q: Find the Thevenin resistance seen at terminals a-b. 20 Ω V Σ10Ω 3 Α 0.5 V

A: it is asked to find the thevenin resistance seen at terminals

Q: 3. a) For a unity negative feedback system with forward transfer function G(s) given below, use…

A:

Q: n the circuit of Figure 1, ≡) Determine the power consumed by the 1 kΩ resistor. b) Determine the…

A: In this Circuit we need to calculate a)power consumed by 1 kohm resistorb)power supplied by the…

Q: o circuit below, use mesh analysis method to determine the current flows through the capacitor Xc.…

A:

Q: -pot the series RC circuit in Fig. 14.7: a) Find the transfer function between the source voltage…

A: A RC low pass filter is given we need to calculate -a) Transfer function T(s)=Vo(s)/Vi(s)b) The cut…

Q: od of the signal x (t) = COS (t) + sin (53 6

A:

Q: Q4) Which one could be a valid and acceptable root-locus? (b) (c) (d)

A:

Q: + Out - SA ww 2A O 612 $ 202 a PO b

A:

Q: Mention and draw the enhancement loaded NMOS inverter types with explain operation one of them?

A: generally MOS transistor consists of 3 terminals namely1 gate denoted as G2 source denoted as S3…

Q: Find the charge and current in a series LRC circuit when L = 1h, R= 2002, C = 0.001 f,and E(t) = 200…

A:

Q: A parallel plate capacitor with a surface area of 1 cm² is found to store 1x 10¹4 electrons when the…

A: In parallel plate capacitor,Surface area, .Number of electrons, .Electric field, .

Q: Q3. Determine the z-parameters of two-port circuit shown below. V₁ ΤΟ I 5Ω ww ww 10 Ω 20 Ω 41₁ V₂

A:

Q: find lappace inverse,

A:

Q: circuit is in balance for values R2 = R3 and R1 = 1/(20wC1) a) calculate Cx loss factor b) which…

A: In the AC bridge circuit, the impedance balance condition implies that the voltages at the two…

Q: Question 4: Determine the Currents 11 and 12 for the Network in Fig 4-4 Constructed of Standard…

A:

Q: Consider the circuit shown below a 10 ΚΩ 5 V b e 4 ΚΩ 40 ΚΩ 10 ΚΩ 12v C f 6 ΚΩ + d 4 ΚΩ 5 ΚΩ 10 ΚΩ…

A: In this questionWe need to determine the voltage at the node e and d as shown the circuit. We are…

Q: FET amplifier

A:

Q: A magnetic circuit has a length Lcore=20 cm, cross section area A=0.003 m², Lgap=1mm. and relativity…

A: length of Lcore=20 cm cross section area A=0.003 m² Lgap=1mm relativity permeability 12000number of…

Q: 2P=4 pole 230V-60Hz three phase round rotor synchronous motor is connected in star. The synchronous…

A: Solution:Given Data:=>Supply voltage =…

Q: Question 2: Evaluate the Discrete Time Fourier series representation for the following signal бл…

A:

Q: 3. Using branch current method, determine the unknown currents 1₁, 12 and 13 in the circuit given in…

A: Circuit diagram is given as,

Q: outline the operation of UJT in power electronics

A: Step-1->A unijunction transistor (UJT) is a three-terminal semiconductor device. It is a negative…

Q: A transfer function is given by 100 H(f)= 1+ j(f/1000) Sketch the asymptotic magnitude and phase…

A: For the given transfer function the bode magnitude and phase plot need to be drawn and the half…

Q: Sv + Find Vx + U X- 22 + sr and ix + ил M Yv

A: In this questionWe need to determine the voltage Vx and current ix  as shown the circuit. We are…

Q: 25 V + 15 Ω 10 Ω 10 F #l} ν 10 Η mor 20 Η ell www 10 Ω

A: it is asked to find i, v in given circuit under steady state conditions

Q: A repulsion start, induction run motor is used to drive a fan. The motor has a rated power of 2kW…

A:

Q: A two bus system is shown in Fig. 8.8 If 100 MW is transmitted from plant 1 to the load, a loss of…

A: Given data,System incremental cost, To find outWe have to determine the ,  and power received by the…

Q: The drift current in transistor is influenced by O Breakdown voltage limit of VCC O Forward biasing…

A: In the active mode of operation: The electrons gets drifted from emitter to base because of the…

Q: Q3.1 Use qualitative analysis to show that the circuit in Figure 3 is a band-reject filter. Q3.2…

A:

Q: "What is the magnitude of the capacitive reactance XC at a frequency of 2 MHz, if C is 2 nF?" O 0…

A: Frequency, f=Hz                 C=F

Q: 12 v 8002 www 1000 A 500, Q/ In the following circuit, find the current, voltage, and capacity, all…

A: it is asked to find the current, voltage and power capacity in all resistors

Q: Can you give me which is the correct answer from below. 83.32 pF 31.0 pF 44.22 pF 85.49 pF

A: To determine the transition capacitance (Ct) of a diffused junction varicap diode at a reverse…

Q: Design the oscillator circuit as shown in fig(3) for frequency of IkHz, given FET parameters g-Sms,…

A: Given:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.