Find the resistance and reactance of an inductive load if it draws 4 A and 600 W from a 240 v ac source. Select the correct response: R = 46.8 ohms, X = 37.5 ohms R = 37.5 ohms, X = 46.8 ohms R = 53.7ohms, X = 46.8 ohms OR = 37.5 ohms, X = 64.8 ohms < Previous

Q: 1 4.3 A resistor, denoted as R₁, is added in series with the inductor in the circuit in Fig.…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: Determine the approximate value of lp of Figure 522. VDD 17V 1.8kQ V, = 9.8V O 3.67 MA 4 mA 7 mA…

A: In this question,  We need to choose the correct options What is drain current?

Q: 2. For the given two stage amplifier circuit, hfe's = ß's = 150 and VBE = 0.7 V. Determine Avs VCC…

A: Two stage amplifier: Two stage amplifier has two transistor that are connected as common emitter and…

Q: Por cose c m' a Example/ Within a region of free space, charge density is given as py= where p, and…

A: The uniform charge distribution in a enclosed space system can be represented by applying the gauss…

Q: Q10) Find inverse Fourier transform of Xx (w) = √2nd' (w).

A: Brief description:  For the given fourier transform function we need to calculate its inverse…

Q: An alternating current is represented as i(t) = 20 sin (100 t+). The frequency of the current is :

A:

Q: Q5) Impulse response of a causal LTI systems is given as in the following. Find impulse responce of…

A:

Q: Explain what the voltage reg

A: Given  We need to explain the down voltage regulation of a power transformer. Please find the below…

Q: 6r sin (wt) D1 A 10 ΚΩ 10 ΚΩ 20 ΚΩ B D2

A: To analyze the circuit with multiple diodes Observe the diode ON/ OFF condition in positive half…

Q: Find the Vx in the network below:   Round off the final answer to four decimal places, polar form,…

A: The voltage across the resistor can be calculated by using the mesh analysis in the circuit

Q: Determine (show your work) the gross and net demand loads of power distribution for a large building…

A: Given data for a large building complex with the following design data: Lighting 4000 kW connected,…

Q: What is the ripple factor of a sinusoidal signal having peak ripple of 2 V on an average of 50 V?

A:

Q: Find the overall T-parameters of the following network.

A: Given circuit is a type of series connection of two port network. We can add Z parameters of each…

Q: Qy A Transistor dissipates 50w in ambient temperature of fo, The thermal visistance are 8jc=0 · 5…

A: Pavg= Average rate of heat generated of a transistorTJ= Junction TemperatureTC= Case…

Q: 7.57 The switch in the circuit in Fig. P7.57 has been in position a for a long time. At t = 0, the…

A: given here electrical transient analysis related topic question. given here a electrical transient…

Q: Why dc motors change its direction of rotation as the sign of input voltage to it gets changed?

A: The solution is provided in the following section.

Q: Flip-flops Give the disadvantages and advantages of Positive Edge Triggering vs Negative Edge…

A: According to the question, Flip-flops Give the disadvantages and advantages of Positive Edge…

Q: Design Wien-bridge and ose to get sin wave F = 3000 HZ 1 signal

A: The wein bridge oscillator is a low frequency oscillator which generates sinusoidal waveform based…

Q: j40 02 2592 j30 Ω j10 Ω ale j20 Ω 8 Ω -j6Ω

A:

Q: What will be the sign convention of the voltage if the current passes through the negative terminal…

A:

Q: Q13) Using Fourier transforms show that Jim sinc (w T1) 6 (w)

A: The Fourier transform of rectangular signal is                   where, τ is duration of rectangular…

Q: Q1. Construct the Mealy and Moore state diagrams for a sequence detector that outputs a 1 when the…

A: A Binary sequence detector is a circuit implemented using combinational and sequential circuit…

Q: A series R-L-C circuit is fed by a 230 V, 60 Hz ac supply. The circuit elements are R = 2 ohms, L =…

A: To find the value of C in a series RLC circuit such that total power power drawn from the supply is…

Q: 1. Find Ix in the circuit of figure shown below using Kirchhoff's law and Maxwell Analysis. 10 Q2 1…

A: To find ix in the given circuit using kirchoff's law and Maxwell analysis

Q: 12.5 nF 60 Ω 100 Ω 75 μΗ + τα

A:

Q: An inductive impedance Z₁ is connected in series with a 5 ohm resistance. When 50 V at 60 Hz is…

A:

Q: What types of PWM is shown in the figure? * Modulating Waveform Carrier waveform M₁ (b) O Unipolar O…

A: In case of unipolar pulse width modulation taken two sinusoidal modulating signal in outof phase…

Q: Q6:A) A transistor dissipates 50W in an ambient temperature of 60°C.The thermal resistance are…

A: The circuit diagram of transistor heating and cooling is  where,             Pavg =average rate of…

Q: Acontrol system is shown in figure belows. Find K and Ke so that the damping ratio 2.0.6 and damped…

A: Given data : Damping ratio ξ=0.6 Damped natural frequency ωd=10rad/s

Q: A three-phase transmission line has resistance and inductive reactance of 25V and 90V, respectively.…

A: Given:Sending end voltage, VS=145 kVReceiving end voltage, VR=132KVLine resistance, RL=25ΩLine…

Q: 3. A hybrid model amplifier is shown below. The parameters are h₁1 = 45ohms, h21 = 80, h₂2 = 12.5 us…

A: We need to find out the load resistance of given circuit .

Q: The instantaneous current of AC source is 1, = 250 sin(300t). The value of rms current (m) is inst…

A: Option - B  is the correct answer.

Q: For R1=191, R2=190, R3=112, 11=6 A and V1=9 V in the shown circuit, find the Norton equivalent with…

A: The circuit diagram is shown below, Where,R1=191 ΩR2=190 ΩR3=112 ΩI1=6 AV1=9 V

Q: For R1=7, R2=5, R3=7, 12=3 A, 11=3 A & V1=12 V in the shown circuit, Find the Norton equivalents at…

A:

Q: The load in each phase of a delta connected network is equal to 73247 Ohms. The network is connected…

A: In this question,  We need to determine the line currents?  Using the ohms law I= V/Z

Q: U1 1F ΤΟ 1 F •1 Ω 1 F 201 1 Ω Q+ U2

A:

Q: Find the following parameters if B-120 for this transistor C. VCE d. VE RB 680kQ VCC 15V LRC 2.2kQ…

A: We need to find out the current and voltage for given circuit

Q: PWM is cross-s

A:

Q: 3. A hybrid model amplifier is shown below. The parameters are h₁1 = 45ohms, h21 = 80, h22 = 12.5 us…

A:

Q: Design using NAND gate to have such a truth table. Inputs Outputs C Y₂ Y₁ Y₁

A: Given truth table of inputs A,B,C. To design the respected outputs with  NAND gates only.

Q: 1 A circuit element draws 10A when connected to a 240V line. The time (in sec) required to consume…

A: Given: Current drawn by circuit element, I=10 A Supply, VS=240 V Energy consumed, E=12 kJ

Q: A three-phase motor can be regarded as a balanced Y-load. A three-phase motor draws 5.6 kW when the…

A: Given data, 3 phase power P = 5.6 KW = 5600 W Line voltage VL=220 V Line current IL=18.2 A

Q: 1. A resistor in a circuit has a value of 550 2. It is desired to decrease its value to 330 n. The…

A: Dear students as per our Guidelines we are supposed to answers only first three parts of a multi…

Q: The net magnetic flux density of the stator of 2 pole synchronous generator is Bnet = 0.3x +0.193 y…

A: Solution is as shown below

Q: (a) Provide a block diagram and a function table for the D-type flip-flop with falling edge…

A: Since you have posted multiple questions, we will solve the first question for you. If you require…

Q: 04: One branch A of a parallel circuit consists of a 50-uF capacitor. The other branch B consists of…

A: Given:C=50μFXC=1j×2π×f×C=1j×2π×50×50×10-6=-j63.66ΩL=0.2HXL=j×2π×f×L=j×2π×50×0.2=j62.83Ω

Q: The instantaneous current of AC source is 1, inst Select one: Oa: 250 A b. 176.6 A OC. 300 A Od. 150…

A: Given, Instantaneous current, Iinst=250 sin300t A Peak current, Ipk=Im=250 A

Q: -10 (S-1) (a) The continuous plant G(s) = s+5 is controlled by adjusting a gain K. Here, the plant…

A: The block diagram of the control system is shown below,   Where,Gs=-10s-1s+5and Sampling period,…

Q: Find the magnitude of the impedance of a series RLC circuit if the inductive reactance, capacitive…

A:

Q: 7. Draw the output waveform for a sinusoidal input Vin(pp) - 30V (Assuming D1 is Silicon diode & D2…

A: We need to find out the output voltage for given circuit

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.