Example 04:- A capacitance comparison bridge (similar angle bridge) is used to measure a capacitive impedance at a frequency of 2 kHz. The bridge constants at balance are C2 = 100 mF, R1 = 10 k2, R3 = 50 ks2, R2 = 100 ks. Find the equivalent series circuit of the unknown impedance.

Example 04:- A capacitance comparison bridge (similar angle bridge) is used to measure a capacitive impedance at a frequency of 2 kHz. The bridge constants at balance are C2 = 100 mF, R1 = 10 k2, R3 = 50 ks2, R2 = 100 ks. Find the equivalent series circuit of the unknown impedance.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: and Q7: A compound generator is supplying a load of 100A at 220V, Ra=0.012, Rsh-4002 and Rs 0.04 2.…

Q: D10.7. Standing wave measurements on an air-filled lossless 75-2 line show maxima of 18 V and minima…

Q: Calculate the voltage gain (A = V/V) for the circuit below. Show the details of your work. Write…

Q: A group of a small appliances on a 60Hz system requires 20kVA at 0.85 pf lagging when operated at…

Q: Solve the transfer function T (s) =Y (s) / U (s) if b1= b2 = b3 = 1/s and a1=a2 = a3 = 10 20 pts लि

A: transfer funtion is calculated as by masos gain formula

Q: A coil and capacitor are connected in series. The inductive reactance is 250 W, and the capacitive…

A: Brief description: Note : In the above given question inductive and capacitive reactances must be in…

Q: 7. Explain how the starting torque of an induction motor depends on resistance and reactance of the…

A: The objective is to determine the dependency of the torque on the impedance of circuit.

Q: Q/B For the circuit below, RE=2K ohm, RC=3K ohm, VEE=4 Volt, Vcc=20Volt. Assume the transistor to be…

Q: Q21. What is the drive output frequency when switch S1 only is closed and the analog inputs are…

A: According to the question, for the given wiring schematic as shown below We need to find the…

Q: Inductive sensors should not be used to detect _______ objects. A. odd-shaped B. fast-moving C.…

Q: Solve the following problem using Kirchhoff's Rule. Show the equivalent circuit when solving for the…

Q: 1 = 42,4/0° A US -j3 n UP

Q: Enlist the power quality issues for renewable energy integration

A: Renewable energy is also called green energy because it is generated from Energy resources which are…

Q: For the system described by the following transfer function (A) Find the state space equations. (B)…

Q: What is the velocity of an electromagnetic wave in free space?

Q: Q2: In the figure shown find the power of this circuit if R1=3 ΚΩ, R3=3 ΚΩ , R5=5 ΚΩ , R7=0.5 ΚΩ ,…

A: The total power can be obtained by using the equivalent resistance of the circuit.

Q: How does the value of stator current density influences on the efficiency of the induction Motor (

A: In this question we will write effect of stator current density on efficiency of induction motor...

Q: Q1. Choose the correct answer (Answer any TEN): in frequency domain. 1. The convolution of two…

A: As per the guidelines of bartleyby I need to answer first thre questions only so kindly repost other…

Q: The power input to a 500V, 50Hz, 6 pole, 30 squirrel cage induction motor running at 975 RPM is…

Q: What the need of testing insulators in the laboratory? Why insulators most likely to fail at lower…

A: Insulators are the substances that don't conduct electricity at all.

Q: what is the main deference between photo diode &photo transistor?

A: Photodiode Phototransistor Definition: It's a PN-junction diode that generates an electric current…

Q: QUESTION 3 circuit provided in figure 3. Write out all equations and units in full. H 252 42 sin 81…

Q: In the given Full Wave Center tapped Rectifier circuit, a step down transformer gives an RMS voltage…

A: As per Bartleby policy we can answer only three subparts. So I am solving first three for you.…

Q: What is the frequency of oscillation for the triangular wave oscillator shown below? Show the…

A: Given:

Q: Q1: Answer the following sentences with (True) or (False) then correct the false sentences: 2- The…

A: We need to tell about whether the given statement is true or false.

Q: F/P Semiconductor X Semiconductor Y Based on the band diagram shown above, what is X, Y and Z?…

Q: - Q/B For the circuit below, RE=2K ohm, RC=3K ohm, VEE=4 Volt, Vcc=20Volt. Assume the transistor to…

Q: For a 3-phase, 4-wire system having balanced supply and unbalanced load, the following sequence…

Q: D13.9. A TE mode in a parallel-plate guide is observed to have three maxima in its electric field…

A: We need to tell about the mode number m .

Q: The equivalent impedance per phase of a star-connected load are as follows: Za= 100 Ohms, Zb=j5…

A: Total power: The quantity of power in a circuit at any particular time is known as instantaneous…

Q: Q1) Using the mesh analysis, find the power dissipated by 4k2 and 6k2 resistors for the network in…

A: We need to find out the power for given circuit

Q: 1: Answer the following sentences with (True) or (False) then correct the false sentences: 1- When…

A: We need to tell about whether the given statement are true or false

Q: A 25 kva 220-volt three phase alternator delivers rated kva at 0.84 power factor. The effective ac…

Q: Aside for the mutual induction, can we apply the principle of electromagnetic induction in a…

A: Given transformer operation principle whether electromagnetic induction or not.

Q: For the following two problems, write a system of linear equations that determines the loop…

A: Note : According to the guidelines of the company if questions are of different then we supposed to…

Q: can we apply the principle of electromagnetic induction in a Transformers operation? (short answer)

A: Electromagnetic induction : According to electromagnetic induction whenever there is a change in…

Q: www 40 30.0

Q: 3. An ON-OFF temperature controller controls a room air conditioner. The bandwidth (OH) is set to 4,…

Q: B)- Indicate whether the following statements are true or false and correct the false statements 529…

A: In this question we will write answers related to dc generator, transformers and motors... Note :-…

Q: 9) Provide one general method to control the speed of an induction motor.

A: The rotor speed (Nr) of an induction motor is given by,??=(1−?)??And the synchronous speed is…

Q: Calculate the input voltage* (in millivolts) if the final output is 24.19 V. Vi= _mV *note…

Q: The following are examples of an FM detector except for ___. a rectifier detector b PLL…

A: FM detector is instantaneous convert the frequency change the carrier signal to output counterpart…

Q: Transform these sinusoids to phasor: (a) (b) i(t) = 6 cos (50t -40°) v(t) = 4sin (30t + 50°)

Q: Using Kirchhoff's voltage law, solve for V1. RI= 2.2 + 5 V Ra =3023 V₂

A: Given circuit:

Q: Q1/ Consider a uniform cha 17cm, 75

A: a R=12 cmRadius> 12 cmqinside=0∴ E=kqr2=0E=0

Q: 3. R Use Mason's Gain formulat 6 G3 H₁ 6₂ 64 65 N . ܝ

Q: The dimensions of a coaxial transmission line are a = 4 mm, b= 17.5 mm, and c = 20 mm. The…

A: It is given that: a=4 mm=4×10-3 mb=17.5 mm=17.5×10-3 mc=20 mm=20×10-3 mσc=2×107…

Q: Q1. Correct the following statements without changing the underline words: (do not use NOT) 1- The…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when it…

Q: Answer the following questions: i. What is the function of the antenna? 2. What are the differences…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: 1. A PT100 RTD has a positive temperature coefficient (a) of 0.00392 02/°C. It is being used to…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Question

Example 04:- A capacitance comparison bridge (similar angle
bridge) is used to measure a capacitive impedance at a frequency
of 2 kHz. The bridge constants at balance are C2 = 100 mF, R1 =
10 k2, R3 = 50 ks2, R2 = 100 ks. Find the equivalent series circuit
of the unknown impedance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
4. A capacitor now is connected in parallel with R1 to reduce the ripple. Find the value of the capacitance needed to make the following ripple index less than 5% through PSpice simulation study. V -×100% -V o,min 0,max rpp RFP = -x100% = V dc dc D1 Dbreak R1 V1 1k VAMPL = 169.71 FREQ = 50 Vo
the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a phase to ground c. none of the answers O d. Between phases
Calibri (Body) -11 by AaBbCcDx AaBbCcD AaBbC AaBbCc AaB AaBbCc. mat Painter BIU 1Normal 1No Spaci. Heading 1 Heading 2 Title Subtitle Chang Styles d Font Paragraph Styles IMPEDANCE QUIZ # 2 1. What capacitance when connected in series with a 500Q resistor will limit the current drawn from a 48-mV 465-kHz source to 20µA? * a. 144pF b. 145pF c. 146pF d. 147pF MY ANSWER: c.146pF 2. What is the total impedance at 20kHz of a series circuit consisting of a 1.5mH inductance, a 100Q resistance, and a 0.08uF capacitance? * a. 1340 41.7 b. 1930 L-37.2" C. 920 290 d. 530 2-12.6°
The figure below shows a capacitor network. The values of the components are as follows: • C₁ = 2.71 μFarads C₂ = 4.29 μFarads • C3=6.84 μFarads C4-9.05 μFarads . . CA . V 14.66 Volts V C3
A resistor with a resistance of 50 2 is connected in parallel with an inductor with an inductance of 0.175 henry. The power source is 60 Hz. What is the impedance of the cir- cuit? Letod ed
I need answer with explaination In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
This waveform, is the current in Half- bridge With Purely capacitor Load .circuit lo 0. T/2 lo True O False O
for the R-th part. isn't R3 and R5 in series not parrallel? If not, explain why. If so, fix the solution. THank you.
Per figure find ZT
a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.
Question 4 A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must be no less than 50% of the average. The output voltage ripple must be less than 1%. The switching frequency is 30kHz. Determine the duty ratio, minimum inductor value, and minimum capacitor value. Verify your answers using Matlab, show the inductor current is continues and its minimum is no less than 50% of its average. Furthermore, the output voltage ripple is less than 1%.