www 40 30.0

Q: what is the main difference between of thermometer &thrmisor?

A: Thermometer is used to the measure the temperature of human body mostly it is used in a clinic. it…

Q: 1. Given an ade of 0.998, determine Ic if IE = 4 mA. 2. Determine ade if IE = 2.8 mA and IB = 20 µA.…

A: In this question we will solve BJT related problems.... Note :- as per our guidelines, I am supposed…

Q: Q5-(A)- Explain briefly the following questions What are the reasons for connecting transformers in…

A: The transformer is an electrical device which is used to convert the voltage magnitude in a…

Q: "If Vc is equal to 2754193 and Vab is 476.3142103, the phase sequence is:" O POSITIVE NEGATIVE

A: In this question,  We need to choose the correct options If VC and Vab  are given then what is phase…

Q: Let x(t) = 5 cos (50t+ sin 5t). Its instantaneous frequency (in rad/sec) at t=0 has the value? (a) 5…

A: Given signal equation, xt=5 cos50t+sin 5t

Q: The maximum deviation allowed in a frequency modulation system is 100 kHz; the modulating signal…

A: Given a frequency modulation system with, Maximum deviation, δ=100 kHz Modulating signal frequency,…

Q: Q3-(A)- Indicate whether the following statements are true or false and correct the false statements…

A: DC series motor: When a DC motor has the field winding is in series with the armature through the…

Q: "If Ibc is equal to 659.9112271 and la is 381 angle;1, the phase sequence is:" O POSITIVE O NEGATIVE

A: Phase sequence :The order in which each phase attain a positive peak is called phase sequence.…

Q: Q1:In the figure shown find the current in each resistor. 252 15 V 10 V м 452 м m 652 ли 852

A:

Q: Use Norton to solve for the current and voltage at 10 ohm resistor. 1 20 Ω 2 10 Ω Σ 3 120 V 30 Ω 40…

A:

Q: A generating station has four bus-bar sections. Each section is connected to tie-bar though 20%…

A: Busbars is used carry high amount of current. In every home electrical panel has busbars to…

Q: For the circuit in Figure, solve the nodes and order the matrix as follows: B] [1 C c. What is the…

A: The required parameters can be calculated by using the kirchhoff's current law to the nodes.

Q: Q4: Cylidrical conductor of radius 2 cm currying a uniform current of 170 Amp. What is a magnitude…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1) Find the voltage at node A in the given circuit by applying nodal analysis.

A: The node voltage can be calculated by using the nodal analysis. The node equation can be obtained by…

Q: (c) Wind at one standard atmospheric pressure and has a speed of 12 m/s. A 12 meter diameter wind…

A: (b) Explain the following terms: (i) Solar incident angle, slope, and total global radiation on a…

Q: A. Find f(t) if F (S) = 3S+1 - (S-1)(s²+1) B. solve the following equation using Laplace…

A:

Q: Find the Inverse Laplace Transform of the following functions S³+35²-s-3 1. F(s) = = (s²+25+5)²

A:

Q: QUESTION 1 In the figure V=47 volts, and R=117 ohms. Determine the current (in unit of mA) in the…

A: Given, The circuit is, And V=47 voltsR=117 Ω

Q: Q2: Design a basic RC band stop filter with a lower cut-off frequency of 200Hz and a higher cut- off…

A: We need to find out value of resistance and capacitance for given filter

Q: Homework1: In the circuit shown in Fig. below, find io, Vo, and i for all time, assumingthat the…

A:

Q: Given the vector field in cylindrical coordinate system: A=2psinócospa, + (rcos²o-rsin²o)a, + pcos²…

A:

Q: Q4: An op-amp multivibrator circuit is constructed using the following components. Ri Rr=35k2, R =…

A: In this question we will find frequency of oscillation of opamp multivibrator......

Q: For the unity feedback system shown below ,answer the following questions: R(s) + E(s) C(s) G(s)…

A:

Q: The torque curve presented here is most representative of: Engine Power and Torque Curves 280 Power…

A: The Electric motors are categorized into two types on the basis of their supply potential : DC…

Q: Find the charge on the capacitor in an LRC-series circuit when L = q(t) = C h, R = 102, C = 0.01 f,…

A:

Q: Q4- A d.c. series motor runs at 500 r. p.m. on 220V supply drawing a current of 50A .The total…

A:

Q: 1. For the network of Fig. 5.158: a. Determine re. b. Find Zi and Zo. c. Calculate A v. d. Repeat…

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you…

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A:

Q: For each of the following transfer functions, write, by inspection, the general form of the step…

A: Transfer function is the ratio of Laplace transform of output to the Laplace transform of input.…

Q: A: When v (1) = 100 volts, L: -0.8 henry, L₂= 1 henry, R₁ =1.402, and R: = 102. The system of…

A: The Runge–Kutta technique is a popular and successful approach for solving differential equations'…

Q: solve for the collector saturation current of an emitter stabilized bias circuit with Vcc=18V,…

A: We need to find out saturation current

Q: Q3-A)- A 220 V d.c. Shunt motor has a shunt field resistance of 11002 and an armature resistance of…

A:

Q: What is the Peak Inverse Voltage (PIV) of a Bridge-type rectifier if Vp = 12V? Group of answer…

A: We need to select correct option for PIV inversion voltage .

Q: Example 33.19. Two single-phase furnaces working at 100 V are connected to 3300-V, 3-phase mains…

A: The scott connection is the most common method of connecting two single-phasetransformers to perform…

Q: (f) Let g(x) be another periodic function as shown below. Plot the frequency spectrum of the…

A:

Q: Find the average power absorbed by the resistor R R-900

A:

Q: The generator is connected to two electrodes are placed in the ground 1000m from each other. The AC…

A: Grounding gives extra strength to the only and most secure path from a piece of equipment lower back…

Q: Q: Design a basic RC band stop filter with a lower cut-off frequency of 200Hz and a higher cut- off…

A: Bandwidth: This is the range of frequency in which different frequencies signal lies. Outside the…

Q: Q2/A Shunt motor having a field resistance of 50 02 and an armature resistance of 0.5 is connected…

A: In this question we need to determine the speed of the motor when the load is changed such that it…

Q: Write the appropriate term for the following questions A clipper or limiter circuit consists of a…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: AJFET data sheet specifies Vas(off) = -6 V and loss = 8 mA. The value of lp when VGs = -3 V is Blank…

A:

Q: Directions: DRAW and label the parts of an Electric Motor. In your own words and idea, write a short…

A: Electric motor: It is an electromechanical device that takes electrical input and produce the…

Q: Draw the signal flow graph of the n electrical network. Is A IR R elle Ic C

A: As per company guidelines, I am allow to solve only one question of multi-part question.  Signal…

Q: Q1. Choose the correct answer (Answer any TEN): 1. The convolution of two signals in time domain is…

A: In this question we will write about convolution and pulse modulation... Note :- as per our…

Q: V₁ = 30v SIW 514 miel 510 ми V₂ = 10V 1014 f w 1010 M Find Vo 3101 Į

A: given here op-amp based circuit and asked to find the output voltage V0 .

Q: Solve the following problem using Kirchhoff's Rule. Show the equivalent circuit when solving for the…

A:

Q: Find the Inverse Laplace Transform of the following functions F(s) = = S3+3s²-s-3 (s²+2s+5)²

A: given F(s) and asked to find the inverse laplace transform of F(s). we know that Le-atu(t)=1s-aLcos…

Q: Find the Voltages and Currents for all the devices on the circuit below.

A: The voltage across the elements and current through the elements can be calculated by using the…

Q: If an FM wave is represented by the equation e=10sin (9×10³t+4sin 1500r), then what is the carrier…

A: Given FM signal equation, e=10 sin 9×108t+4 sin 1500t

Q: Reduce the block diagram of the control system below to a single block, and then find ? R R G H₂ H₁

A: Given: The block diagram,

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.