ELEV. 130m 2 B L = 1000m D = 200mm f = 0.023 L = 1500m D = 250mm L = 300m ELEV. = 40m f = 0.02 D = 300mm Q = 0.14 m3/s C f = 0.018 ELEV. = 10m D A P 1 Determine the power (in horsepower) delivered by the pump to the system shown above a) Power Blank 1 HP Blank 1 Add your answer :

ELEV. 130m 2 B L = 1000m D = 200mm f = 0.023 L = 1500m D = 250mm L = 300m ELEV. = 40m f = 0.02 D = 300mm Q = 0.14 m3/s C f = 0.018 ELEV. = 10m D A P 1 Determine the power (in horsepower) delivered by the pump to the system shown above a) Power Blank 1 HP Blank 1 Add your answer :

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 40m 120 1.2L/ Water ervoirs A and B are connected to each other through a 40-m-long, 2-cm swing…

Q: EXAMPLE 10.5. A pump delivers 2.5 cfs of 70°F water from a reservoir at elevation 50-ft to a…

Q: J A pump that creating pressure difference between the intake and discharge point. a. Dynamic pump…

A: As per our guidelines we are supposed to answer only one question. Answer :- b. Pressure Pump

Q: Q2)For the system shown in the figure, the water flow rate is (40)L/s. Find the 30m power…

A: To find :- Power transferred from the flow by the turbine.

Q: FRESHMEN What is the value of F required to balance the weight of the cylinder if the weight of the…

Q: A 70-mm-diameter suction pipe leading to a pump, as shown below, carries a discharge of 0.05 of oil…

Q: The 50 cm diameter pipe shown below transfers water from reservoir A to a pressure turbine and…

A: Given Data Determine the power (in HP) from the turbine (P).

Q: Two geometrically similar pumps are running at 1200 rpm speed (both). If one pump has impeller…

Q: Calculate the pressure in the pipe (Point A). The area of the reservoir is 100 times the area of the…

Q: Situation # 4: The pump shown draws water from the reservoir A at elevation 10m and lifts it to…

Q: The Power (P) required to drive the pump depends upon the diameter (D), the angular velocity (0),…

Q: The tractor mounted bucket is controlled by an identical and parallel double mechanism, one of which…

A: To find the forces in the members BC and DE of the system.

Q: Q2)For the system shown in the figure, the water flow rate is (40)L/s. Find the 30m power…

A: Given Discharge, Q = 40 l/s = 0.04 m3/sec Kinematic viscosity = 1 x 10-6 m2/s Total head = 30 m To…

Q: In Fig. all pipes are 8-cm-diameter cast iron. Determine the flow rate from reservoir (1) if valve C…

A: D = 8 cm or 0.08 m Kv = 0.5

Q: C) In a cylinder-piston arrangement shown (D₁ = 100 mm), the piston is moving downwards at Vp = 0.5…

A: step 1-

Q: Calculate the pressure in the pipe (Point A). The area of the reservoir is 100 times the area of the…

A: Manometer is used to measure pressure at any point which is exerted by a gas or liquid under the…

Q: 7- a) b) c) d) For the transmission line shown below, what is the power of the pump with efficiency…

A: Efficiency, η=70% Flow rate, Q=200 lit./s The density of water, ρ=9806 N/m3 The slope of the…

Q: Current Attempt in Progress A U-tube manometer is connected to a closed tank as shown in the figure…

Q: For the sprinkler shown, find a. the torque required to hold it steady, and b. the rotation rate in…

A: Given that :-radius of the sprinkler (r) = 0.152 mDiameter of the nozzle () = 0.00635 mFlow rate (Q)…

Q: sp. he pump in the system is 78% efficient and is rated 185 kW. Determine the energy added by he…

Q: In the system shown in the figure, the pump moves 220 It/s of water through a system of horizontal…

A: given data,pump moves 220 It/shead of pressure at the pump inlet is -1.2 meters and at the outletof…

Q: Water flows from a lake through a 300-m-long pipe having a diameter of 300 mm and a friction factor…

Q: Q2: For the system shown below, find the minimum flow rate of the jet from the orifice at the end of…

Q: Water flows through a 90° bend in a horizontal plane as depicted in the figure.

Q: mpt in progress A U-tube manometer is connected to a closed tank as shown in the figure below. The…

Q: H-W1 Q1/ Neglecting losses, determine the discharge in Fig. below Oi so 075 Q2/When the pump in Fig.…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: Fig. 2. Assume constar factors, with f = 0.018. The head-discharge relation for the pump is Hp =…

Q: In the figure the water (P = 1000 kg/m3) enters the pump to be raised at (1), with a pressure P1 =…

Q: If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and…

A: The expression for velocity in pipe is given as V=QA Substitute the value in above expression V=0.15…

Q: The pump is powered by a 30 kW motor. If the pump is 82% efficient, determine the pressure rise…

A: V1 = 40 m/s d1 = 4 cm =0.04 m d2 = 8 cm = 0.08 m effective power P = 0.82 x 30000= 24600 W

Q: A pump is rated with 80% efficiency and requires 4hp of power. The power output results to a…

A: Efficiency of the pump = QHρ367 P2 ρ=1000 kg/m3 P2= 2.9828 KW Velocity = 5ft/s=1.524 m/s Average dia…

Q: Cross sectional area: 4 meter by 4 meter, three consecutive flocculation tanks. a) Determine the…

A: A. 4m/nB.1. v2= 50m/s v3= 30m/s2. n1= 0.3183/s n2= 7.9577/s n3= 3.1831/s3. P=0.0002WC.…

Q: A pump drawing water from a reservoir and discharging it into the atmosphere at point B. The…

Q: The 24-in. pipe conducts water from reservoir A to a pressure turbine, which discharges through…

A: step 1-

Q: Situation 1 The 60 cm pipe conducts water from reservoir A to a pressure turbine which discharges…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An empty water tank has a diameter, D=6ft, and height, H=10ft, an inlet valve with a diameter, din…

A: The water tank has a diameter D= 6ft height, H=10ft,inlet valve with a diameter d(in)=6”outlet valve…

Q: shows a pump employed for lifting water from a sump. If its required to pump 60 liters/sec of water…

Q: ELEV. = 130m L = 1000m D = 200mm f= 0.023 2 L= 1500m D = 250mm f = 0.02 Q = 0.14 m3/s L= 300m ELEV.…

Q: Two identical pumps connected in series using a pipe 3.5 cm diameter with water flowing at velocity…

A: Given data: G1=0.1 bar=0.1×105 N/m2G2=0.6 bar=0.6×105 N/m2V (velocity of flow) = 2.5 m/sD = 3.5 cm

Q: a) V1= b) Q1- c) Q2- d) Q2- The end of the pipe with a diameter of 150 mm shown in the figure is…

Q: 3. Water is being pumped at 2.5ft3/s. The head loss between points 1 and 2 is 9ft and the power…

A: Given data: Flow of water pumped by the pump: Q=2.5 ft3/s Head loss between point 1 and 2 = hL=9 ft.…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

ELEV. 130m
2
B
L = 1000m
D = 200mm
f = 0.023
L = 1500m
D = 250mm
ELEV. = 40m
f = 0.02
Q = 0.14 m3/s
C
ELEV. = 10m
D
A
P 1
Determine the power (in horsepower) delivered by the pump to the system shown above
a) Power = Blank 1 HP
Blank 1 Add your answer
L = 300m
D = 300mm
f = 0.018

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 10-cm fire hose with a 3-cm nozzle discharges 1.5 m3/min to the atmosphere. Assuming frictionless flow, find the force FB exterted by the flange bolts to hold the nozzle on the hose. O 2728 N O5861 N Water: 1000 kg/m³ O 3566 N O 4067 N D₁ = 10 cm Pa = 0 (gage) Hint: One-dimensional momentum flux: F = ploutvout - Plin Vin (2) D₂ = 3 cm CV
During a flow of 450 L/s, a pressure of 65 kPa was measured at point C in 320 mm diameter horizontal the supply line of water turbine and a -47 kPa pressure T. was measured at point D, 2 m below point C at the 460 diameter exit pipe. mm Compute the total head extracted by a. the turbine. b. Compute the power supplied to the turbine in horsepower.
The turbine shown below develops 120 hp (66000 ft Ib/s) when the flow rate of water is 15 ft /s. If all losses are negligible, determine the pressure difference across the turbine (i.e., P4-P3). Answer should be in units of Ib/ft?. (Specific weight of water = 62.4 lb/ft3) P4 12 in.. 12 in. T Free jet
The pump in the figure B. draws water from a reservoir and discharges through 2 V2 inches hose, which terminates in a nozzle having a jet diameter of inch. The head losses are: I to 2. 5.75 ft: 2 to 3. negligible: 3 to 4. 30.61 ft. 4 to 5. 11.6 ft. Compute the required horsepower output of the pump and make a table of the heads at the five points. Q is (a) 261 gpm. (b) 361 gpm.
Ql:-A cylinder of 1lft diameter and 2ft length floats in a tank that contains a liquid of specific weight .A u-tube manometer is connected as shown in figure. What is the weight of the cylinder whose upper the surface is flush with fluid surface PA--0.1 psi Water 2 ft Cylirder Gage fluid SG- 1.5 Sp wt.y 0.5 ft 02. w1
6) Turbulent water flows from a tank to a pipe. The head loss relationship in the pipe can be 25 (-)). What is the discharge of water? described as h₁=0.025 몰 Water T = 60°F Elevation 100 ft D = 1 ft ↓ ↑ L = 1000 ft Elevation 60 ft 6 in. diameter jet
Q3
subject: hydraulics engineering. if possible, please give a detailed answer for me to under
Fluid 5
Qu: Calculate the magnitude 4 direction af force exerted on the three-quar ter cylinder (ABCD), shown in figure below, which is (3m) long perpendieular to the figue. Also prove that this force passes through paint O. Water 2 m B 0.6
Water is pumped from reservoir A at elevation 250 m. The pump is close to reservoir A and is at the same elevation as reservoir A. It is pumping 90 liters per second of water through a 1,000 m of 150 mm diameter pipe to a reservoir whose elevation is 300 m. What is the horsepower delivered by the pump? Assume f=0.02 and neglect minor losses. Select one: O a. 150.50 Hp O b. 302.23 Hp O c. 267.72 Hp O d. 252.30 Hp
ELEV. = 130m B L = 1000m D = 200mm f = 0.023 L= 1500m L = 300m D = 250mm ELEV.= 40m D = 300mm f = 0.02 f = 0.018 Q = 0.14 m3/s ELEV. = 10m 3 A Determine the power (in horsepower) delivered by the pump to the water system shown above,