draw the timing diagram for 10 clock cycles! What is the name and modulo number of this counter

Q: When SW1 is open, RESET is 5 V MPU RESET O Activated O Inactivated Grounded O Turned on

A: here, the small bubble at the reset terminal indicates that it is a active low signal

Q: Current is being discussed. Technician A says that DC current is produced in a sine wave. Technician…

A: Ac current is alternating current which has both positive and negative values. Which means that AC…

Q: If a voltage spike lasts for 1.5 nanoseconds, what is the frequency of the spike?

A: Voltage spike is defined as sudden rise in voltage which is very higher than normal voltage for very…

Q: QUESTION 6 What do the individual symbols in the rung pictured represent? L1 Inputs 1/1 0-1/2 01/3…

A: PLC:- The PLC (Programmable Logic Controllers) is used to monitor the state of the input device and…

Q: b) A student sets up an electric circuit like the one shown in Figure Q1(b). i) Describe how a…

A: Given :   Practical current source the student in the laboratory has made the circuit.     The…

Q: answer ASAP

A:

Q: Question -07 A 0-10V PMMC meter reads 4V reading. Suddenly spring snaps at one place, then the meter…

A: When the spring snaps at one place , then the meter shows a reading of 0 V.

Q: A pressure measuring device indicates 13 psi which actually has the true value as 11 psi. The…

A:

Q: Choose the name of time taken by a meter, to reach 95% of the final value from 10% of final value.…

A:

Q: If the clock period is 25 ns, what is the clock period in MHz?

A: Given: Clock period, T=25 ns=25×10-9 s.

Q: Energy is released from fossil fuels when they are О а. Сooled O b. Burned O c. Pressurized O d.…

A: Energy is released from fossil fuels when they are Burned. They release heat energy when they are…

Q: Show all work. Please type so I card read. Calculate the voltage value of a sine wave at 135° whose…

A: Given: Phase angle, θ=135° RMS voltage, Vrms=1000 V

Q: If a processor has a Ton of 0.033ns with 50% duty cycle, what is its clock speed?

A:

Q: To run a motor in two directions, we have to use DPDT switch. Select one: O True O False

A: To change the direction of rotation of a DC motor we have to switch the terminal of the…

Q: How can the ammeter range be increased to 1A?

A: In this question we discuss how to increase ammeter range .

Q: Item #: For the circuit below, find the current I. j 62 ll HE -j22 j22 12 -j22 j42 24 Vac -j20…

A:

Q: Q1 :A. write the code and state the name for the following signals 15 Clock 1O1 0 • 111 0 0 10 Data

A: Line code is used for data transmission over a transmission line. There are different types of line…

Q: a 40% duty cycle clock signal is low for 10ns. What will the clock frequency be?

A: In this question We need to determine the clock frequency of the given signal.  We know Frequency f=…

Q: A system comprises a tank of liquid heated by a coil containing saturated steam. Its block diagram…

A:

Q: Find the value of the time constant z after the switch opens. The values of some of the circuit…

A: We have to find the time constant

Q: What is the difference between a TON and RTO timer? Onone O TON is on delay and RTO is off delay…

A: To do: We have to select from the given options for the difference between a TON and RTO timer.

Q: have a question on why did you use 3 in the equation when solving for the ripple voltage

A: Forward bias of a diode: When Anode voltage of a diode greater than the cathode voltage of a diode…

Q: Wb / m2 represents O a. watt O b. Henry O c. Joule O d. Tesla

A: Given, WB/m2 represents=?

Q: Kleno As the clock pulses continue what two values will you see displayed on the 7-segment unit?

A: The truth table for the JK-flipflop is given by:

Q: h of the following load is Inductive in nature tor hontor

A: Water heater is a resistive load and uses heat produced by resistors to heat water.

Q: It is a rotating electrical machine that converts electrical energy into mechanical energy.

A: Rotor: In electric generator, motor, or alternator, rotor is just a moving part of an…

Q: If you reverse the flow of electricity in a converter, it then becomes an?

A: From the INVERTER concepts

Q: QUESTION 6 What is this a diagram of? O NO pushbutton ONC temperature switch ONC level switch ONC…

A: Introduction: Various parts are required to configure an electrical circuit. To understand…

Q: methodology used to know how many people pass through the place where the tiles will be installed…

A: To describe:methodology used to know how many people pass through the place where the tiles will be…

Q: Clock cycles on the CPU are defined.

A: A clock cycle is an electronic pulse given to the processor in the CPU and specifically, it is the…

Q: full five digits value in the clock diagram. 3. For the following diagram- draw the state table…

A:

Q: Question 27 To turn on all the LEDS with the instruction "OUT AL, 7B", AL should be first set to 7B…

A: Given OUTAL 7B So AL will assign 7B value

Q: Estimate the range of resistance (in 2) needed to make a variable timer for typical intermittent…

A:

Q: The slight sideward motion of a shaft is called end play. The end play in theshaft of a rotor for an…

A: The end play of the rotor of an electric motor should be,  End play ≤132 inch The given motor has an…

Q: If you want to measure the current without breaking the circuit then which of the following meters…

A: To measure the electric current without direct contact in a circuit we use a clam meter.

Q: 13 In an ammeter, increasing the number of turns in the movement winding would yield None of the…

A: In an ammeter,

Q: Attempt Only if you are sure . a 24 V DC voltage source is controlled by a rotational potentiometer.…

A: Given data At θ=0°C, V0°C=24 V At θ=12°C, V12°C=10 V To find out We have to determine the voltage…

Q: Determine the value of R1 that will ensure proper turn-on and turn-off for the following values: eta…

A:

Q: If a voltage surge lasts for 20 microseconds, what is the frequency of the surge?

A: Voltage surge is defined as sudden rise in voltage which is able to damage the installed electrical…

Q: What is the difference between a TON and RTO timer?     none     TON is on delay and RTO is off…

A: What is the difference between a TON and RTO timer To select from the given options

Q: The temperature range for the flash steam power plant is---- O a. 350 F O b. 840C c. 840 F O d. 350…

A: flash steam power plants are capable of operating in certain range of frequencies only , based on…

Q: What is the final position of the Spot trace in the CRO Screen if DC voltage is applied to the y…

A: CRO- Cathode Ray Oscilloscope- CRO mainly consists of a cathode ray tube. The main component of…