Draw the Circuit with Multism

Q: In all electrical machines, the core is made of iron always in spite of its cost, weight, eddy curre...

A: In all electric machine, we basically want core to be made of such material that it has high permeab...

Q: 2. Solve for the transfer function

A:

Q: Single Phase AC Circuits 1. Wavelength is the distance traveled by an electronic wave during the tim...

A:

Q: 1. The 3 bits wide output of a 4-1 Multiplexer is connected to the select lines of a 3-8 Decoder as ...

A: As per our company guidelines we are supposed to answer only first question kindly repost other ques...

Q: Given a periodic signal in the picture below: determine: 1. the fundamental period of the signal T...

A: As per the guidelines of bartleyby I need to answer first three subparts only.So kindly repost other...

Q: 3. Show how a JK flip-flop can be constructed using a T flip-flop and other logic gates.

A:

Q: Determine the divergence of a given vector field: D= (2xyz – y?)a + (x²z – 2xy)ay + x*yaz at PA(2, 3...

A:

Q: Find the phase angle in the given alternating quantity: 90sin 400rt V O O degrees O 12 degrees O100 ...

A: Option - a ( answer )

Q: Determine Vo and ID for the network. * Va Si 10 mA 2.2 ΚΩ 2.2 kl O 8.13V, 5.32 mA O 10V, 2.2mA O 7.5...

A:

Q: 1. An AM signal consists of a 10-MHz carrier modulated by a 5-kHz sine wave. It has a maximum positi...

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you ar...

Q: Refer to the circuit shown below. The current-controlled-current source has an unknown constant k. S...

A:

Q: 24430 v. z, = 2 + 2 2, 2, = 4 - j3 2, j10 0, and z, 4. For the circuit below, E, z, = 6 + 38 2, 2, =...

A: The circuit is as shown below,

Q: 1. The PN junction diode D1 and D2 has the maximum power Pmax -14 mW. D1 Si Imar 160 V D2 4.7kQ 68ka...

A: Note: As per the policy we can solve only one question, please re-upload the remaining question as a...

Q: R 3302 www E 1ov等 R2= 2202 1.

A:

Q: Determine the range of Vi from the given figure. (MINIMUM VALUE) 2. Determine the range of Vi from...

A:

Q: How many cycles occur in 1 second for a 60Hz signal?

A: Frequency means the number of complete cycles occur in one second. 

Q: 2. Find the Norton's Equivalent circuit at terminals a and b. Solve for RTH = RN, In and VTH= VN res...

A:

Q: Three condensers, each having a capacity of 75 microfarads are connected in star to a 440 volts, 3-p...

A: To calculate capacitor value when connected in delta

Q: iv. When the half power point bandwidth is 10 MHz and the center frequency is 5MHZ, the quality fact...

A:

Q: C(s) for the signal flow graph shown below R(s) eulate the transfer function a2 az a4 C(s) C(s) а) R...

A:

Q: Simplify the circuit using appropriate resistor combinations and apply voltage division to determine...

A: Initially solve the circuit a bit some of the resistors are directly in parallel and series

Q: A circuit is constructed with six resistors and two batteries as shown. The battery voltages are V, ...

A: 2Apply Kirchoff's law,The current I3 that flows through R3 isI2=I1+I3 .....1I3R3-I1R1+V1=0From equat...

Q: An iron ring has a length of 60 cm and cross section of 4 cm^2. If the field strength is 1.5 T, find...

A:

Q: Answer number 14.write youe solution pls.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: Three resistances of 20 Q each are connected in star across the 400 V, 3-phase A.C. supply. Calculat...

A:

Q: 25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respec...

A:

Q: If the value of a capacitor is increased, then its impedance will a. Increase O b. None of the answe...

A:

Q: Consider the circuit shown: R1 100 Q V1 sine (A 60 Hz 120 Vrms R2 100 2 4:1 1:2 Calculate the magnit...

A: For easiness , 1st refer all the resistance to source side of the transformer.

Q: Using re model, compute for the AC characteristic of below circuit. a. Zi b. Zo c. Av d. Ai

A: The required parameters of collector DC feedback configuration of CE amplifier can be calculated by ...

Q: vii. The voltage of the power supplied from the synchronous generator is fixed: (a) Due to the AVR o...

A: To select correct answer

Q: Answer the question. 1. What is Alternating Current (AC)? Draw a simple graphical representation of ...

A: To give the answers

Q: Five resistors are connected as shown in the figure. What is the equivalent resistance of this combi...

A:

Q: Two resistors when connected in series have a total resistance of 10 ohms. If they are connected in ...

A: Please refer the attached images for the complete answer..

Q: * Question Completion Status: Determine the magnitude of the total current labeled lo for the circui...

A: The solution is given below 

Q: A magnetic circuit consists of silicon steel 2,500 permeability, of 10 cm length and a cross section...

A:

Q: A three-phase motor takes 10 kVA at 0.6 lagging from a source of 230 volts. It is in parallel with a...

A: Find active and reactive power of each load then add individual active reactive power to get total a...

Q: (b) Find the Q-point (VcF,Ic) if given Boc =150 for the BJT circuit shown in Figure Q3(b). Vcc +10V ...

A: In this question,  We need to determine the Q point of the BJT.  If dc current gain = 150 Assume for...

Q: Use mesh-current analysis to find the branch currents indicated in the network shown below

A: In this question, Use mesh-current analysis to find the branch currents indicated in the network sho...

Q: i. Some reasons for adopting high transmission line voltages are to improve -------and the enhanceme...

A: Given that three fill in the blanks related to high transmission line voltages .

Q: (t) 一} 0'

A:

Q: 22 n VIN 8 V Figure 8

A: The given circuit diagram is shown below:

Q: For what voltage will the reverse current in pn junction Germanium diode reach 90% of its saturation...

A:

Q: QUESTIONS: 1. What is the Transfer function? 2. What do the BODE diagram and poles-zeros graph tell ...

A: Solve the first question, unless the student has asked for a specific question to be solved, subject...

Q: Are the signals periodic or not? If it's periodic, what's the period? Show it by calculating.   a)...

A: The solution is given below

Q: SHOW YOUR SOLUTIONS. In a common base connection, IC = 1 mA and IB = 50µA. Convert the values first ...

A:

Q: 1. Use Kirchhoff Law to detemine the current flowing in the 12 resistance in circuit below. 4 V 50 3...

A: We are supposed to be answer of first question as per guidelines.

Q: 23. A supply of 240V, 50Hz is connected across a pure inductance and the resulting current is 1.2A. ...

A: The solution is given below  option A is correct 

Q: 7. Theoretical axial resolution is Q a/4. In practice, frequency dependance of ultrasonic attenuatio...

A: Axial resolution- It is an ability to observe two different structure and  determine the difference....

Q: What is the angular frequency of a waveform having a period of 1 millisecond?

A: There is no correct answer in the option . I have checked the solution . This question belongs to el...

Q: When a capacitor is connected to an AC supply, the current A. Leads the voltage by pi/2 rad B. Leads...

A: The solution is given below 

Current Division Method

The generalized current divider formula is given by the following relation below,