Determine internal shear, normal and moment at point c p = 12 kN

1- A line 10mm in length inclined at 75 degrees to the x- axis can be represented as, A. will write 0<75 B. will write 0<15 C. will write 10 <15 D. will write 10 <75 2- How will you create a line representing length 15 units at an angle of 30 degrees with respect to the positive direction of the X-axis and the first point of the line is not at the origin? А. 30<15 B. 15<30 С. @30<15 D. @15<30 3- A fillet command is used to produce, A. Sharp corners B. Round corners C. Both of the above D. None of the above 4- Which statement is true about the precedence of lines? A. a hidden line has precedence over a visible line B. a center line has precedence over a visible line C. a visible line has precedence over a center line D. all of the above

On the attached drawing 11A005< what is dimension "G"

100 mm В A 30 mm

Determine, using the principle of superposition, the reactions at supports A and B for equilibrium. The beam is fixed at A and supported by a roller at B. Take Wo = 900 N/m and consider El is constant. WO B 3 m Select one: Ax = 0, Ay = 120 N (upward), MA = 540 N.m (counter-clockwise) and By 90 N (upward).

Please answer all questions

How do you find the point of application?

mechanical design and drawing

Help

mmetri Each part has a constant thickness with values indicated. 2.0 mm 1.5 mm 3.0 mm 2.0 mm A shear force, S₂ is applied. This results in shear flow, shown with red arrows, which has the following values: • Shear flow in part 13, just before point 3 - 38 N/mm Shear flow in part 23, just before point 3 = 44 N/mm Shear flow in part 43, just before point 3- 44 N/mm What is the shear stress in part 35, just below point 3? Express your answer in MPa, to 2 decimal places but without the units included. You have a 3% margin of error.