D4 D1 + C1+ RL 22µ 1.2K Vs(N D3 Y D2 9V sin(2n 50 t) +

Q: A drawing office 10mX5m having illumination of 200 Im/m2 which is to be provided by a number of 50 W…

A: Solution is as follows.

Q: Current A ?

A: Given network:

Q: 4. Solve for the equivalent resistance Rt 30 20V 322 50

A: Given:  Brief description: In the above given question they have mentioned a circuit which is made…

Q: The value of Keq is not dependent on temperature. True False

A: For the given question identify the given statement true or false. The value of Keq is not…

Q: Q1 (ii) A light emitting diode (LED) with a forward voltage drop of 1.8 V, a resistor and a 6 V…

A:

Q: 5 Classification of 10 MWe capacity solar power plant

A: Solar power plants can be classified in many different ways, depending on the criteria used. Here…

Q: out when finished experiment. Mwatyr 0.972 kg ed: Kettle before : 322.647 kwh after : 322. 745 kwh…

A: The answer for the above problem is shown in below steps:

Q: Given the circuit below, The current through the 100 resistor in the circuit below is 8.0 mA.…

A:

Q: A completely discharged new battery with nominal ampere hour capacity of 100Ah needs to be fully…

A:

Q: Explain C-rate? Indicate the difference in 0.5 C and 0.375 C in terms of battery discharge…

A: C rate: The current discharge of a battery is expressed in terms of C rate. It is the rate at which…

Q: G2/ Convert 473,125 ,88 be Binary

A: To convert the given decimal numbers to binary numbers:

Q: CREATE A SCHEMATIC DIAGRAM  components: - 9v battery buzzer bc 547 resistor 1k ohm LED light…

A: Step 1  BC547 is a BJT transistor. It is used for a PWM, current amplifier and also used for fast…

Q: For the following circuit find VL, IL, Iz and IR if RL = 180 , repeat for R₁ = 470 R$ 20 V 220 2 Vz=…

A: Given: Circuit diagram,

Q: An electric current is a of charged particles called flowing through the wires and electronic . It…

A: The solution is achieved as follows.

Q: Which of the following is the basic step in calculating LOLE? a. Energy Demand b. Expected Energy…

A: To calculate of loss of load expectation following steps should be performed. 1. Determine the…

Q: Convert 3000 W into the equivalent Btu/hour. Show all the steps.

A: The relation between watts (W) and Btu/hour can be expressed as 1 W=3.4121 Btu/hour

Q: 120 * 8F what is the T?' b. what is the voitage capactor apter 10 sec? c. How many a. time constants…

A:

Q: An assembly consists of 1040 individual protons. What will be the total charge of the assembly?

A: Although charge of a Proton is 1.6×10-19 C (+1e).It is given that number of protons is 1040.

Q: Two resistors R1=50 Ohm and R2=50 Ohm (series connection) are connected in series with a battery 3V.…

A:

Q: Which of the following standard reference electrode is best described with the following statements?…

A: Find out standard reference electrode in the given electrode types based on given sentences ?

Q: Explain the results and why this happens? 0.00 Ω fghij abcde fghij abcde ΜΩ ~ M ᎧᎧᎧ ***RAR The…

A: Diode : Diode is a two terminal Device which allows current in only one direction and doesn't allow…

Q: The amplification factor and plate resistance in a triode are 50 and 2 kΩ respectively. With…

A:

Q: 10/30 10 +J27-60-(5x10)

A:

Q: A Standard cell of 1.0185 V with a simple potential meter balances at 50 cm. Calculate percentage…

A: Given data: The voltage of the cell, V=1.0185 V The current is I = 0.43 A The resistor R=2 Ω For…

Q: The true value of a current Is 25mA and It is indicated in a digital Ammeter as 28 mA. The absolute…

A: Given : True value, x= 25 mA Measured Value, x0=28 mA

Q: If the energy demand is 93.5 kWhr and battery storage capacity is 124.5 kWhr, then the depth of…

A: Energy demand =93.5 kWhr. Storage capacity =124.5 kWhr.

Q: 5- Describe abbreviate the function of each block shown below: Scope Mux Product

A: There are various blocks which can be used in matlab simulink for the simulation of particular…

Q: TOoK 1ook a) Whatt is and b) What is Ps ard P if the transfurmer is hack weards ?

A:

Q: 4S LiPo • 5100 mAh • charge rate 1-3C • discharge rate: 35C Complete the following questions as…

A: Since there are multiple questions uploaded so solving the relevant questions accordingly. Kindly…

Q: 4. Calculate the number of chips can be obtained from 8 inch wafer. Size of the chip is 5x5 mm. If…

A: Given data Diameter of wafer (D)= 8 inch =203 mm size of chip =5 x 5 mm Calculate the maximum…

Q: Delta to Way equivalent 200 mV 300 n 500 n3 600 nE 1.2 kn 400 n (c)

A: In three phase circuits, the resistances can be connected in two ways: star connection and delta…

Q: Ht OF answers the quesO 1. Which of the following common enggineering prefixes has the largest power…

A: 1) The values are given below, Pico = 10-12 Milli= 10-3 Kilo = 103 Giga = 109

Q: 30n |Oov (I 150 250

A: Determine total resistance and total current for the given circuit .

Q: A J- type thermocouple  is used to measure the temperature in a heating process. Sheath material…

A:

Q: In the circuit below the LED will turn on once the voltage goes below 5V: SV Select one: True O…

A: According to the question, for the circuit given belowFor the LED to be ON positive potential must…

Q: A 616 meter is having an accuracy of ± 0.16% of FSD. Calculate the %error for a measurement of 12,…

A: Error for 616 range is, Error=616*0.16100=0.9856 Full scale error valueAccuracy=0.9856100-0.16…

Q: The statutory limit for voltage variations at the consumer's terminals is . . % of rated value. +24…

A: The statutory limit reaches of voltage varieties is ± 6% of the appraised esteem at the purchaser's…

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.