Please provide Handwritten details Four identical solar batteries of 12V nominal volatage are connected in a 2 by 2configuration. The discharge rating of the batteries is given in the following tables:Discharge rating (C) at 25°CСaрacity (Ah)C3C5185C10220C20120165230a. State the total battery bank capacity at 5 hour discharge rate and 25 degree andthus calculate the expected state of charge of the battery (%) if it has beendischarge continuously for 2 hoursb. Determine the system voltage of the battery bank

Given Four batteries are connected in 2 by 2 fasion Rated voltage of each battery = 12 V

Four identical solar batteries of 12V nominal volatage are connected in a 2 by 2 configuration. The discharge rating of the batteries is given in the following tables: Discharge rating (C,) at 25°C Сарacity (Ah) Cs 185 C10 220 C20 230 120 165 a. State the total battery bank capacity at 5 hour discharge rate and 25 degree and thus calculate the expected state of charge of the battery (%) if it has been discharge continuously for 2 hours b. Determine the system voltage of the battery bank

Four identical solar batteries of 12V nominal volatage are connected in a 2 by 2 configuration. The discharge rating of the batteries is given in the following tables: Discharge rating (C,) at 25°C Сарacity (Ah) Cs 185 C10 220 C20 230 120 165 a. State the total battery bank capacity at 5 hour discharge rate and 25 degree and thus calculate the expected state of charge of the battery (%) if it has been discharge continuously for 2 hours b. Determine the system voltage of the battery bank

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter30: Dc Motors

Section: Chapter Questions

Problem 6RQ: What is CEMF?

See similar textbooks

Similar questions

Which change to the circuit will not extend the charging time of one time constant.a. Increasing the value of the capacitorb. Increasing the value of the resistorc. Increasing the voltage from 15 to 20 volts
In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases. True or false
Explain the difference between charging current and faradaic current
5) For a single phase full wave bridge rectifier with a resistive load if the input voltage is 225 V, 50 Hz with the value of resistance is 25 ohms. Compute the value of ms value of load voltage and average value of load voltage by formulating the equations with all steps
Question 13 Not yet answered Marked out of 1.00 P Flag question Which of the following ratings (PIV- Peak Inverse Voltage and temperature) is true? Si diodes have lower PIV and narrower temperature ranges than Ge diodes. Si diodes have lower PIV and wider temperature ranges than Ge diodes. Si diodes have higher PIV and wider temperature ranges than Ge diodes. Si diodes have higher PIV and narrower temperature ranges than Ge diodes.
a. If you do not go completely around the loop when applying Kirchhoff’s voltage law, then the algebraic sum of the voltages cannot be determined the algebraic sum of the voltages will always be positive the algebraic sum of the voltages will always be negative the algebraic sum is the voltage between the start and finish points b. A p -type semiconductor is a semiconductor doped with impurity atoms whose electron valence is +4 pentavalent impurity atoms trivalent impurity atoms
Calculate % ripple factor for the given details of a full wave bridge rectifier. frequency= 50 Hz Rms voltage = 220 V Capacitance= 100 microfarad Resistance= 1 kiloohm
e+ VBB = 12Y. 50k VE RBB- 5Kd 7= 0.6 ATEM F 50052 Ip= 1OUA. GND DETERMINE: A) RB1 B) RB2 C) Vp D) VR2, DURING THE CHARGING PHASE E) VR2, DURING THE DISCHARGING PHASE.
When resistors with higher wattage ratings are required, resistors are generally used to dissipate the excessive heat. a) Variable b) Fixed c) Wirewound d) Preset The diode is considered shorted when both anode and cathode has a) Low resistance b) High resistance c) Different resistance d) None of the above When two resistors are connected in parallel then their overall power rating is a) Increased b) Decreased c) Doubled d) Reduced
An alternating voltage, given by v = 100 sin 314t is connected to a full-wave rectifier. The average value will be _________. 31.8 volts 63.7 volts 70.7 volts 50 volts A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______. 3.46 amp 2.1213 amp 0.866 amp 4.2426 amp A sine wave has a maximum value of 20 volts; its value at 135° is _________. 15V 5V 10V 14.14V
Question 5 Assume the zener diodes are all ideal in the circuit below and let V1=3.7 V, R1=935 2, R2=1,04702, and R3=855. Determine the output voltage Vo. Express your answer in Volts and round to the 1st digit to the right of the decimal. R1 V1 D1 5V R2 D2 3V {R3 D3 2V Vo
An alternating current was measured by a DC milliammeter in conjunction with afull-wave rectifier. The reading on the milliammeter was 7.0 mA. Assuming thewaveform of the alternating current to be sinusoidal, calculate: (a) the r.m.s. valueand (b) the maximum value for the alternating current.