Answered: Consider the following figure that…

Consider the following figure that shows the current in an inductor of 5 H. Find the voltage across the inductor at t= 3.5 second.*

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 3. Assume the values given in the circuit diagram above. The switch is in position (a) for a long…

A: 3.The given circuit isThe switch is in position (a) for a long time before being thrown into…

Q: 2.) The total capacitance of two Capacitors in series is 3MF. The first has a capacitance GMF and…

Q: For the circuit at right: a. Immediately after the switch is closed, what is the current in the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The current through a 10-mH inductor is 10e-12 A. Find the voltage and the power at t = 2 s. The…

Q: (a) After the switch is first thrown to a (connecting the battery), what time interval elapses…

A: For the given RL circuit the value of time required to reach 220mA, Value of current at t-10s and…

Q: . A capacitor is rated at 1000uF of capacitance its minimum value is 850uF, what is its maxi…

Q: A 15 uF capacitor is charged to a potential of 110 V. The capacitor then discharged through a…

A: Given: Capacitance of capacitor, C=15 μF Capacitor charged to potential, Vc=110 V Resistors in…

Q: The variation of the current in a 20 mH inductor is the one shown find and graph the voltage across…

Q: In the figure ɛ = 10.0 V, R, = 4.00 N , and R2 = 1.00 : inductor is ideal. If the switch is closed…

A: According to question :

Q: 4. The capacitor in the figure below has capacitance C = 0.1F. The waveform of the current i flowing…

A: Given, Capacitance (C) = 0.1F We need to determine a) voltage across capacitor v(t) for t>0.…

Q: A sinusoidal current of amplitude 10 A and frequency of 10 kHz is applied and allowed to flow…

A: If i(t) A is the time varying current flowing through an inductor of inductance L H, then the…

Q: 4. As a general rule, for an inductor to be considered as a pure inductor, it should have a Q value…

A: According to the question we have to find Q value of pure inductor.

Q: A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V…

Q: Whenever current in an inductor changes: Select one: the coil inductance changes. induced voltage…

A: The objective of the question is to understand the behavior of an inductor when the current flowing…

Q: Exercise: A sinewave voltage with amplitude 2 V and frequency 500 Hz is applied across an ideal…

A: Drawing the circuit by using the given data from question:

Q: The current through a 10-mH inductor is 10e The voltage is mV. The power is mW. A. Find the voltage…

A: Given:Required:We need to find the voltage and the power at t=3.

Q: A 60μF capacitor in series with a voltmeter of 100000 resistance is connected across a 120-volt…

A: A 60uF capacitor in series with a voltmeter of 10000 ohms resistance is connected across a 120-volt…

Q: Draw the inductance and resistance voltages on an oscilloscope screen in accordance with their…

A: The formula for Ohm's law mentioned in the last line is incorrect. The actual formula is V=IR. The…

Q: A 0.185H inductor is connected in series with a 99 Ohm resistor and an ac source. The voltage…

A: The objective of the question is to derive an expression for the voltage across the resistor (vR) in…

Q: The capacitance specified in the circuit below is limited to 1-10nF. find the capacitance and RL…

A: XL=ωLXL=2π×10×103×30×10-3XL=1884.95 ΩXC=1ωCXC=12π×10×103×4×10-9XC=1052π×4XC=3978.87 Ω

Q: A capacitor is charged to a potential of 12.0V and is then connected to a voltmeter having an…

Q: Three capacitors each of the capacitance C are given. The resultant capacitance 2/3 C Can be…

Q: Suppose that we have two 100-μF capacitors. One is charged to an initial voltage of 50 V, and the…

A: Given data, The value of capacitor C1 = 100 μF. The value of capacitor C2 = 100 μF. The value of…

Q: 2. The current through a 0.1mH inductor (in the direction of the voltage drop) is depicted below.…

Q: How do you model an inductor under DC or steady-state conditions? Select all that apply. Short…

A: When modeling an inductor under DC or steady-state conditions, the following options apply:Open…

Q: 1. You are an electrician working in an industrial plant. You discover the problem with a certain…

A: Given that: In an industrial plant, a machine has a defective capacitor and its rating is 10 μF and…

Q: Describe an inductor and the how an inductor stores energy

A: Inductor is a passive bilateral element which has two terminals and it is wound in the form of coil.…

Q: A capacitor is connected to a 150-V supply. If the capacitor is being charged to 0.99 W-s. What is…

A: We need to find out the capacitance of capacitor

Q: capacitor (1 nanofarad) is charged to 50 V and then disconnected. One can model the charge leakage…

Q: The current in an initially uncharged 4-uF capacitor is shown below. Compute for the following at t…

A: The given waveform is shown below, Where,Capacitor =4 μF

Q: When the capacitor is charged current flows on either side of the capacitor. Do electrons cross the…

A: A capacitor is an electrical device which consists of 2 conducting plates separated a dielectric…

Q: CAPACITANCE IN A CIRCUIT Construct a circuit using a schematic diagram with at least 6 capacitors…

Q: at which time the current is zero. Im

A: Given: Inductor is 8 mH Resistor is 2 ohm potential 20 V t=0, I=0

Q: The shown circuit is connected for a very long time with all capacitors were initially unchargod.…

Q: Three capacitors valued luF, 2uF and 5uF, What is their equivalent capacitance in series? And What…

Q: Measuring Capacitance One way to measure capacitance is to apply a voltage step to an RC circuit…

A: Solution- R=10 kΩC=100pF

Q: A capacitor of 50 μF is connected to 100 V d.c. is charged on So find the energy stored in the…

Q: A 5  resistor, an ideal inductor and a variable capacitor are connected in series to an…

Q: at time zero a 90uF capacitor with an initial charge of 15uC is connected across a 120 ohms…

A: In this question, We need to determine the time if capacitor gets fully discharge. We know time…

Q: 0.35-H inductor is connected across a 12-V AC power source whose frequency can be varied. Calculate…

A: The phasor current can be solved .

Q: Which of the following statements about inductors is correct? When an inductor and a capacitor…

A: Inductor: It is a two terminal passive electrical component. When electric current flows through an…

Q: 2.) The total capacitance of two Capacitors in series is 3MF. The first has a capacitance GMF and…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Ask NVC M Gmail
YouTube
Maps
Google bily
6.
in (A)
21
2.
4.
5.
Consider the following figure that shows the current in an inductor of 5 H. Find the voltage
across the inductor at t= 3.5 second.
otherwise
125 V
-12.5 V
25 V
75V
+++

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A capacitor of 80 uF is charged through a DC source of 8 v with internal resistance 40 ohm after a long time the source is short circuited with a wire of resistance 40 ohm. Find the time taken by the capacitor to discharge to the 75% of it's maximum value.
Two capacitors give an equivalent capacitance of 9.00 pF when connected in parallel and an equivalent capacitance of 2.00 pF when connected in series. a.) What is the capacitance of each capacitor? b.) John was asked to design a capacitor in which small size and large capacitance were required. He said that he can achieve that by inserting a piece of paper between the plates. Do you agree with him? Why? Is there anything else that could be done to increase the capacitance?
In the figure ɛ = inductor is ideal. If the switch is closed for a long time, what is the current through the inductor. Give your answer in A. 10.0 V, R1 = 4.00 N , and R2 = 1.00 N. The R1 S -R2 L ll
A 10 uF capacitor is charged to a voltage of 100 V. The capacitor is now discharged through a resistors of 20 kohm. Find the time constant.
What is the capacitance of a capacitor that stores 1mC of charge at 66V? How long does it take to charge it to 99% through a 3kn resistor? The capacitance is The capacitor should be charged for seconds
A fully charged capacitor has a voltage of 100V and is then discharged through a resistor. The potential difference across the capacitor is 1V after 10 seconds. What is the time constant of the circuit?
. Find the value of R, if the energized inductor L spends 20 % of its energy in 10 msec after the switch is turned ON. to ImH R=?
The capacitor behaves as an open circuit to a DC source. Why? How does the inductor behave to a DC source? Please explain in great detail.
A steady current of 4.5 A is flowing through an inductor with 50 volts across it. Find Inductance of the coil if the current falls to zero in 160 msec,
Using a simple series circuit with an inductor with inductance L and a resistor, R connected across a battery pack with total voltage V derive the equation governing the inductor's current growth response
Help me solve this
A capacitor is made of 2 rectangular metal plates with side length of 3cmx6cm separated by a distance of 2.36cm with water in between the plates. The capacitor has a voltage of 110v and is not connected to a battery. Calculate the capacitance. What is the new capacitance if we replace water with a new dielectric material with a constant of 3.75 in between the plates? What is the new voltage? What is the charge on each plate? Follow this format- Given: Required: Equtions: Solution: Answer: