Consider the following : (1) Twisted pair cables (2) Microwaves and Satellite Signals (3) Repeaters (4) Analog Transmissions (5) Fiber optics Which of the above is consider as (a) signal transmission medium is data communications? A. (1) and (5) B. (1) and (2) C. (1) (2) and (5) D. (1) (2) (3) and (5)

Consider the following : (1) Twisted pair cables (2) Microwaves and Satellite Signals (3) Repeaters (4) Analog Transmissions (5) Fiber optics Which of the above is consider as (a) signal transmission medium is data communications? A. (1) and (5) B. (1) and (2) C. (1) (2) and (5) D. (1) (2) (3) and (5)

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter17: Commercial And Industrial Air-conditioning Control Systems

Section: Chapter Questions

Problem 25RQ

See similar textbooks

Similar questions

3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks. The cable standard provides performance of up to 100 MHz. We would like to transmit information over a CAT-5 twisted pair cable at 500 megabits per second (Mbps). (a) Is a signal-to-noise ratio (SNR) of 30 dB adequate to transmit 500 Mbps? (b) What is the SNR required to just adequately transmit at 500 Mbps? Express your answer in decibels for the SNR
Convert (45.75), to base 7. (a) (63.5151..), (b) (231.3), (c) (0.625), (d) (66.25),
Write about the uses and importance of twisted pair cable - crossover cable
What advantages could the Network Laws have over the simple Series andParallel Circuits?
i. Explain the operational process of Chemical Vapor Disposition (CVD) in fiber optic cable manufacturing. State the advantages and disadvantages of the CVD pricess.
a) The Channel is a key component to consider in all communications systems. Give two examples of a channel commonly used in communications systems, and for each, the key properties that can impact transmission. Compare twisted-pair and fibre-optic wired channels. Explain how the use of differential signals can be used to improve the signal to noise ratio in a twisted pair channel. i) ii)
(b) Figure Q.4b shows an Adder/Subtractor circuit implemented using Adder Q. The delay for XOR = 2t, OR = AND=1t and cascadable full adder is used for ripple carry adder. Assume inputs X, Y and ADDSUB have arrived at Ot. Analyze the critical path delay for the circuit if:- X[7.4] YI7.4] 4. A[3.0] A[3.0] lo"cle C4 C8 C4 Adder Q co C4 Adder Q co ADDSUB Sum(3.0] Sum[3.0] Z17.4] Figure Q.4b i. Adder Q is a 4-bit Ripple-Carry Adder. Show your analysis in Table Q.4b.i. ii. Adder Q is a 4-bit Carry-Lookahead Adder. Show your analysis in Table Q.4b.ii. Table Q.4b.i Table Q.4b.ii To Node Delay To Node Delay Z3 Z3 С4 С4 Z7 Z7 C8 C8 Page 14 of 21
My Signals and Systems question is attached. I don't understand how to figure out parts b and c mostly, but help with a would also be appreciated. The problem is from Alan V. Oppenheim by Alan S. Willsky. Thank you!
C.Comments on this statement: "PMUs can be used as a protective relays”. D. What is the ZIB and it role in OPP E Is there any effect of existence of HVDC transmission lines in OPP and state estimations? F. Discuss the challenges that might face application of PMUS/WAMs in any given power system.
In the Transmission Line Simulator, the Transmission Line is composed of which parameter/s? O A. The Shunt Conductance Only O B. The Series Impedance and Shunt Capacitance O C. The Shunt Capacitance Only O D. The Series Impedance Only
Discuss the impact of cable thickness on its resistance and data transmission capabilities.
(b) In a junction of road instaled with traffic light, the sensor circuit with capabilties to detect a vehicle is planned to be buikl. By using the a.c bridge, discuss types of ac bridge that can be used for that purpose. Explain the concept using bock diagram of how the circut is connected and used with microprocessor.