Consider an inductor whose inductance varies as L(x) = 0.1H/cm. x, where x is the variable length of the inductor. The inductor is connected in series with a 100-W light bulb and a standard power source with the rms output 120 V at 60 Hz. Find the power consumed by the light bulb as a function of the length x in cm. Do not submit the units. The power output, P = Watts. At what length of the inductor the power output of the bulb reduces by a factor of 100? The length, x = Units Select an answer

Consider an inductor whose inductance varies as L(x) = 0.1H/cm. x, where x is the variable length of the inductor. The inductor is connected in series with a 100-W light bulb and a standard power source with the rms output 120 V at 60 Hz. Find the power consumed by the light bulb as a function of the length x in cm. Do not submit the units. The power output, P = Watts. At what length of the inductor the power output of the bulb reduces by a factor of 100? The length, x = Units Select an answer

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An AC voltage source and a resistor are connected in series to make up a simple AC circuit. If the source voltage is given by AV = AVmax sin(27ft) and the source frequency is 19.0 Hz, at what time t will the current flowing in this circuit be 61.0% of the peak current? 5.922 X Note that the voltage in this AC circuit is a sine function. Did you use the correct units for the argument of the sine function? ms
d) Determine the phasors VL, VR and Vc.
b) Determine the voltage ?(?) and current ?(?) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors ?L, ?r and ?c. e) Sketch the phasor diagram showing ?s, ?r, ?r, ?c and ?.
Plz solve it early.......
(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequency of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms - (iii) Determine phase relationship between voltage and current waveform. (c) From the measurement process, the circuit generated two different outputs, V,(t) and V,(t) with the same peak voltage. The V,(t) lagging V,(t) by 100°. If V,(t) =150sin(1000t – 40°)V , determine the RMS value and phase angle of.
(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequeney of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms . (iii) Determine phase relationship between voltage and current waveform.
THE SUBJECT IS BASIC ELECTRICAL ENGINEERING Chapter 12. Voltage and Current Relation
What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a480 nF capacitor in series. If the AC source has a peak emf of 5.0V, then what is the peakcurrent at 3000 Hz?At what frequency do you get the largest potential difference across the resistor? And what isthis potential difference?
Write the sinusoidal equation of the following waveform a. 4e (V) f=60 Hz 30 b. 0.01 f= 40 Hz - 100°-
Find the RMS value..
The inductive reactance (XL) .. .be ..... ..... affected by the harmonics of non- * .sinusoidal wave
The frequency of a sinusoidal voltage with a maximum value of 250V is 55 Hz.a) Write the equation for this voltage.b) Calculate the value of the voltage at 0.008 seconds from the beginning, while the curve increases in the positive direction from the moment t = 0?