Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The inner cylinder was forced to move a distance X yielding a new capacitance of 5 pF. Hence, the distance moved is approximately found to be

Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The inner cylinder was forced to move a distance X yielding a new capacitance of 5 pF. Hence, the distance moved is approximately found to be

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A coaxial cable used in a transmission line responds as a distributed capacitance to the circuit…

Q: Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages…

Q: An air filled capacitor of Co-2.0 µF is fully charged with Qo-51.0 µC using an electromotive force…

A: It is given in the question that an air-filled capacitor is charged with a charge Qo using an…

Q: A capacitance of 5 uF, if the current given in the graph below is applied, what would the voltage on…

A: Voltage across capacitance C=5uF At t=30us

Q: Derive the expression for the energy stored in the capacitor.

Q: C2 C3 Once vou u

A: The solution is given below

Q: The below diagram shows the De-Sauty method to measure the unknown capacitance (C). Then C, is given…

A: Circuit diagram is given as, Here, R1 and R2 are resistance C is standard capacitance, Cx is…

Q: What is the step response equations for Capacitor, and inductor?

A: Let the initial voltage of the capacitor is V(0) and initial current of the inductor is i(0)

Q: 5 is used to find the unknown values of inductance and capacitance. Determine the following, Figure…

Q: A resistance R, capacitance C, and inductance L are connected in series to a voltage source with…

A: Note: As per the policy we can solve only 3 sub parts of a question, please re-upload the remaining…

Q: below. The output node F' has a parasitic capacitance 'Cout'. VDp MpB MpA орen F A MnA Cout B. MnB…

A: a) In the given figure, there is a fault or we can say that it is open at the output,the PMOS is not…

Q: 1. Using the 500 2 theoretical resistance, the 4.1 mH inductance, and the 6V source, compute for the…

Q: Reduce the network below to the smallest possible number of components if each inductor is 1 n? and…

Q: Sketch plots of the magnitudes of the impedances of a 10-mH inductance, a 10-μF capacitance, and a…

A: Given data: The value of inductance is: 10 mH The value of capacitance is: 10 μF The value of…

Q: Prob 1. Given a parallel plate capacitor with parameters E, = 2, d = 3 nm and A = 1 mm². a. Find the…

A: An arrangement of electrodes and an insulating substance or dielectric constitute parallel plate…

Q: Sketch the waveform of the voltage Vc across the capacitor if Vc = 0V at t = 0 s, below for the…

A: We have given the problem

Q: Using GRSA(Given, Required, Solution, Answer) method provide 1 sample problem and steps in solving…

Q: State the phase relationship between current and voltage for a resistance, for an inductance, and…

A: For Resistance, The expression for Voltage is, VR=IR×ZR=IR×R=IR×R∠00 Therefore it is concluded as…

Q: Problem 2 Problem: A capacitor is allowed to discharge through a 1002 resistor and the voltage…

Q: A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…

A: Ohm's law is very important to find the current, voltage, or resistance of a circuit. According to…

Q: What current flows through an ideal capacitor if the voltage across the capacitor is constant with…

A: since the current flowing through an ideal capacitor is described by following equation: iC=Cdvdt…

Q: A 200 V, 50 Hz a.c. supply is given to capacitance of 25 micro F. If the supply is given, write the…

Q: Task: Using the given charge and discharge values at these discrete points in time, construct two…

Q: The voltage & charge relation for a capacitor is given by V = 1+q+q². The amount of energy required…

A: Given- V=1+q+q2,q0=1C to qt=3C, To Find- Amount of energy required (E).

Q: If the current through an ideal inductor is constant with time, what is the value of the voltage…

A: if the current flowing through an ideal inductor is constant with time, the voltage across inductor…

Q: 5. A capacitor is connected to a 10-mV, 1.2-MHz source and a current of 50 µA flows. What is the…

Q: dą Q-5. The charge, q, on a capacitor of capacitance C, of a series RCcircuit is given by = Ve t…

A: According to the question, There is the RC series circuit and the differential equation is given as…

Q: present a derivation for the expressions of the energy stored in a capacitor and inductor

Q: A pure inductance of L = 158 mH is connected to a V = 116 V, 50 Hz supply. The %| current taken by…

A: In this question we need to find a current taken by inductor.

Q: 3. Consider a long cylindrical capacitor (see figure on the right) wherein the separation distance d…

A: A rectangular sheet when rolled will form a cylinder. Since the distance between the plates of the…

Q: A pure inductance of L = 144 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…

Q: At time t1 a capacitance C is charged to a voltage of V1. Then, the capacitance discharges through a…

A: Now, draw the circuit having a series-connected capacitor and resistor. Initially, the capacitor…

Q: What are the minimum and maximum values of capacitance that can be obtained by connecting four 2-μF…

A: Given: The capacitors should be connected is shown as:

Q: pure capacitance of C =38 µF capacitor is connected to a V = 116 V, 50 Hz supply. The current taken…

Q: Using a simple series circuit with an inductor with inductance L and a resistor, R connected across…

Q: expression for the voltage across a 2 µF capacitor is given below. what is the sinusoidal expression…

A: We know relationship between voltage and current for capacitor.

Q: Determine the capacitance of the capacitor

Q: Find the total capacitance. Show complete solution and include the figures used to generate

A: In this question we will find equivalent capacitance....

Q: The capacitor is discharged through a resistor with the resistance R = 10000 Ohm with a relaxation…

Q: A pure inductance of L = 144 mH is connected to a V = 112 V, 50 Hz supply. The current ta by the…

Q: • Six identical capacitors with capacitance C are connected as shown in Fig a. What is the…

A: Capacitance- Capacitance does not depend upon Q and V but it depends upon ratio of Q and V.…

Q: A paper dielectric plate capacitor is to be experimentally tested. The metal plates and the paper…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vị. The capacitance is in parallel with…

A: A parallel RC circuit Initial capacitance have Vi voltage. If voltage across the capacitance at…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vj. The capacitance is in parallel with…

A: Applying KCL at node gives diffrential equation in terms of capacitor voltage. Solving differential…

Q: Given an initially charged capacitance that begins to discharge through a resistance at t=0, what…

A: The given capacitor is initially fully charged. The charge that will remain on its plate after the…

Q: Calculate the theoretical voltages across the resistor (VR) and capacitor (VC) for 500 Hz and 1750…

A: Given An RC circuit,we need to determine the voltage across capacitor and resistor. Please find the…

Question

10 cm
L
Consider a cylindrical transducer making a
capacitance of 8 pF, as shown in the figure
next. The inner cylinder was forced to move
a distance X yielding a new capacitance of
5 pF. Hence, the distance moved is
approximately found to be
2n E0
mm
€o = 8.85 x 10-12 F.m-1
2.5cm
None of the choices
3.75cm
6.25cm
1.25cm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Capacitance by AC- Bridge: The impedance of the capacitor of capacitance C is: Select one: a. Directly proportional to 1/C b. Directly proportional to 1/C2 C. Directly proportional to C2 d. Inversely proportional to 1/C
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
A 10 Q resistor is placed in series with a coil of self resistance RL and inductance L and a pure capacitor 'C' across a 50 V variable Ans: 40 Q, frequency supply. The current is maximum and has value of 1 A when the frequency is 500 Hz. At this frequency, voltage across the capacitor is 300 V. Calculate (i) capacitance of the capacitor (ii) resistance and inductance of the coil (iii) Power consumed in the circuit (iv) Voltage across the resistor and the coil. 1.06 µF, 95.5 mH,50 W,10 V,302.7 V
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?
R 4. A resistor and a capacitor are connected in series across a supply of 250V. Where supply frequency is 50HZ the current in the circuit is 5A. When the supply frequency is 60HZ, the current is 5.8A. Find the value of the capacitance.
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
What will happen to the current in the PURE CAPACITOR if the frequency is adjusted higher? and What will happen to the current in the PURE CAPACITOR if the frequency is adjusted lower?
A 20ohms resistor is connected in series with an inductor, a capacitor and an ammeter across a 25V variable frequency supply. When the frequency is 400Hz the current is at the maximum value of 0.5A and the p.d. across the capacitor is 150V. Calculate the capacitance of the capacitor and the resistance and inductance of the inductor.
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
An RC circuit has an emf of 5 V, a resistance of 10 ohms, a capacitance of 10 – 2 F, and initially a charge of 5 C on the capacitor. Determine the current flowing through the circuit. Ans.: I = - 99e – 10t/2