Capacitance’s of 15μF, 12μF, 17μF, and 19μF are connected in parallel to a Direct Voltage Supply of 400V. Determine the: (A) Equivalent Circuit Capacitance, (B) Total Charge, and (C) Charge on each Capacitor

Capacitance’s of 15μF, 12μF, 17μF, and 19μF are connected in parallel to a Direct Voltage Supply of 400V. Determine the: (A) Equivalent Circuit Capacitance, (B) Total Charge, and (C) Charge on each Capacitor

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: A capacitor consists of two similar square aluminum plates, each 10 cm x 10 cm mounted parallel and…

Q: Using the 0.68 kilo Ohms, 3.3mH inductance, and 5V source, compute for the theoretical voltages…

Q: A series RLC circuit has a resistance of 20 ohms, a capacitance of 102 Farads, an inductance of 10…

A: In the question, A series RLC circuit, Resistance R= 20 ohm Inductance L= 10H Capacitance C= 10-2 F…

Q: 1. In a circuit with a 9V battery and a 25mA lamp, what value resistor should you choose?

A: As per our policy i have attempted only one. Given data: Battery: 9V

Q: Given a variable capacitor that can be adjusted over the range of 40pf to 365pf we want to tune the…

Q: capacitor having capacitance of 10uF is connected with 1k ohm resistor in series. The switch of the…

A: Series circuit which have capacitor 10uF with 1k ohm resistor. DC supply =10 Volts, a. Draw a…

Q: For the circuit in Figure Q1(b), under DC condition, find the voltage across the capacitor, Ve and…

Q: voltage drop across

Q: Q3) an LRC circuit is set up with an inductance of 1/5 henry, a resistance of 1 ohm, and a…

A: For a series LRC circuit with L=15 H, R=1 Ω, C=56 F; the capacitor has an initial charge of q0=2 C…

Q: What is a true statement about the capacitors connected in series illustrated below? C 30 AV O The…

A: Energy stored in capacitors is calculated as

Q: A certain parallel-plate capacitor consists of two plates, each with area 200 cm2, separated by a…

A: If two metal plates are connected across a battery, then due to the charges of plates an electric…

Q: 5. A resistance, a capacitor and a variable inductance are connected in series across a 200-V, 50-Hz…

A: We need to find out circuit elements for given circuit

Q: A parallel plate capacitor having area 40 cm2 and plate spacing 1.0 mm is charged to potential…

A: The cross-sectional area of the capacitor is given by:

Q: For the circuit shown in the figure, in which the capacitor is initially fully discharged. If the…

Q: 1. Using the 500 2 theoretical resistance, the 4.1 mH inductance, and the 6V source, compute for the…

Q: Suppose that we have two 100-μF capacitors. One is charged to an initial voltage of 50 V, and the…

A: Given data, The value of capacitor C1 = 100 μF. The value of capacitor C2 = 100 μF. The value of…

Q: Sketch the waveform of the voltage Vc across the capacitor if Vc = 0V at t = 0 s, below for the…

A: We have given the problem

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge.…

Q: A small capacitor of 100 pF is charged by a steady current of 1 µA for 1 ms. At that time, the…

Q: (a) If the capacitor is initially uncharged with C = 8.50 µF and = 1230 V, find the value of R (in…

Q: A pure inductance of L = 120 mH is connected to a V = 102 V, 50 Hz supply. The current taken by the…

A: Ohm's law is very important to find the current, voltage, or resistance of a circuit. According to…

Q: 19 10 cm Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure…

Q: Find the energy (in microjoules) stored in the inductor at 5 ms. e.) Find the maximum energy 9in…

Q: In the circuit diagram below, the capacitor C is first fully charged by using a 6.0V battery and the…

Q: 1. Design a capacitor set-up that can give at least 1 Farad. You can focus on the design by finding…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from…

A: find the voltage across capacitor at t = 2.5ms ?

Q: An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a…

Q: Ina series RLC circuit, the supply voltage is 120 volts 60-cyle, the resistance of resistoris 10…

Q: For the circuit shown below, find an expression for the voltage drop across the inductor after the…

A: Find the current through the inductor for t < 0.

Q: You are provided with three capacitors of values 4μF, 6μF, 30μF and 220V power supply. Connect the…

A: As per the guidelines of Bartleby we have to solve first three sub part of the question. For…

Q: 4) b) The circuit of figure given below shows a capacitor, two ideal batteries, two resistors, and a…

A: It is given that: C=10 μFε1=1 Vε2=2.2 VR1=0.2 ΩR2=0.4 Ω

Q: Two capacitors of 200 and 800 nF, respectively are connected in parallel. The combination is then…

Q: At a potential of 7000 V, a simple parallel-plate capacitor will be built to store charge. The…

Q: The capacitor is discharged through a resistor with the resistance R = 10000 Ohm with a relaxation…

Q: A large capacitor of 1000 μF is charged by a steady current of 1 mA until it reaches a voltage of100…

A: To solve the above question, one should understand the behavior of Inductor and capacitor in DC…

Q: Calculate the capacitance between two parallel plates, each of which is 100 sq. Inches and 2 mm…

A: We need to find out capacitance for given parallel plate capacitor . We will also find out…

Q: A capacitor is constructed with parallel metal plates, If the plate separation is 2 mm and the…

Q: 4. When a capacitor, charged to a p.d. of 300 V, is connected to a voltmeter having a resistance of…

Q: Fill in the blanks add, capacitance, charge capacity, dielectric, dissipate, electrical circuits, ,…

A: The solution is as follows.

Q: Given the waveform below for the current of a 20 uF capacitor, sketch the waveform of the voltage Vc…

A: Expression of the voltage across the capacitor: vct2-vct1=1C∫t1t2 iC dt→eq. i From the given figure,…

Q: 1. A cardiac defibrillator is used to shock a heart that is beating erratically. The capacitor is…

Q: Suppose a battery is connected to a parallel-plate capacitor with (infinitely) large plates and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A series circuit has a capacitor of 0.25 x 10-0 F, a resistor of 5x 10' 2, and an inductor of 1 H.…

Q: 5. An RC (DC) circuit consists of a Resistor with a resistance of 25000 2 and Capacitor in series…

Q: ** 18. The following questions refer to the circuit represented by the diagram at right. Think of R,…

A: According to the question we have to calculate, a) Immediately after the switch is closed,…

Q: btain the expression of the voltage across the capacitor from the Experiment when the circuit is…

A: Given Data: R = 10 k C = 10 uF Vs = 5 V

Q: A capacitor has a capacitance of 10 µF and a phase difference of 10°. It is inserted in series with…

A: Given,Capacitance (C)=10 μF=10×10-6 FPhase difference =10°Voltage =200 VFrequency = 50 HzR=100 Ω

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
4. In what form is the energy of a capacitor stored?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
A resistor and a capacitor are connected in series with a variable inductor. When the circuit is connected to a 240 – V, 50 – Hz supply, the maximum current given by varying the inductance is 0.5 A. At this current, the voltage across the capacitor is 250 V. Calculate the values of (a) the resistance, (b) the capacitance, and (c) the inductance. draw circuit diagram
A. Find the equivalent capacitance of the combination shown in the figure. (C2 = 2µF, C3 = 3µF) B. Determine the charge on each capacitor, if there is a potential difference of 900V C. Determine the voltages across each capacitor
The parallel capacitor combination shown in the figure is connected across a 12 V source. Determine the following: a. equivalent capacitance Ceq b. the charge on the combination. c. the work needed to carry the charge across 1uF + 12V 3uF 2uF
A variable capacitance and a resistance of 290 2 are connected in series across a 110-V; 60-Hz supply. Draw the complex or locus of impedance and current as the capacitance changes from 6uF to 32 µF. From the diagram, find (a) the capacitance to give a current of 0.6 A and (b) the current when the capacitance is 11 µF.
Refer to the diagram below. Compute the total capacitance, voltage and charge across each capacitor given that the total voltage is 120V. Please help, I've been getting ridiculously long decimal values and I don't know what to do.