An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a source of E=10cos2t V. At t=0, the charge on the capacitor and current in the circuit is zero. Find the charge and current at any time t.

An inductor of 5H, a resistor of 20ohms, and a capacitor of 20mF are connected in series with a source of E=10cos2t V. At t=0, the charge on the capacitor and current in the circuit is zero. Find the charge and current at any time t.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Related questions

Q: The Voltage across a capacitor s given Velt)='500teas0ot V. 2500€ as Find the eneray stored in the…

Q: Q2) For the circuit in the figure, the capacitance is 0.5, the resistor is linear with v-i…

A: It is given that the resistance has a linear characteristic v=2i. So we have vi=2. And by ohm's law…

Q: The RC circuit shown in the figure has resistance of R=3kn and the capacitance of C=14µF. The…

A: The given RC circuit have initial voltage Vo= 15V Resistance R= 3k ohm Capacitance C= 14uF Find the…

Q: A 130-µF capacitance is initially charged to 1160 V . At t = 0, it is connected to a 1-k2…

A: Energy stored in capacitor=12×CV2. We will write expression for for general Expression for voltage…

Q: An air filled capacitor of Co-2.0 µF is fully charged with Qo-51.0 µC using an electromotive force…

A: It is given in the question that an air-filled capacitor is charged with a charge Qo using an…

Q: At t=0, a constant 5-V voltage source is applied to a 3-H inductor. Assume an initial current of…

A: It is given initial current is 0 Therefore , Inductance L = 3 H and source voltage V = 5 V Current…

Q: Prior to t=0, the current in a 2-H inductance is zero. Starting at t=0, the current is increased…

A: For the given details regarding the values of the current across the inductor. The curve between the…

Q: Design a simple charging circuit using a 100 V source, a 1M resistor and a capacitor. The circuit…

A: The capacitor will not reach its final immediately after giving the input it will take five times…

Q: A capacitor with capacitance C = 1.0 pF is charged to a potential of Vo = 9.0 V. The charged…

Q: An RC circuit has no applied emf, a resistance of 10 ohms, a capacitance of 0.04 farad, and an…

A: In a RC circuit,The applied emf is zero.E=0The resistance is,R=10ΩThe capacitance is,C=0.04FThe…

Q: The current through a 100-mH inductance is given by i( t )=exp( −t ) sin( 10t ) in which the angle…

A: The current through the 100-mH inductance is given by, Hence, the inductance is calculated by using…

Q: A certain parallel-plate capacitor consists of two plates, each with area 200 cm2, separated by a…

A: If two metal plates are connected across a battery, then due to the charges of plates an electric…

Q: 5. A resistance, a capacitor and a variable inductance are connected in series across a 200-V, 50-Hz…

A: We need to find out circuit elements for given circuit

Q: Convince yourself that the product of the resistance and capacitance is as shown: ne - - S Ẽ · dĽ\ /…

Q: Derive the equivalent circuit for a parallel connection of ideal capacitors. Assume that the initial…

A: Parallel combination of capacitors is given in below figure, Current I is equal to,

Q: RC circuit equation Suppose a battery with voltage V is con- nected in series to a capacitor (a…

A: a) I'(t)+I(t)RC=0dIdt+I(t)RC=0 Arranging them, dII=-dtRC∫dII=∫-dtRCln…

Q: Capacitors in Figure Ql(a) has been charged up to its steady state condition. For each of the…

Q: Capacitance= 5uF

A: 1). Given, Capacitance= 5 μF Now, Time constant,Ƭ = ReqCwhere, Req=4ll2 =4×24+2 =86…

Q: Suppose that at t=0, we connect an uncharged 10{μF capacitor to a charging circuitconsisting of a…

A: Given values are = Initially, We connect an uncharged 10μF capacitor to a charging circuit…

Q: A 100{μF capacitance is initially charged to 1000 V. At t=0 it is connected to a 1-kΩ resistance. At…

A: Value of capacitance Initial voltage across capacitor Value of resistance Energy stored by…

Q: v(t) = -3e-3t V and i(t) = 4 + 2e-3t A fort >0

A: Designing a circuit can be done in multiple way. It is depend on the designer and their knowledge.…

Q: The current flowing through a 2-H inductance is given by 5 exp( −20t ) A. Find expressions for the…

A: Given data, The value of inductor L = 2 H. The value of current i(t) = 5exp(-20t) A. The…

Q: A circuit consists of switches that open or close at t=0, resistances, dc sources, and a single…

A: According to the given problem we will consider a series RL circuit which can be realized as…

Q: ) Using DC energy circuit behavior, dekermine the stored the inductore in ) Calcolate the value of…

Q: A small capacitor of 100 pF is charged by a steady current of 1 µA for 1 ms. At that time, the…

Q: A capacitor of capacity C is discharged through a resistance of value R. If the charge of this…

Q: Switch S is closed in position a at time t = 0 for along of time in the below circuit, to being…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: What are the steps in solving a circuit having a resistance, a source, and an inductance (or…

A: Concept: A capacity to do work is called energy and it may exist in potential, kinetic, thermal,…

Q: Problem 2 Problem: A capacitor is allowed to discharge through a 1002 resistor and the voltage…

Q: The circuit shown in the figure consists of ideal batteries ɛ, =20V and E2 =20V, resistors R =6002,…

A: Given circuit, Now, E1+E2-qc+qc-iR=040-2q10mF-dqdt×600=0 By solving above equation, q=q01-e-tς…

Q: Calculate the equivalent capacitance for the circuit shown.

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

A: To find current through the inductor , first we need to know that , under steady state condition ,…

Q: What is the practical application of a circuit that you can tune such that it reaches some minimum…

A: The Resistance in a circuit can be paired as the series or parallel combination. These combinations…

Q: An R-C series circuit consists of a capacitor with capacitance, C, connected in series with a…

Q: At time t1 a capacitance C is charged to a voltage of V1. Then, the capacitance discharges through a…

A: Now, draw the circuit having a series-connected capacitor and resistor. Initially, the capacitor…

Q: For a resistor, what resistance corresponds to a short circuit? For an uncharged capacitor, what…

A: For short circuit, Resistor The expression of ohm's law is, V=IR, for short circuit V = 0…

Q: What are the minimum and maximum values of capacitance that can be obtained by connecting four 2-μF…

A: Given: The capacitors should be connected is shown as:

Q: Q2) The uncharged capacitor in the circuit shown in figure is initially switched to terminal (1). At…

Q: Using a simple series circuit with an inductor with inductance L and a resistor, R connected across…

Q: Give the expression for the time constant of a circuit consisting of an inductance with an initial…

A: Given: The expression are shown as:

Q: A circuit with a battery, 2 resistors, a capacitor, and a switch is built as shown in the figure.…

Q: Q1: A current waveform in a 10 µF capacitor is shown below. If the initial voltage in the capacitor…

Q: Att<0, a 360-nF capacitance is charged to an unknown voltage Vị. The capacitance is in parallel with…

A: A parallel RC circuit Initial capacitance have Vi voltage. If voltage across the capacitance at…

Q: 16. Consider a simple RC circuit which has a resistor of 2 ohm and capacitor of 3F. If the initial…

A: We are authorized to answer only one question at a time since you have not mentioned which question…

Q: Q2) The uncharged capacitor in the circuit shown in figure is initially switched to terminal (1).…

A: we gave given in circuit;input voltage V=400Vresistance respectively R1 and R2 are 100kΩ…

Q: Att = 0, a charged 27-µF capacitance is connected to a voltmeter (VM), as shown in the figure below.…

A: The capacitor stores the charge in the form of voltage. The current can be exponential decaying or…

Q: An RC circuit has an emf of 100 volts, a resistance of 5 ohms, a capacitance of 0.02 farad, and an…

A: 1st we will find out voltage across the the capacitor then we will find out the charge on capacitor…

Q: waveforms to scale versus time. 2. The current through a 200-mH inductance is given by i₁(t) =…

A: clc; clear all; close all; syms t; i=exp(-2*t)*sin(4*pi*t); l=0.2; %200mH=0.2H k=diff(i); v=l*k;…

Q: 1. Equivalent Capacitance, Charge and Energy. Consider the circuit below. The capacitors are all…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An inductor is "charged" to some value, then connected in series with a 1002 resistor and allowed to "discharge". A measurement of the potential difference across the resistor is shown in the figure below. Compute the time constant of the circuit, the inductance of the inductor, and the initial current through the inductor. 12 10 8 6 Potential across resistor (V) 2 0 0 0.0001 0.0002 0.0003 0.0004 0.0005 0.0006 0.0007 time (s)
A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0, there is no charge on the capacitor. Find the capacitance if the current at t = 5 seconds is 3/e^s amperes. Ans. 0.05 Farads
a. Show how you would connect all five capacitors to get a maximum capacitance and find the maximum capacitance in terms of C. b. Show how you would connect all five capacitors to get a minimum capacitance and find the minimum capacitance in terms of C.
how do i calculate the inverse capacitance and its uncertainty if the capacitance value 1.8748+/- 0.0006. please show steps im using this example to do my other values.
Three capacitors each of the capacitance C are given. The resultant capacitance 2/3 C Can be obtained by using them ? a)Two in parallel and third in series with this combination b)All in parallel c)All in series d)Two in series and third in parallel across this combination
A 100- resistor, an uncharged 100-µF capacitor and a switch are connected in series across a 24-V battery. The switched is closed at t = 0. Determine the rate of increase in the capacitor voltage after t = 2 ms.
6. An inductive circuit of 50-2 resistance and 0.08-H inductance is connected in series with a capacitor across a 200-V, 50-Hz supply. The current taken is 3.8 A leading. Find the value of the capacitor.
The parallel capacitor combination shown in the figure is connected across a 12 V source. Determine the following: a. equivalent capacitance Ceq b. the charge on the combination. c. the work needed to carry the charge across 1uF + 12V 3uF 2uF
Suppose that we have a 1000-pF parallel-plate capacitor with air dielectric charged to 1000 V. The capacitor terminals are open circuited. Find the stored energy. If the plates are moved farther apart so that d is doubled, determine the new voltage on the capacitor and the new stored energy. Where did the extra energy come from?