Calculate the theoretical flame temperature of a gas containing 30% carbon monoxide and 70% nitrogen when burnt with 100% excess air. Both the reactants enter at 298 K. Standard heat of formation of carbon dioxide and carbon monoxide are -393.7 kJ/mol and -110.6 kJ/mol, respectively.

Q: O calculate the energy change, in kJ,

A: 1 mole of O2 goes from 200°C to 800°C We have to calculate energy change From Table B.8 provided in…

Q: specify: a. standard heat of reaction at 25 degrees Celsius b. standard heat of reaction at 400…

A: a) At 25°C standard heat of reaction N2g+C2H2g→2HCNg Heat of reaction…

Q: Compare the standard heat of combustion at 6 moles of CH3OH(g) at 25 C with the standard heat of…

A: The combustion reaction of CH3OH is as follows:

Q: . The HHV for Ethanol is 29.7 MJ/kg. From this information, please determine the heat of formation…

A:

Q: 1. The chemical formula for methyl linoleate biodiesel is C19H3402. How much heat (in kJ) is…

A: Since we are entitled to answer only 1 question, we’ll answer the first one. Please resubmit other…

Q: Calculate the adiabatic temperature of the combustion products if methane is burned with 20% excess…

A: Given: Methane is burned with 20% excess oxygen  The reactants enter at 25oC. a)Methane is burned…

Q: oxygen and aluminum react to form aluminum(III) oxide. the delta H reaction for this is -3339.6 kJ.…

A:

Q: 5. Below equation may be used in order to evaluate the heat capacity of Solid X: cal 0.503x105 =…

A:

Q: Heat in the amount of 798.50 kJ is added to 10 g-mol of ethylene, initially at 180 C at atmospheric…

A: In thermodynamics, heat is energy in transfer to or from a thermodynamic system, by mechanisms other…

Q: Hot waters enters a radiator at a rate of 0.5 kg/s, losing heat from 100°C to 75°C. Air flows across…

A: Given: Number of Tubes(N)=50 tubes Inner diameter of tube(di)=5mm=0.005 m Length  of…

Q: sulfur and 0.7% ash by mass. There are no other elements in the bio-oil. The HHV of this fuel is…

A: This problem involves application of High Heating Value( HHV) and Lower Heating Value (LHV). The…

Q: 4. The latent heat of vaporization of n-hexane at 25 °C is 366.1 J/g. What approximately is the…

A: Value of latent heat of vaporization at 1500C is asked.

Q: 3.35 Calculate the maximum flame temperature attained when methane is burned with theoretical air…

A: Let the methane be stream 1 and air be stream 2 fed to the reactor at 298 K. The product stream is…

Q: A food product containing 85% moisture content is being frozen. Estimate the specific heat of the…

A: Given data: Temperature of food product = -100C Moisture content in the food product = 85 % Specific…

Q: Estimate the theoretical flame temperature of a gas containing 40% CO and 60% N2 when burned with…

A:

Q: Gas having a composition of 40 weight % of ethane and 60 weight % of Butane is to be heated from 150…

A:

Q: In a process plant handling benzene compounds, a vertical thermosyphon reboiler is used in a column…

A: Here thermosyphon reboiler is used.Steam pressure = 20 barColumn bottom pressure = 1.2 barMolecular…

Q: 6) Estimate is AH, AS, and AG for the following reaction CH6 (benzene, liq.) 30°C C,H6 (vapor) at…

A: The enthalpy is a product of heat capacity and temperature. The change in enthalpy is given by the…

Q: An air sample contains 10% H2O(g) by mole   at 100 °C, 1 atm. a.At what temperature would be the…

A: Given data: The composition of water in the air mixture = 10 mole % Temperature of air sample = 100…

Q: 1-kg/s Glycerin (C₂=2200 J/kg.K) is to be heated from 20°C to 60°C using 2-kg/s Ethylene Glycol (Cp…

A:

Q: Estimate the heat of vaporization of methyl chloride at 243.15 K from the Clapeyron equation…

A: Temperature, T = 243.15 K Clapeyron equation, lnPs= 14.2410 - 2137.72T-26.72..........(i) We know…

Q: A food product containing 82% moisture content is being frozen. Estimated specific heat of the…

A: Moisture content = 82% Moisture content is being frozen = 75 % Specific heat of the dry product = 2…

Q: The vapor pressure of liquid cadmium is 400 mm Hg at 983 K. Assuming that its molar heat of…

A: The vapor pressure of liquid cadmium at 959 K is to be calculated.

Q: 3. When 45 g of an alloy at 45°C was dropped into 100.0 g of water (initially at 35°C). If the final…

A: Given Alloy information ma= 45g Ta,i= 45°C Ta,f =37℃ Water information mw =100g Tw,i=35℃ Tw,f…

Q: Write the thermochemical equation for the following reactions that occur at constant pressure.

A: Given that, The amount of heat released = 3923.9 kJ It is required to write the thermochemical…

Q: Propane is burned with 300% theoretical air; both are at 25℃ and 1 atm. Predict the adiabatic flame…

A: The initial temperature of reactants is, T1 = 25 °C The pressure of the reactants is, P1 = 1 atm The…

Q: 2. 1 toluene. Entering the process is 0.5126 m³ of toluene (C,Hs) vapor at 124 °C. The liquid…

A: Given: A toluene-water system enters a heat exchanger For toluene: Volume V = 0.5126 m3 and; Let the…

Q: food product containing 80% moisture content is being frozen. Predict the specific heat of the…

A: Moisture content = 80 % specific heat of the dry product = 2.5 kJ / (kg ° C) Specific heat of…

Q: What amount of heat is required to heat 5g of liquid water from 0°C to 100°C? The specific heat of…

A: The Law of conservation of Energy states that energy in the Universe is constant. Energy can neither…

Q: 10 mol of feed composed of 40 mol% methanol and 60 mol% ethanol at 20 cantigrade C is fed…

A: Specific heat is defined by the amount of heat needed to raise the temperature of 1 g of a substance…

Q: determine the enthalpy of formation at 298 K

A:

Q: If LiCl·3H2O(s) and H2O(l) are mixed isothermally at 25°C (298.15 K) to form a solution containing…

A: Heat of reaction is either the amount added to reaction or removed from reaction. This action is…

Q: Calculate AH;f

A: To produce change in temperature by a unit degree of a molecule, the amount of heat required for the…

Q: Calculate the theoretical flame temperature when an equimolar mixture of methane and ethylene at…

A:

Q: In order to concentrate 5,000 kg/h of an NaOH solution containing 10 wt.% NaOH to a 25 wt.%…

A: A solution of NaOH is concentrated in single –effect evaporator.

Q: Once the methanol has reached its boiling point, it must be vaporized. Themolar enthalpy of…

A: Given: The enthalpy of vaporization for methanol is ∆Hvap = 38 kJ/mol The amount of heat (Q)…

Q: The heat of fusion of water is 6.01 kJ/mol. The heat capacity of liquid water is 75.3 J/mol K. The…

A: The amount of heat requires in kJ is to be calculated for the given conversion.

Q: If a food product is being frozen in a system capable of removing 6200 kJ of thermal energy per…

A:

Q: At 150 °C, linalyl acetate exerts a vapor pressure of 93 tor. If a steam still were run using steam…

A: