Calculate the equilibrium conversion and concentration for each of the following reactions: (A) The reversible reaction 2 A B is carried out in a flow reactor where pure A is fed at a concentration of 4.0 mol/dm³. If the equilibrium conversion is found to be 60%, then: (1) What is the equilibrium constant, Kc, if the reaction is a pure gas phase reaction? (2) What is the Kc if the reaction is a liquid phase reaction?

Q: The deepest point in the oceans of the world is believed to be in the Marianas Trench, southeast of…

A: Given-The pressure is substantially higher at the ocean's depths than it is at the water's surface.…

Q: In a reactive system with recycle, impurities keep accumulating over a period of time. Your boss…

A: "Since you have posted multiple questions, we will provide the solution only to the first question…

Q: A stirred-tank blending system initially is full of water and is being fed pure water at a constant…

A: 1% Define the parameters 2V = 2; % Volume (m³) 3q = 0.4; % Flow rate (m³/min) 4Ci =…

Q: steam table

A: State 1 : Superheated water vapor at P1 = 180 psia and T1 = 400 °F.State 2 : temperature, T2 =…

Q: 23.24 A sample of wastewater was incubated for 7 days at 20°C and showed a BOD of 208 mg/L. (Assume…

A: After 7 days of incubation, BOD = 208 mg/Lk' = 0.35/day

Q: The mass density of a 20% by mass ethanol/water solution is 968.7 kg/m3 at 200C. Calculate the…

A:

Q: C4.1 In a certain medical application, water at room temperature and pressure flows through length…

A: Length of rectangular channel, L = 10 cm Width of rectangular channel = 1 cm Gap thickness = 0.3 mm…

Q: Consider a hollow tube with a length of 20m and a diameter of .5m. As shown below, the concentration…

A:

Q: Problem 2: A perfusion bioreactor used to grow bone has a volume of 500 mL as shown. Osteogenic…

A: Volume of bioreactor= 500 mLThis is a straightforward calculation. The volume of the bioreactor is…

Q: Iron ore is wet-milled, the mill produces a pulp at a rate of 1.54 t/hr. The mill product has a…

A: Mill Characteristics:Mill product rate (Q) = 1.54 t/hrLiquid-to-solids ratio (L/S) of mill product =…

Q: A heat exchanger uses 5000 kg/hr of water to cool hydrocarbon oil from 140oC to 65oC. The oil,…

A: In a heat exchanger, two fluids, namely hydrocarbon oil and water, are used to transfer heat between…

Q: 3.48. Calculate Z and V for boron trichloride at 300 K and 1.5 bar by the following equations: (a)…

A: (a). Truncated viral equation Z=(PV/RT)=1+(B/V)+(C/V2)]Using the given values of…

Q: top 10 practical learnings in chemical engineering that I can apply in real life

A: Chemical engineering is the branch of engineering where principles of science and mathematics is…

Q: 1. The partial molar enthalpies of species in simple binary mixtures can sometimes be approximated…

A:

Q: A plate, which is moving with velocity 10 cm/s, is placed 0.5 cm apart from a fixed plate. What will…

A:

Q: C₂H₂ + N¥₂ + 20₁₂ → C₂ H₂ N = 3H/₂C The feed to propylene anmoxidation off process Contain's 10.0…

A:

Q: A landfill cell is open for 5 years, receiving solid waste of 250,000 tonnes/year. Calculate the…

A: To calculate the methane gas production for each year during the first five years of the landfill…

Q: t = 2π F m where t = period, 1 = length of strength where: n frequency of vibration, 1= length of…

A: To check whether the given relations are true using the method of dimensional analysis, we'll…

Q: In the figure below, a tank partially filled with liquid (SG =1.2) is connected to a closed end…

A:

Q: reaction stoichiometry

A:

Q: What is the power output -2

A:

Q: The decay of U-238 to Pb-206 can be used to estimate the age of inorganic matter. The half-life of…

A: To calculate the age of the rock using the decay of U-238 to Pb-206, you can use the concept of…

Q: Consider a second order reaction where ? → ?. The reaction is performed in a batch reactor where the…

A:

Q: -TA XA 0.0 mol m³.sec (m³-sec) -TA FAO (m³-sec -TA mol 0.49 0.1 (A) Calculate values of 0.41 0.2…

A: A reaction, AB is given with following information,Feed flow rate, FA0 = 0.8 Pure reactant A is…

Q: Consider freezing a 2 cm x 2 cm x 2 cm cube of water. Calculate AH, AU, q, w, and AS for the…

A:

Q: 40 g/min a solution containing only chemicals A and B flow through a tanko The volumetrie flow rate…

A:

Q: The rate at which solid dissolves from a flat plate of solid benzoic acid in to water flowing past…

A: Molar flux of benzoic acid Solubility of benzoic acid in water = 2.9510-2 kmol/m3Diffusivity of…

Q: 2. Experimental measurements of the molar volume (in cm³ mol-¹) of binary mixtures of species A and…

A: Determine the values of the pure-component molar volumes of species A and B (in cm³ mol⁻¹).Given the…

Q: 2. How many kg of water are evaporated per kg of wood when the wood is dried from 40% moisture to…

A:

Q: A chemical reaction A→B is carried out in a closed vessel. The following data are taken for the…

A:

Q: Nitrogen from a gaseous phase is to be diffused into pure iron at 700°C. If the surface…

A:

Q: 6.6. In Example 6.2 how much does the internal energy per unit mass of the fluid increase as it…

A: The head loss across the viscometer is 1.2 ft. Assuming that the fluid is flowing horizontally, the…

Q: What is the equation that defines fugacity? O None of the above GR P ln (RT) In GR RT Ope() GR RT)

A: fugacity in terms of Gibbs free energy we find equation or relation between them

Q: Estimate the density (in kg/m³ and lbm/ft³) of a particle in if its specific surface area is equal…

A:

Q: If an anaerobic reactors operates at 1 atm and 35°C produced 20 m³/d of biogas with CH₁ of 50%,…

A:

Q: 2- The steady state flow of a liquid əx Space between two very large static parallel plates at a…

A: A steady state flow of fluid is flowing between two very large parallel plates in the…

Q: An inventor has devised a complicated nonflow process in which 1 mol of air is the working fluid.…

A: A physical principle based on observed interactions between heat and energy, the second law of…

Q: Mn in groundwater A ground water has the following conditions: {Mn2+ (aq)} = 1.0x10 -5 pH = 7.0…

A:

Q: Cyclobutane can decompose to form ethylene: C4H8(g) →2C₂H4(9). The cyclobutane concentration can be…

A:

Q: Discuss the different products obtained from the r

A: Crude oil, the raw material in petroleum refining, is processed at refineries to yield various…

Q: 2. At 25°C the surface tension of benzene is 28.9 mN/m and its molar volume is 89.2 cm³/mol.…

A: Given Data :At 25 degree C the surface tension of benzene is  Molar volume of benzene((Vm)) is  -…

Q: a) What is the CSTR reactor volume necessary to achieve 90% conversion? b) What PFR volume is…

A:

Q: (b) I wo fluid streams with velocities u₁ and u₂ flow between parallel plates separated by a…

A: Given :u1 =15m/s   u2 = 40 m/sh = 25 m/sw= 3 mU=25 m/s

Q: A mixture of benzene and toluene containing 40 mole % of benzene is to be separated to give a…

A: In this problem, we are considering the separation of a mixture of benzene and toluene using a…

Q: Example 2-1 Consider the liquid reaction: A → B is to be carried out isothermally in a continuous…

A: Liquid phase reaction taking place is Reaction takes place in continuous flow reactor.Conversion of…

Q: Scrubbing with an oil in a 4-tray tower

A:

Q: The decay of U-238 to Pb-206 can be used to estimate the age of inorganic matter. The half-life of…

A: The decay of the U - 238  to Pb - 206 is used to estimate the age of the inorganic matter .The half…

Q: A fluid is flowing in a pipe. The pressure drop is 10 psi per 1000 ft. We now double the volumetric…

A:

Q: he body normally produces about 2 g of creatinine per day. the amount varies with individuals and us…

A:

Q: How long will it take for a non-reactive contaminant to travel a distance of 8 m if Darcy's flux is…

A: Darcy's flux = 8 cm/day Porosity of the soil = 0.4