2. At 25°C the surface tension of benzene is 28.9 mN/m and its molar volume is 89.2 cm³/mol. Determine the relative pressures at which condensation of benzene vapour should begin in a cylindrical capillary of radius 20 nm if the capillary is (a) closed at one end, (b) open at both ends. Assume zero contact angle and neglect adsorption on the walls of the capillary.

Q: Convert Henry's constant for benzene, 5.5 x 10^-3 atm.m³ per mole at 20°C, to a dimensionless…

A:

Q: Determine the reaction order,K value( unit must be included )and the R^2 value using the graphic…

A:

Q: 2. Urea solution is applied to generate ammonia under pressure and high temperature for de-NOx…

A: A process flow diagram of ammonia production is given and controlled and manipulated variables are…

Q: lowing the wall at x = B to move in the positive z direction at a steady speed vo. Obtain (a) the…

A:

Q: In a vessel at 101.3 KN/m² and 300 K, The percentage relative humidity of the water vapor in the air…

A: Given,

Q: a non ideal mixture of components A and B exhibits an azeotrope at the composition Xa = Ya = 0.7. At…

A: (a) To find the activity coefficients for components A and B when these components are present in a…

Q: Calculate the theoretical oxygen demand of a solution containing 550 mg/L of glutamic acid (C₂H.NO).

A:

Q: In a binary distillation column, if the feed contains 40 mol% vapor, the q line will have a slope…

A: The equation of a feed line (or q-line) is given by the following equation:If we compare it with a…

Q: A stirred-tank blending system initially is full of water and is being fed pure water at a constant…

A: 1% Define the parameters 2V = 2; % Volume (m³) 3q = 0.4; % Flow rate (m³/min) 4Ci =…

Q: 10 ft 10 ft Very large Water 3-in steel pipe FIGURE 6.25 Tank draining by gravity, with pipe and…

A: Water is flowing from the bottom of a tank via 3 in steel pipe. Volumetric flow rate is to be…

Q: Calculate the pressure difference between points A and B 66.6 in Water 30.0 in 22.2 in 40.3 JJ in…

A: Assuming pressure at point A is PA and at point B is PB.We know specific gravity of water is 1 and…

Q: An MSDS can be utilized to create a COA.  True  False

A:

Q: Assess the environmental impact of microchip manufacturing and disposal, and discuss sustainable…

A:

Q: . CO₂ entering from a combustion (T= 500°C) process is mixed stoichiometrically with H₂ at (T=…

A:

Q: Calculate AS when two iron blocks, each of mass 1.00 kg, one at 200 K and the other at 25 K, are…

A: Mass of each block = 1.00 Kg Temperature of one block = 200 K temperature of other block = 25 K…

Q: Suppose fluid A is methanol, B is water and C is a manometer fluid with a specific gravity of 1.63;…

A:

Q: Mn in groundwater A ground water has the following conditions: {Mn2+ (aq)} = 1.0x10 -5 pH = 7.0…

A:

Q: A liquid feed of 100kmol/hr is fed to a distillation tower operating at 405.3 kPa. The composition…

A:

Q: How long will it take for a non-reactive contaminant to travel a distance of 8 m if Darcy's flux is…

A: Darcy's flux = 8 cm/day Porosity of the soil = 0.4

Q: Estimate the specific gravities (gas) for methane and propane. Their molecular weights are shown in…

A: Specific gravity of gas A is defined as the ratio of the density of gas A to the density of the…

Q: The tank in Fig. 3.7 has an inflow line with a cross-sectional area of 0.5 ft² and an outflow line…

A: To determine how many pounds-mass per second (lbm/s) of air are flowing through the vent and in…

Q: Climate change is attributed to the accumulation of carbon dioxide in the atmosphere. While the…

A: CO2 concentration after industrial revolution = 412 ppmCO2 concentration before industrial…

Q: Consider a following reaction carried out in a plug flow reactor. C₂H6 C₂H4 + H₂ C₂H6 + H₂ - 2 CH₂…

A: The differential equations for all components along the length of the reactor are:dC2H6/dx =…

Q: Consider a reaction 4A → B + 6C in a liquid phase with a re The feed contains 0.1 mol/L of A and…

A:

Q: 1 kg of a mixture of 60 wt% naphthalene crystallized at 24°C. in benzene is

A:

Q: Problem 1 Propane is catalytically dehydrogenated to produce propylene by passing it over a granular…

A:

Q: a) How many rotational degrees of freedom are there in a CO2 molecule and in a H2O molecule? b) If…

A:

Q: What is the key principle behind Enhanced Single Loop Control in chemical engineering, and how does…

A: Single Loop Control in chemical engineering typically refers to a control strategy where a single…

Q: 4. The industrial scrubber B in FIGURE Q4 consumes water (v=0.113 x 105 m²/s) at the rate of 0.1…

A:

Q: (B) The value of kinetic rate constant k using T = 300 K as the base case. From there, write out the…

A: The Arrhenius equation describes the temperature dependence of reaction rates. It is given bywhere,…

Q: 4) (Note that this is an exam problem from a previous year. Also note that Figure 8.1-1 will be…

A: To determine the partial molar enthalpies of sulfuric acid and water for a 50 mol% sulfuric acid…

Q: Composition in vapor phase 11 0.8- 0.6 Y₁ 0.4- 0.2 0 Equilibrium line 0.2 0.4 0.6 0.8 X1 Composition…

A: Equilibrium graph is given. Liquid mole fraction is given as 0.6 and vapor phase composition is to…

Q: Calculate the surface / volume of a sphere, a cube, and a right cylinder of height equal to…

A: Surface area to volume ratio of a cylinder, a sphere and a cube is to be calculated and compared.It…

Q: How many independent equations can be derived by applying balances to the nonreactive process…

A: A process can be solved for its variables if the degree of freedom of that process is zero.Degree of…

Q: An equimolar liquid mixture of benzene (B) and toluene (T) is in equilibrium with its vapor at 30…

A:

Q: A PM10 sampler was operated for a 24 hour period at a flowrate of 1.7 cubic meter/min. At the end of…

A:

Q: At room T, sucrose is hydrolyzed by the catalytic action of the enzyme, sucrase. Starting with the…

A:

Q: The feed to a distillation column contains 36% benzene by weight, the remaining being toluene. The…

A:

Q: An ideal gas with a volume of 1 m³ is at 100 °C and 2 bar. The gas undergoes a process with two…

A:

Q: An inventor has devised a complicated nonflow process in which 1 mol of air is the working fluid.…

A: A physical principle based on observed interactions between heat and energy, the second law of…

Q: Regulations of Contaminant (A) call for PPM less than or = to 20 PPM. is the treatment in spec?…

A:

Q: Determine pressure of CO₂ at 400 °C with a density of 10 mol/l. Using (a) The ideal-gas equation.…

A:

Q: Calculate K; for molecule X. K;

A: Where,

Q: A closed 2 m3 chamber is half-filled with water containing sulphur dioxide anhydride (H₂S). Water…

A:

Q: 1. For the system water (1) plus ethyl acetate (2) plus acetone (3) at 30°C and 1 atm, the following…

A: A ternary phase diagram shows possible phases and their equilibrium according to the composition of…

Q: Water is flowing at an average velocity of 7 ft/s in a 6-in pipe. What is the pressure drop per unit…

A:

Q: What is the final temperature when 25 kJ of heat is added to 10 gmol of N₂ in a constant pressure…

A:

Q: Find the general fugacity expression for the following equation of state as a function of T and P; V…

A: Equation of state as a function of Temperature and pressure isWhere a is constant

Q: At 1100 ºC n-nonane (n-C9H20) thermally cracks (i.e. breaks  into smaller molecule fragments) 20…

A:

Q: 11. (Mihelcic and Zimmerman, 2014, 7.36) The wastewater treatment plant for Pine City discharges 1.0…

A: