Based on the melting point of your impure solid, you look at the given samples and believe you have compound A. Compound A is recrystallized using a mixed solvent system of ethanol and water. You add 1 ml of hot ethanol to your sample and it doesn’t completely dissolve. You continue to add hot ethanol but there isn’t any change. Some solid remains. What should you do next?

Q: Why would a solvent with a very high boiling point be inappropriate for a recrystallization?…

A: There are some ideal conditions in selecting the solvent for crystallization. Among which the…

Q: Decide how the compounds below will partition during liquid-liquid extraction of water with an…

A: Polar compounds soluble in polar solvents( H2O) Non polar compounds soluble in non polar solvents

Q: Will recrystallization work as a purification technique on all samples? If the sample contained more…

A: Recrystallization techniques works only on the solid samples which is used to purify them. This…

Q: When checking the melting point of your impure sample, what temperature should you set as the…

A: In the event that the inexact temperature at which your sample should melt is known, the sample can…

Q: 5. Discuss how melting points of the impure sample and recrystallized sample could have been used to…

A: Melting point is the temperature at which there is a change from the solid to the liquid state i.e.…

Q: If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the…

A: The loss of water happening during the inital heating or during the second heating is not relevant

Q: Imagine your original mixture had contained a component capable of sublimation, such as naphthalene.…

A:

Q: Give some reasons that would lead you to purify a liquid by using vacuum distillation rather than by…

A: Distillation under reduced pressure is called vacuum distillation and is generally employed for…

Q: Is recrystallization a good method for purifying any product?

A:

Q: Add an excess of methanol to 8.0g of benzoic acid followed by a few drops Cool the mixture, pour…

A: The procedure given in the diagram is the method of preparation of ester (methyl benzoate) from…

Q: Organic solids are best purified by a. recrystallization b. vacuum distillation c. fractional…

A: Purification of organic compounds can be done by various methods namely distillation method,…

Q: Write the dispersion medium and dispersed phase in milk.

A: Phase of solution in which colloidal particles are present termed as dispersed phase. The phase in…

Q: Place 2.4 grams of sulfanilic monohydrate in a 125 ml Erlenmayer flask and dissolve it in 25 ml of…

A: Experiment: Place 2.4 grams of sulfanilic monohydrate in a 125 ml Erlenmayer flask and dissolve it…

Q: What is an effective way of preventing irregular ebullition or bumping of the mixture during…

A: The question is based on the concept of experimental chemistry. we have to suggest an effective way…

Q: 7. A student did a distillation experiment using 40 % aqueous ethanol and presented his result of…

A: Given : Distillation process using 40% ethanol  To find : 7 . Conclusion  8. Purpose of fractional…

Q: What is the effect of an insoluble impurity, such as charcoal, on the observed melting point of a…

A:

Q: See attached problem

A: Recrystallization is a technique used to purify chemicals. Recrystallization, also known as…

Q: Imagine you are an organic chemistry student who isolates a crude sample of salicylic acid following…

A: The melting point is largely dependent on the impurities present in the substance. If there are…

Q: Why is the collection done through a 10% Na,CO, solution? Remove traces of acids or neutralizes the…

A: The alcohol functional group in a molecule is observed by the presence of -OH group. For example,…

Q: As part of the discussion, explain your results from Part 2 within the context of Le Châtelier's…

A: The equilibrium system is: [Co(H2O)6]2+(aq)+2 Cl-(aq) ⇌   [CoCl2 (H2O)2 ] (aq) +4 H2O(l)   (pink)…

Q: How would you recrystallize a mixture of Benzoic acid and 2-Naphthol? Discuss the choice of solvent…

A:

Q: Which of the following statements is true when considering temperature during a recrystallization?…

A: For crystallization, it is important to prepare a saturated solution of the sample in minimum amount…

Q: After you collect a fraction from the column, how do you remove the solvent to get the pure…

A: Solid crude compound purify by column chromatography. Crude contains two or more compound. Column…

Q: Distillation Curve 110 100 90 80 70 60 50 40 20 40 60 100 120 Volume (drops) 13. Based from the…

A: Distillation is a technique in which the mixture of liquid can be separated.

Q: If we are recrystallizing a PURE compound, what will happen to the sample if we cool the solution…

A:

Q: While determining the pressure during the Dumas experiment, if the barometric pressure reported were…

A: Given: The barometric pressure reported was lower than the actual vapour pressure in the Dumas…

Q: what is the freezing method on separating alcohol to the mixture and its step by step process

A: Separating Alcohol Through Freezing: Start with a liquid that is 5%-15% alcohol. You'll need a…

Q: The phensuprin solid is first dissolved in ethyl acetate. One solid will be left over – what is it?…

A: Phensuprin is the mixture of aspirin or acetyl salicylic acid, acetanilide and sucrose.

Q: Contrast the physical appearance of the crude material before the recrystallization and that of the…

A: A question based on re-crystallization, which is to be accomplished.

Q: Why is it important to cool slowly during recrystallization

A: recrystallization is a process in which we dissolve an impure crystal in a solvent at high…

Q: Add an excess of methanol to 8.0g of benzoic acid followed by a few drops of concentrated sulfuric…

A: Benzoic acid reacts with methanol in the presence of sulfuric acid to produce methylbenzoate like…

Q: The best liquid mixtures for separation by simple distillation need to have boiling points that…

A:

Q: When performing arecrystallization, slocent with a boiling point less must be use than the melting…

A:

Q: All of the following is true about crystallization EXCEPT * A common practice is to dissolve the…

A: Ans. Crystallization is the process of obtaining the pure crystals of the sample from the sample…

Q: 2. Is it possible to purify a compound by recrystallization using a mixture of solvents? Why or why…

A:

Q: A pure white crystalline compound was found to melt at 131.5-132.0°C when taken on a melting point…

A: A question based on introduction to chemistry that is to be accomplished.

Q: what is the purpose of steam distillation? and what are the factors involved ?

A: Steam distillation is a separation process which purifies isolate temperature-sensitive materials,…

Q: Compare the simple distillation of pure hexane and binary mixture of hexane and toluene to that of a…

A:

Q: A mixture of two liquids with the boiling point of  65 oC and 73 oC has been subjected for…

A: Distillation is the most common technique applied to separate/ purify a mixture of two or more…

Q: You are attempting to purify a compound via recrystallization. You prepare the process through the…

A: Least solubility of the compound means that it would get precipitated in that solvent.  So we would…

Q: How can you tell that a compound is impure? (or pure?)  What are the characteristics considered…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: For this chemistry problem, I am stuck on what the reactants and products are in order to determine…

A: (a)Product A is Cu(NO3)2 and it reacts with NaOH giving Cu(OH)2. The reaction between Cu(NO3)2 and…

Q: 1. Pure compounds have higher (and sharper) melting points than compounds that contain impurities.…

A: Melting point depends on the intermolecular forces of attraction to a greater extent. Pure crystal…

Q: Filter paper is usually a poor material on which to powder a solid sample before introducing it…

A: Filter paper is not used as material on which substance can be powdered before its addition into…

Q: BRIEFLY explain why steam distillation can be used to purify or isolate temperature-sensitive…

A: A question based on analytical separation that is to be accomplished.

Q: Based on your observations during our experiment, would water make a suitable solvent for the…

A: In the water, the solubility of fluoride ion is much higher than the solubility of benzoic acid. So,…

Q: When steam distillation is not recommended? What is the theory of steam distillation technique?

A: There are various solutions which contains a lot of solvents which needs to be separated out from…

Q: Place 2.4 grams of sulfanilic monohydrate in a 125 ml Erlenmayer flask and dissolve it in 25 ml of…

A: Experiment: Place 2.4 grams of sulfanilic monohydrate in a 125 ml Erlenmayer flask and dissolve it…

Q: All are properties of ideal solvent for recrystallization except: • Dissolves the sample when hot •…

A:

Q: Prepare a Temperature vs Time cooling curve for each of the two trials involving the lauric…

A: Given data for trial 1: