Based on the frequency response, what is the magnitude of the system at 1 Hz frequency? dB Give the answer to the nearest tens. What is the gain of the system at 0.002 Hz frequency? dB Give the answer to the nearest tens. At what frequency is gain 10 dB? Hz Give the answer to one decimal place. Check

Based on the frequency response, what is the magnitude of the system at 1 Hz frequency? dB Give the answer to the nearest tens. What is the gain of the system at 0.002 Hz frequency? dB Give the answer to the nearest tens. At what frequency is gain 10 dB? Hz Give the answer to one decimal place. Check

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Pi constant to be used: 3.14159 Capillary tube: radius = 0.02 cm; length = 9 cm; pressure = 0.7 mmHg Liquid sample: density = 4 ml; time of flow = 4.5 seconds Determine (a) pressure in MKS unit, (b) pressure in CGS unit, (c) the viscosity of the liquid, (d) If the weight was given as 8.5 grams, what will be the density of the liquid? (e) the kinematic viscosity of the liquid? (f) and the fluidity of the liquid?
from Figure 1, determine the damped natural frequency (ringing frequency) of the pressure transducer. Report both the Period of oscillation and damped natural frequency in [rad/s]. Based on the response in Figure 1, is the sensor over-damped, under-damped, or critically damped? How can you tell? What is the 10% settling time of this pressure transducer?
The response of a system is given by xt=0.003cos 30t +0.004sin 30t m. Determine (a) the amplitude of motion, (b) the period of motion, (c) the frequency in Hz, (d) the frequency in rad/s, (e) the frequency in rpm, (f) the phase angle, and (g) the response in the form of xt=Asin (ωt+φ)
The image below depicts one section of a cam shaft which opens a valve to release the pressure in the combustion chamber. In order to synchronize the position of the piston and the release of the valve, there is a sensor that measures the position of the camshaft. The sensor can determine when point a is 0.672 in. to the right of the center of the camshaft and 0.672 in. above the center of the camshaft. In a four stroke engine the crank shaft, which is connected to the pistons, turns twice for every turn of the camshaft. At cruising speed the crank shaft turns at 3,000 rotations per minute (rpm) which means that the camshaft turns at 1,500 rpm or 25 revolutions per second (rps). After 0.825 seconds, where would point a be in relation to the center of the camshaft?* Answer options are: (-0.589,0),(0.116, -0.316), (0,-0.95),(0.86,-0.315),(0.431,0), none of these are correct. Please be sure to show your steps.
Parameters Mass 5kg A=2 B=7 C(m)=3 D(m)=4.583
Pressing a key on the piano you hear 440 Hz.The amplitude decays to 1/10 within 6 s.What would the frequency be like if thedamping was 1/10 within 30 s? Please explain why you used the equation you will be using
Find the Frequency Ratio, Displacement, Transmissibility Ratio, Absolute displacement of the mass, Type of Damping, and Equation of motion x(t). Assume Initial conditions for displacement and velocity. Graph 2 cycles of the vibrating system.
Based on the pic attached, If component B of #6 is changed to 3 parallel components and each has thesame reliability, what is the system reliability now? pls provide celaar solutions detailed thanks
a)If the system has a transfer function of the form G_P (s)=H(s)/(V_m (s) )=μ/(1+Ts) where µ is the gain and T is the time constant, calculate values for µ and T for the case where the valve is at position 3. Hints: Use the constants and information in table 1. The dynamics of the water tank can be found by applying the continuity equation: qin - qout = rate of change in water tank
The little brown bat is a common bat species in North America. It emits echolocation pulses at a frequency of 40 kHz, well above the range of human hearing. To allow observers to “hear” these bats, the bat detector as shown combines the bat’s sound wave at frequency f1 with a wave of frequency f2 from a tunable oscillator. The resulting beat frequency is isolated with a filter, then amplified and sent to a loudspeaker. To what frequency should the tunable oscillator be set to produce an audible beat frequency of 3 kHz?
A device with a mass of 1000 kg is placed on top of the suspension, whereby the springs are compressed into a pile a distance of 4 mm. What is the system specific angle frequency (rad / s) to one decimal place?
A kid is plating on a swing and it takes approximately 2.5 seconds to reach on side coming from the other. What is her frequency in Hz?