An electronic circuit contains a 47mH inductor and a 2.2nF capacitor. For the following questions, use 3.142 for . At what frequency does the impedance of the inductor become 9302? f = kHz Give your answer in whole kHz.

An electronic circuit contains a 47mH inductor and a 2.2nF capacitor. For the following questions, use 3.142 for . At what frequency does the impedance of the inductor become 9302? f = kHz Give your answer in whole kHz.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: Would it be b,d, and c? 2. Which of the following are characteristics of a closed loop control…

A: Given Which of the following are characteristics of a closed loop control systems....

Q: An amplifier receives 0.1 W of input signal and delivers 15 W of signal power. What is the power…

A: Given data: Amplifier receives input signal, Pin=0.1 W Amplifier delivers output signal, Pop=15 W

Q: find the result

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38. The…

A: Given data, Response of the system, YS=s2+3s+k2s3+4s2+5s, Final value of the output = 38,

Q: Ao A₁ A₂ Address decoder 0 1 2 3 4 5 6 7 0₂ АННННН 0₂ {KKKKK. 00

A: Given data: An address decoder diagram is given in which the black box of the output represents 0…

Q: a) With the aid of block diagrams, explain the FDX transmission system. b) The signal x(t) is…

A: In a one-way, linear process, a sender encrypts a message and sends it across a channel to a…

Q: Consider the series R-L circuit shown in figure below. For obtaining transient free response, switch…

Q: b- Supported by drawing (structure, carrier movement, current flow, etc.), demonstrate BJT npn)…

A: In this mode, emitter to base junction gets forward biased and collector to base junction gets…

Q: On the same fashion, describe the path followed by the value of INTERNAL SIGNAL towards P0.x (see…

A: Port 0 can be used as an input/output or a bidirectional data bus and lower order address for…

Q: 3. Obtain the closed loop transfer function of the system given below using block diagram reduction…

Q: Choose the correct option and explain each option for the below three questions. 1.The second…

A: In 1983, the first consumer mobile phone to be made available for purchase on the open market was…

Q: Do Kirchhoff’s rules apply to circuits that contain inductors and capacitors?

A: Given: Do Kirchhoff’s rules apply to circuits that contain inductors and capacitors?

Q: f transistor Q1 is a 2N2222, design the circuit to amplify 15 times a signal of ±50 mV amplitude,…

A: for the Given Fixed bias Amplifier: Given : Input Impedance = Zi = 10 Kohm = 10000 ohm = RB…

Q: Ex5: Find the current (1) using superposition.

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: A base load station having a capacity of 15 MW and a standby station having a capacity of 19 MW…

Q: Simplified output for given Boolean function. f(a, b, c, d)= Em(4, 5, 6, 7, 8, 9, 12)

A: Given Boolean function, fa,b,c,d=∑m4,5,6,7,8,9,12

Q: s²+35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38 The…

A: It is given that: Ys=s2+3s+k2s3+4s2+5s limt→∞yt=38

Q: For the voltage-divider bias circuit of Fig. 3.33, determine IRQ ICQ VCEQ Vo V₂ V 16 V D wwwww wwww…

Q: 6 Draw the Fourier transform pattern of the rectangular aperture shown in Figure 4 and justify your…

Q: Create five Kirchhoff's Current Law (KCL) problem with figure and solve it(Show complete solution)

Q: a. Find Voi=? b. If Input DC level = | Voil and R2-15002, design R1 to shift DC level from Vai to IV…

A: To simplify circuit solutions, the voltage divider rule is applied. This rule can be used to…

Q: 1. The normalized radiation intensity of an antenna is represented by U (0) = cos (0) cos² (30), (0…

A: The power emitted from an antenna per unit solid angle is used to describe radiation intensity, also…

Q: a 3-bit up-counter JK Flip flops Design using 1) Truth table to express the function of the counter…

A: The 3-bit up counter can be designed by using the three jk flipflop. The logic expression can be…

Q: The voltage across R₁ resistor in the circuit shown below is? 春 V1 10 *R1 50 R2 50

A: Given, The circuit is,

Q: Ex19; For the circuit below, determine the voltage at the (452) resistor and the power at the (802)…

Q: A diesel power station has the following data: 1000 kg = 4000 kWh = 10,000 kcal/kg = 96% = 95% Fuel…

A: We have an Diesel power station with following data, Fuel Consumption/day = 1000 Kg Units…

Q: Assuming ideal op amps, find the voltage gain vo/vi. Show all steps and assumptions clearly. τι; α…

A: Given circuit: Feedback resistance, Rf=100 kΩ Input resistance, Rin=20 kΩ

Q: 5.29 A magnetic field propagating in free space is given by H(z, t) = 20.sin(π × 108t+Bz) ax A/m…

A: It is given that: Hz,t=20.sinπ×108t+βzax Am

Q: If the resistances 10, 20, 30, 40 are parallel, th :the equivalent resistance (0)

Q: For JFET, loss = 6 mA, Vp = -4.5 V Determine (a) ID at VGS = -2 and -4 V; (b) VGs at l = 3 and 5.5…

Q: There are three input voltages: vI1=2 + 2 sin(wt) V, vI2= 0.5 sin(wt) V and vI3= -4 V. Using an…

Q: What justifies the need for plenumrated cabling above the ceiling tile?

Q: Obtain Vo in Fig. 3 using nodal analysis. 12/0° V + 203 Vol j22 m 3 42 www --j42 Fig. 3. 0.2V.

Q: Sketch the single-sided and double-sided spectra of x(t) = 3 + 4 cos(20nt +30) + 2 sin(60nt) - 4…

A: Quantity squared RMS, where quantity is the unit of the time-domain signal, is frequently used to…

Q: ■ Calculate the current Ic Ic Vs=10020° -j5 Ohm 8 Ohm j6 Ohm

A: Given circuit,

Q: A diesel engine power plant has one 600 kW and two 250 kW generating units. The fuel consumption is…

A: We have an diesel engine power plant with total of 3 units, 1 unit of 600 KW 2 unit of 250 KW Fuel…

Q: (c) A TV broadcast antenna transmits power of 3 kW at frequency of 200 MHz. The transmitter antenna…

A: Note: We are authorized to answer the first three sub-parts at a time, so we are answering the first…

Q: - Calculate the value of the current I needed to setup a flux of 0.1 mwb in the airgap. The magnetic…

A: The MMF is measured in ampere-twists and is equal to the quantity of wire turns to carry an electric…

Q: 4.1 A single core aluminium cable with a length of 120 m has a uniform diameter of 12 mm. If the…

A: The given data is, Length of cable, L=120 m. Diameter, d=12 mm. Resistivity of aluminium, ρ=0.0182…

Q: Is it option B? 1. In an open loop control system the control action is dependent upon; a) the size…

Q: Consider an RC coupled amplifier at low frequency. Internal voltage gain is -120. Find the voltage…

A: Given: Internal voltage gain is -120 Collector resistance is 1 kohm The load is 9 kilo ohm The…

Q: Ques 2. Two coils connected in parallel across a 100V DC supply, take 10 A current from the supply.…

Q: eferring to the circuit of Fig. 1, ) Determine the power absorbed by the 3.3 2 resistor; 0.1V, )…

A: Given Circuit diagram:

Q: 1.2.Given a Programmable Logical Array device in Fig. 2. A Inputs R JO Programmable AND Programmank…

Q: HT of a 1100/230 V, 3 kVA single phase transformer. And L.T. The impedances of the windings are 4.9…

A: It is given that: V1V2=1100230kVA=3 kVAZ1=r1+jx1=4.9+j8.2 ΩZ2=r2+jx2=0.19+j0.5 Ω

Q: Find the output expression. A B B

A: Given, The logic circuit is,

Q: The deflection torque on a PMMC moving system for a particular current is given as 1.8x10-4 Nm. If…

A: SOLUTION Given --> Let…

Q: 13. What is the value of reactive power, if the angle between star connected three phase 415 V a.c…

A: Given, Star connected three phase ac supply has, Line voltage, VL=415 V. Line current, IL=5.2 A.…

Q: Consider a logic function with three inputs, A, B, and C, and three outputs, D, E, and F. The…

A: It is given that: The function is defined as follows: D is true if at least one input…

Q: Q10/Chose the correct answer for the output Q3 of the following circuit ( Assume that A=…

A: Given circuit,

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Resonance and Different Parameter

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A postage stamp capacitor has the following color marks starting at the upper-left dot: black, orange, orange, black, silver, and white. What are the capacitance value and tolerance of this capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz
QUESTION 5 E-05, PC-01. Capacitor can store energy in form of? Current. Electrical charge. Power. QUESTION 6 E-06, PC-03. An Inductor's time constant is given by? LR. O L/R. L2 /R.