Air at 20oC (density = 1.204 kg/m3) flows towards a rotating cylinder of diameter 1.50 m. If the velocity of the air is 100 km/h and the cylinder rotates clockwise at 220 rpm, determine (c) the maximum velocity of the air around the rotor, and (d) the pressure coefficient at the location corresponding to the maximum velocity.

Q: Water at 65 degrees Celsius is flowing horizontally at a rate of 84.1 m^3/hr in a pipe. It enters a…

A:

Q: 1. A pipe 100 mm bore diameter carries oil of density 900 kg/m3 at a rate of 4 kg/s. The pipe…

A:

Q: 1. The water in a 6-m-diameter, 2-m-high above-ground swimming pool is to be emptied by unplugging a…

A:

Q: Consider an air solar collector that is 1 m wide and 4 m long and has a constant spacing of 3 cm…

A: The properties of air at 45 oC are given as, The hydraulic diameter is written as, The velocity of…

Q: A U-tube open at both ends is partially filled with water. Oil having a density of 750 kg/m3 is then…

A:

Q: Oil with ? = 876 kg/m3 and ? = 0.24 kg/m·s is flowing through a 1.5-cm-diameter pipe that discharges…

A: Given data Determine the flow rate of oil through the pipe if the pipe is (a) horizontal (b)…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: h1=3089 KJkgc1= 229 kmhrc1= 229×518=63.61 msech2= 2569 Jkg v2= .63 m3kgA1=.2 m2v1=.31 m3kgNow apply…

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: A 3-cm-diameter horizontal water jet with a speed of Vj = 50 m/s relative to the ground is deflected…

A:

Q: A free jet of water of velocity V strikes against a series of curved semi - circular vanes…

A: η=0.912V1=velocity of jet =VU=velocity of vane=0.6 VVr1=V-UVr1=V-0.6V=0.4VVr2=10% loss Vr1Vr=0.9…

Q: at a point upstream of the throat in a converging-diverging nozzle the velocity temperature and…

A: Given Datau1=192m/sT1=41°Ck=1.4A'=0.03m2P1=282kPa

Q: A large, enclosed (pressurized) cylindrical tank 3 meters high contains 2.8 meters of oil (s.g. =…

A:

Q: Water enters a centrifugal pump axially at atmos- pheric pressure at a rate of 0.12 m3/s and at a…

A:

Q: Explain the work of Nozzles and diffusers are shaped so that they cause large changes in fluid…

A: Nozzle and Diffuser: Nozzle is a device of decreasing cross section. Due to decrease in its area the…

Q: In a pipeline with converging diameter, will the gradient of the total energy line be steeper or…

A: In a converging pipe, the equation of continuity for incompressible flow can be written as,…

Q: Air with a velocity of 150 m/s enters a nozzle at a pressure of 200 kPa and temperature of 77 °C.…

A:

Q: Water @ 30C and 1atm is flows at a rate of 0.5 m^3/s through a horizontal junction in a pipe. The…

A: To find: The resultant force on the junction. Given: The flow rate is Q=0.5 m3sec. The internal…

Q: In a pipe conveying steady flow of incompressible fluid, what factor determines the magnitude of…

A: To find : what factor determines the magnitude of flow velocity In a pipe conveying steady flow of…

Q: Problem 4- A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81…

A: To Find :  The pressure difference in between the smaller and bigger diameter. Given :  The length…

Q: The impeller of a centrifugal blower has a radius of 18 cm and a blade width of 6.1 cm at the inlet,…

A: Write the formula for the density of air delivered at the outlet.  ρ=PRT Here, ρ is the density of…

Q: Fluid of constant density is flowing at a velocity of 0.5 meter per second into a horizontal nozzle…

A: Given Data d2=13d1V1=0.5 m/sTo findV2=?

Q: 1. A pipe 100 mm bore diameter carries oil of density 900 kg/m3 at a rate of 4 kg/s. The pipe…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: Air enters into the hollow propeller tube at A with a mass flow of 3.5 kg/s and exits at the ends B…

A:

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A:

Q: A fluid flows at 455 cubic meters per minute inside a rectangular duct, whose cross-section has a…

A:

Q: The air velocity in the duct of a heating system is to be measured by a Pitot-static probe inserted…

A: Acceleration due to gravity g=9.81 m/s height h = 0.032 m pressure, P=98 kPa air temperature, T=45°…

Q: 2 Oil flows from a tank through a 50 mm diameter pipe. If the average velocity is 1,3 m/s, determine…

A:

Q: Air is flowing through a venture-meter whose diameter is 2.6 in at the entrance part (location 1)…

A:

Q: Underground water is pumped through a 10-cm- diameter pipe that consists of a 2-m-long vertical and…

A:

Q: A fan with a flow rate of 0.34 m3/min will be used to cool a desktop computer. Calculate the mass…

A:

Q: A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81 inches as…

A:

Q: The fluid condition at the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle…

A: for solution refer below images.

Q: A 4-ft-high, 3-ft-diameter cylindrical water tank whose top is open to the atmosphere is initially…

A: Given data : The diameter of the water tank (Dtank) = 3 ft height of the water tank (ho) = 4 ft The…

Q: Orange juice is flowing through a horizontal U-type reducing bend at a rate of 36kg/s. The…

A: We have to determine the force applied to the reducing bend by the orange juice in the horizontal…

Q: The thrust developed by the engine of a Boeing 777 is about 380 kN. Assuming choked flow in the…

A: Given: The thrust developed by the engine is F=380 kN. The ambient temperature is T=215 K. The…

Q: Air flows steadily between two sections in a long straight portion of 0.2 m inside diameter pipe as…

A:

Q: The air in a 7 m x 5 m x 3.5 m hospital room is to be completely replaced by conditioned air every…

A:

Q: determine the average speed in the enlarged pipe.

A: need to determine the average speed in the enlarged pipe.

Q: When is the conservation of linear momentum often applied?

A: In physics, the term conservation refers to something which doesn't change. This means that the…

Q: Water is flowing through a 10-cm-diameter water pipe at a rate of 0.1 m3/s. Now a diffuser with an…

A:

Q: 2. A 15 mm diameter jet of water impinges normally at the centre of rectangular plate of size 100 mm…

A: Note: Since you have asked multiple question, we will solve the first question for you. If you want…

Q: Air enters a compressor at a temperature of 70•C and a pressure of 10 kPa. At the exit of the…

A:

Q: A fluid with a density of 0.8 g/cm3 is being emptied from a very large tank through a small…

A:

Q: calculate the outlet velocity (V2) of water by using continuity and Bernoulli’s equation.

A: Given: Density (ρ) =750 kg/m3 Inlet conditions: d1= 8 cm =0.08 mP1= 400 kPaOutlet condition: d2=4 cm…

Q: Air flows in a duct having cross-sectional area A = 0.861 m², flow speed V 10 meters / sec, pressure…

A:

Q: at a point upstream of the throat in a converging-diverging nozzle the velocity temperature and…

A:

Q: Which fluid at room temperature requires a larger pump to flow at a specified velocity in a given…

A: Engine oil requires a larger pump because of its much larger viscosity. The density of oil is…

Q: 1. A 2 cm diameter water jet having a velocity of 25 m/s and inclined from the horizontal at an…

A: As givcen that water jet velocity (v) = 25 m/s ,Diamter (d)= 2cm =0.02 m ,Inclination of jet with…

Q: Water at 75 degrees Celsius is flowing horizontally at a rate of 1.6 m^3/min in a pipe. It enters a…

A:

Q: Air speed in a duct is measured using a Pitot static tube where the differential pressure reading is…

A: Given:P=0.05 KPaρ=1.041 Kg/m3