Air is flowing through a venture-meter whose diameter is 2.6 in at the entrance part (location 1) and 1.8 in at the throat (location 2). The gage pressure is measured to be 12.2 psia at the entrance and 11.8 psia at the throat. Neglecting frictional effects, show that the volume flow rate can be expressed as and determine the flow rate of air. Take the air density to be 0.075 lbm/ft3.

Q: Air is flowing through a 21.79-cm diameter pipe with a velocity of 6.23 m/s. If the temperature of…

A: Given: P = 104 kPa V = 6.23 m/s d = 21.79 cm = 0.2179 m T = 21.27+273 = 294.27

Q: well water is pumped into a thank that is 25 meters high through a pipe with an inner diameter of…

A: Given data:

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: Water at 20°C is flowing through a horizontal nozzle at a flow rate of 0.005 m3/s. At the nozzle…

A:

Q: n a refinery, fuel ethanol is flowing in a pipe at a velocity of 1.2 m/s at 2 atm. The refinery…

A: Given data v1=1.2 m/sP1=2 atmP2=1 atmd1=40 cmd2=10 cm Here, v is the velocity of flow and P is the…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: 2- mass flow rate is

A: To find Enters density mass flow rate

Q: Oil with p = 865 kg/m³ and µ = 0.24 kg/m. s is flowing through a 2 cm diameter pipe that discharges…

A: Given Density = 865 kg/m3 Viscosity coefficient = 0.24 kg/ms Diameter of the pipe = 2cm = 0.02 m…

Q: air flows in a duct at the rate of 0.056 m3/s. Determine the pressure drop (kPa) between the 6 and 3…

A:

Q: A garden hose attached with a nozzle is used to fill a 20 Liters bucket. The inner diameter of the…

A:

Q: A 4 m in diameter tank open to the atmosphere is filled with water to a height of 400 cm from the…

A:

Q: the inlet and exit of a horizontal convergent nozzle is analysed. The nozzle is operating steadily…

A:

Q: Oil (SG = 0.83) flows at a rate of 200 L/s through a 500m pipe with a diameter of 200mm. The…

A:

Q: Q2) Water at 4°C enters a tank of diameter DT = 50 cm at a constant mass flow rate of min= 1 kg/s.…

A:

Q: Air flow through the pipe at a rate of 170 L/s. The pipe diameter is measured to be 20 cm at the…

A:

Q: Consider incompressible, frictionless flow of a fluid in a horizontal piping. The pressure and…

A: Given,  P1 = 150 kPa v1 = 1.25 m/s P2 = 140 kPa Density = 700kg/m3 v2 = ? By applying Bernoulli's…

Q: A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81 inches as…

A:

Q: The water level in a tank is 12 m above the ground. A hose is connected to the bottom of the tank,…

A:

Q: Water flows through a horizontal pipe at a rate of 0.01 m /s. The pipe consists of two sections of…

A:

Q: Water (modeled as an incompressible substance) flows steadily through a circular pipe of total…

A: Total length of the circular pipe, L=10 mMass flow rate through the pipe, m=2 kg/sTemperature drop…

Q: At the end of the compressor in a jet engine, a diffuser receives air through its 0.6m2 inlet at…

A:

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: Here, air (105 kPa) at 37 degrees celcius is flowing upward in a 6cm diamater inclined duct, at a…

A:

Q: 20 cm diameter pipe carries air at 24 m / s at a pressure of 148 kpa absolute pressure and 27 ° C.…

A: Given:d1=20 cmv1=24 m/sP1=148 KPaT1=27°C =300 Kd2=10 cmT2=11°C =284 KP2=130.5 KPa

Q: A fan delivers 400 m3 /min of air at 1 atm and 21 C when rotating at 600 rpm, with a head of 8 cm…

A: The volumetric flow rate of the air, V = 400 m3/min The pressure of the air, P = 1 atm The…

Q: A boy has a tank with a rectangular bottom base 40 cm by 50 cm and a height of 100 cm. The tank is…

A: Given: V=40 cm × 50 cm×100 cma = 3 mm=0.3 cmQin=0.05 L/s = 50 cm3/s To find: Depth of water in the…

Q: Air is flowing through a venturi meter whose diameter is 2.6 in at the entrance part (location 1)…

A:

Q: A tank of oxygen has a hole of area 0.5 cm2 in its wall. The temperature of the oxygen in the tank…

A:

Q: A pump has a required NPSH of 3.0 m. Assuming that the pump is elevated at 3.5 m above sea level,…

A:

Q: he cylindrical in the figure is filled with 31.4 m3 of water at t = 0. The radius of the tank is 1 m…

A: Given:Radius of tank=r=1mHeight of tank=h=10mNow,area of tank base=A=πr2=π×(1)2=πVolume of…

Q: Consider incompressible, frictionless flow of water in a vertical piping. The pressure is 260 kPa at…

A: Solution: Given Data: P1=260 kPah1=2 mh2=17 mv1=v2   To Find: The pressure at 17 m from the ground…

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of varg = 1.15 m/s.…

A:

Q: Air is flowing through a 23.36-cm diameter pipe with a velocity of 6523 m/s. If the temperature of…

A: It is very basic and conceptual numerical of thermodynamics. And used concept is mass flow rate…

Q: Water is flowing through a venturi meter whose diameter is 7 cm at the entrance part and 4 cm at the…

A:

Q: Water in a duct of area 0.1 m2 has an average velocity of 7 m/s. The duct tapers slowly to 0.4 m2.…

A: Given data: The area of the duct at section 1 is, A1 = 0.1 m2. The average velocity at section 1…

Q: A 6cm diameter horizontal water pipe expands to a 10cm diameter pipe. The average velocity and…

A: Given Data D1=6 cm D2=10 cm V1=7 m/s P1=150 kPa

Q: Water flows through a turbine as shown in figure, where the pipeline upstream of the turbine has a…

A:

Q: Determine the discharge of a flowing fluid from a nozzle, whose specific gravity is 1.3, the nozzle…

A:

Q: Air is flowing through a venturi meter whose diameter is 2.6 in at the entrance part (location 1)…

A: