The military jet aircraft has a gross weight of 28,000 lb and is poised for takeoff with brakes set while the engine isrevved up to maximum power. At this condition, air with a specific weight of 0.0753 lb/ft is sucked into the intake ductsat the rate of 112 Ib/sec with a static pressure of -0.28 Ib/in.? (gage) across the duct entrance. The total cross-sectionalarea of both intake ducts (one on each side) is 1630 in.? The air-fuel ratio is 16.2, and the exhaust velocity u is 2630ft/sec with zero back pressure (gage) across the exhaust nozzle. Compute the initial acceleration a of the aircraft uponrelease of the brakes.Answer: a =ft/sec2

Answered: The military jet aircraft

Engineering

Mechanical Engineering

The military jet aircraft

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

As shown in the figure, air with a volumetric flow rate of 15,000 ft3/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 16 ft/s. Assume steady state operation and ideal gas behavior for the air. 4- D4 = 50 in. Duct system Tz = T3 = T1 = 45°F D; = D; = 26 in. Vz = V3 Air-handling unit 1+ Pi = P2 = P3 = P4 = 1 atm T = B0°F (AV), Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s.
Part 1(a) What is the derived SI unit for energy ?(b) Determine in terms of SI base units the units associated with the followingenergy equations and hence determine what is the combination of base SIunits for energy.(i) E = mc2(ii) PE = mgh(iii) KE = 0.5mv2(c) Explain why SI prefixes are useful to the metric system. Produce a table ofthe most common prefixes used in engineering and their common notation.
Thermodynamics: Please show me how to solve the given practice problems in step by step solution.
As shown in the figure, air with a volumetric flow rate of 16,000 ft/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 16 ft/s. Assume steady state operation and ideal gas behavior for the air. 4+ Da = 50 in. Duct T2 = 73 = 1= 45°F D, - D,- 26 in. V2 = V3 system Air-handling unit 1- = P2 = P3 = p4 = 1 atm T = B0°F (AV), Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s.
• A single-stage, single-acting reciprocating air compressor takes in air at 1 bar, 27°C and delivers at 7 bar, volume of air entering the compressor is 5 m^3 /min. Air is compressed according to pV^1.3 = C. Calculate isothermal efficiency, power required to drive the compressor, neglecting clearance volume.
Which statement is fals? O In an isolated system of many particles in equilibrium a microstate with all particles having the same energy is more likely than a microstate with 1/ of the particles having the same energy and 1/2 of the particles having zero energy. When water freezes its entropy decreases. O The coefficient of performance for a heat pump is the ratio of the energy delivered at the higher temperature to the work put into the system. O The coefficient of performance for a refrigerator is the ratio of the energy removed at the lower temperature to the work put into the system. O The total entropy of a closed system is always increasing is one way of stating the second law of thermodynamics.
Explain how the energy balance for a steady flow device equation, 8qrev - SW ey = dh + dke + dpe can be expressed as the Bernoulli equation. [Note: State all the relevant assumptions]
Determine the velocity in the 50-In. duct, In ft/s. V₂ - i ft/s
What is the investigation procedure for aircraft accidents?
As shown in the figure, air with a volumetric flow rate of 17,000 ft/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 19 ft/s. Assume steady state operation and ideal gas behavior for the air. 4+D - 50 in. Duct system T2 = 73 = T, = 45°F D; = Dz = 26 in. V2 = V3 Air-handling unit 1+ Pi = P2 = P3 = P4 = 1 atm T = B0°F (AV), Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s.
As shown in the figure, air with a volumetric flow rate of 14,000 ft/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 10 ft/s. Assume steady state operation and ideal gas behavior for the air. D- 50 in. Duct system T- - 1 - 45°F D, - D,- 26 in. Vz = V3 Air-handling unit 1+ A = P=P = P4=1 atm T= B0°F (AV) Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s.
As shown in the figure, air with a volumetric flow rate of 14,000 ft³/min enters an air-handling unit at 80°F, 1 atm. The air-handling unit delivers air at 45°F, 1 atm to a duct system with three branches consisting of two 26-in.-diameter ducts and one 50-in. duct. The velocity in each 26-in. duct is 10 ft/s. Assume steady state operation and ideal gas behavior for the air. Da = 50 in. %3D Duct T2 = 13 = 1 = 45°F D; = D, = 26 in. V2 = V3 system Air-handling unit 1+ P = P2 = Pa = P4 = 1 atm T = B0°F (AV), Determine the mass flow rate of air entering the air-handling unit, in Ib/s, the volumetric flow rate in each 26-in. duct, in ft/min, and the velocity in the 50-in. duct, in ft/s. 2-