A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and takes 20 milliseconds to complete one cycle. Then find the maximum cost and the time to reach it for the first time.

Q: A Red, Voltage 21 A. Blue, Current 2mA Determine the period of the waveforms Determine the frequency…

A:

Q: The

A:

Q: Define the following: a. R.m.s value of a sinusoidal wave. b. Form factor , Peak factor. c. Power…

A:

Q: The voltage waveform during the first half cycle are from t = 0 to t = 0.01 increases linearly from…

A:

Q: A The value of: A=5 ms C= 15 ms Peak to peak = 10 B D Figure 1 (a) From Figure 1 above, identify the…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: Determine the simplified  output expression  of the logic diagram using appropriate K map.…

A: find the simplified expression of given function using K-map ?

Q: 180 V Ф - 50 ms

A:

Q: An alternating current varying sinusoidally with a frequency of 50Hz has an RMS value of 20A. a.…

A: Given, An alternating current varying sinusoidally and has, Frequency (f)= 50 Hz I(rms)= 20 A

Q: sume voltage is at its maximum when time a.) Write a sinusoidal function V(t) to model that voltage,…

A: Given data, frequency of the given alternating source, f= 60 hz the frequency in rad/sec is given as…

Q: he sinusoidal waveform 4.35 Ohm Xc-5.52 E-100V

A:

Q: Assume firing angle equal to 10 deg. and find the on-time duration (TON) for the PWM waveform when…

A:

Q: Alternating voltage and current differ from direct voltage and current because alternating voltage…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: : For the current waveform that shown in Figure belo w Find:- 1). Average value 2). R.M.S value 3).…

A:

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and…

A: time division - time/cm=0.2ms/cm voltage division volt/cm=1V/cm

Q: A sinusoidal current wave has an instantaneous value of -20 A at t = 0 and s increasing negatively.…

A:

Q: explain what sinusoidal signals are, and how they’re used in every day life.

A: sinusoidal signals are those signals which is continuous and varies with respect to the time.  It is…

Q: Average value of a sinusoidal voltage over a complete full cycle is . a. 2n V m b. (Vm) / Tt C. Zero…

A: Average value of a sinusoidal voltage is 0 as positive half and negative half cancel out each other

Q: A sinusoidal voltage has a peak value of 340 V. Calculate its mean and r.m.s. values, correct to 3…

A: Given information is shown below:

Q: peak distance of a sinusoidal waveform displayed on a 38 V/cm. The peak to peak voltage is given by…

A:

Q: Assume you are working on sinusoidal ac supply voltage which is in the form of 150 sin 220 t. So…

A: In the theory of alternating current, a sinusoidal waveform can be generated by using a single-coil…

Q: The peak to peak distance of a sinusoidal waveform displayed on a C.R.O. screen is 9 cm ane the…

A: Peak value= no. Of divisions×Volt/div. Given no. Of divisions= 9 cm. And volt/div =45V/div

Q: What is the principle of operation of an inductor and how does it behave in an AC circuit?

A: An inductor is a passive electrical component that stores energy in the form of a magnetic field. It…

Q: (5 minutes) A sine voltage signal is zero at t = 0.1s, and increasing to the succeeding zero at t =…

A: Given, Sine voltage signal with zero at t=0.1 s And increasing to the succeeding zero at t=0.3 s

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

A:

Q: A sinusoidal voltage has a peak value of 15 V, has a frequency of 125 Hz, and crosses zero with…

A:

Q: Determine and sketch the output voltage waveform for the circuit shown if the sinusoidal signal at…

A:

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL  XL=j(100)(0.01) Ω XL=j1 Ω

Q: The source in the circuit shown is a sinusoidal source. The supply voltages across various elements…

A: Given a series RLC circuit, Voltages across each elements are as, Resistance voltage, VR=3 V…

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: he direction of the oscillation of an electric field is called..................

A: Vibrations and waves are extremely important phenomena in physics. In nature, oscillations are found…

Q: iii) A sine waveform with following specifications. RMS voltage 161.4V Time for ten cycles 0.02s…

A: Given values are =

Q: b) Determine the voltage ??(??) and current ??(??) sinusoidal forms. Sketch one cycle of  the…

A: Given;I=100∠-20°mAVs=120∠30°Vf=60 HzC=35μFDetermine;voltage=?current=?sinusoidal wave form

Q: Q4/ Find the voltage average and the voltage waveform for the output of the circuit shown below.…

A: Diode conducts for negative half cycle and reverse bias for positive half cycle of input . As output…

Q: Q3]. Draw a neat sine wave with a peak amplitude 110V and time period 3 sec. For the same waveform…

A: The different formula in the case of sinusoidal waveform is used to find the required parameters.…

Q: Using a single DC power supply and 3 AC power supplies, generate the required complex waveforms A…

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.