A steam power plant operates on a Rankine cycle The steam enters the turbine at 15000 kPa and 600°C. t is condensed in the condenser at 10 kPa. The isentropic efficiencies of the pump and turbine are 95% and 94% respectively. Determine the following a Work input to the pump in (k/kg) b. Heat added in the boler in /kg) Properties: h 19183 Kg vỊ - 0.00101 mng hg 3582.3 kg, xa0.804 h 42392.k kg c Work output from turbine in (/ng) d. Thermal efficiency of the cycle (

A steam power plant operates on a Rankine cycle The steam enters the turbine at 15000 kPa and 600°C. t is condensed in the condenser at 10 kPa. The isentropic efficiencies of the pump and turbine are 95% and 94% respectively. Determine the following a Work input to the pump in (k/kg) b. Heat added in the boler in /kg) Properties: h 19183 Kg vỊ - 0.00101 mng hg 3582.3 kg, xa0.804 h 42392.k kg c Work output from turbine in (/ng) d. Thermal efficiency of the cycle (

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Refrigerant R12 is used in a vapour compression cycle. The saturated vapour entersthe compressor at -18.8°C, and subsequently leaves at 75°C and 10 bar. Thesaturated liquid leaving the condenser is at 10 bar. The resulting stream is throttledand evaporated before being fed back to the compressor. a) Determine the coefficient of performance of the refrigerator. Take the specific enthalpy,h, at 10 bar and 36 K of superheat to be 163.7 kJ/kgb) Obtain the isentropic efficiency of the compressor. Take the specific entropy, s, at 10bar to be 1.188 kJ/kg
Steam at 20 MPa and 620°C enters a steam turbine and expands to a condenser pressure of 100 kPa. An open feedwater heater is added operating at 2 MPa. Calculate the cycle thermal efficiency in %. Use the unrounded values of the work of the turbine, work of the pump, and heat added when needed.
PROBLEM 2Consider a Brayton refrigeration cycle where air enters the compressor at 100 kPa, 280Kand is compressed to 400 kPa. The temperature at the turbine inlet is 340K. Thecompressor and turbine have isentropic efficiencies of 70% and 80%, respectively.Questions:Determine:(a) The refrigeration capacity per unit of mass flowing.(b) The net work input.(c) The Coefficient of Performance.
A thermal power plant operates such that the steam exits boiler at 4 MPa, 400C and the condenser pressure is 10 kPa. The efficiency of the turbine and pump is 85% and 90% respectively. a. Draw the plant PFD (Process Flow Disgram) and the process Ts diagram and calculate quality of steam discharge from the turbine as well as the plant's thermal efficiency. b. If the plant produces 300MW of net power, - What is the steam flowrates in kg/hr? - If the plant uses natural gas as a fuel, determine the flowrate of NG in MMSCMD. State the reference for your data. - If the plant uses coal as a fuel, determine the amount of coal required (tonne per annum). State the reference for your data and all your assumptions. c. How much power required by the pump in kW? Is this the real power required by the pump? Explain d. Find the heat rejected in the condenser and evaluate the thermal efficiency using this value. e. The heat rejected to surrounding is through a cooling water system from a nearby ocean.…
Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam is extracted for feed water heating at 0.6 MPa. The turbine exhaust is 60 degree C. the required values of some state point properties are tabulated below. 9. Calculate the total pump work of the cycle
Q3) A steam power plant operates on a simple ideal Rankine cycle between the pressures limits of 8000 kPa and 10 kPa. The mass flow rate of steam through the cycle is 25 kg/s. The temperature of steam at the turbine inlet is 400 C. Show the cycle on a block diagram and on a T-S diagram with respect to saturation lines. Calculate: a- The rate of heat input in the boiler and the rate of heat output in the condenser. b-The thermal efficiency of the turbine.
i need the answer quickly
H1
Ill leave a thumbs up if you answer the following. Determine the following: a. Entropy of steam turbine at exit b. Entropy of saturated liquid at condenser temperature c. Sfg at condenser temperature
TNB steam power plant in Genting Highlandsoperates on reheat Rankine cycleand has power net output of 50MW. Steam enters the turbine at aMPa and b °Cand it is cooled in the condenser at a pressure of ckPa by running cooling water from the Bertam River through the tubesof condenser. Steam enters both stages of the turbine at b°C. If the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, show the cycle on a T-s diagram and determine;i.The pressure at which reheating takes place, ii.The thermal efficiency of the cycleandiii.Please justify how does the thermal efficiency of the cycle if the temperature to low turbine is increase to 600°C? a=12 b=500 c=12
A steam Rankine cycle operates between the pressure limits of 1500 psia in the boiler and 3 psia in the condenser. The turbine Inlet temperature is 800°F. The turbine isentropic efficiency is 90 percent, the pump losses are negligible, and the cycle is sized to produce 2500 kW of power. How much error is caused in the thermal efficiency if the power required by the pump were completely neglected? Use steam tables. The error caused in the thermal efficiency if the power required by the pump was completely neglected is 32.65 %.
A steam Rankine cycle operates between the pressure limits of 1500 psia in the boiler and 4 psia in the condenser. The turbine inlet temperature is 800°F. The turbine isentropic efficiency is 90 percent, the pump losses are negligible, and the cycle is sized to produce 2500 kW of power. How much error is caused in the thermal efficiency if the power required by the pump were completely neglected? Use steam tables. The error caused in the thermal efficiency if the power required by the pump was completely neglected is %.