A standing inspector picks up 12 lb castings (with poor coupling) from a conveyor 45 inches from the floor with a horizontal distance of 20 inches. He then puts the casting on a work area 20 inches lower than the conveyor and closer to the body (a minimum horizontal distance) for inspection. For good ones, he twists 90 degrees to the right and sets it on another conveyor 30 inches from the floor with a minimum horizontal distance. For bad ones, he twists 90 degrees to the left and sets it on a third conveyor 30 inches from the floor with a minimum horizontal distance. a. How many castings per minute can he inspect for an 8-hour shift so as to be acceptable according to NIOSH guidelines?

A standing inspector picks up 12 lb castings (with poor coupling) from a conveyor 45 inches from the floor with a horizontal distance of 20 inches. He then puts the casting on a work area 20 inches lower than the conveyor and closer to the body (a minimum horizontal distance) for inspection. For good ones, he twists 90 degrees to the right and sets it on another conveyor 30 inches from the floor with a minimum horizontal distance. For bad ones, he twists 90 degrees to the left and sets it on a third conveyor 30 inches from the floor with a minimum horizontal distance. a. How many castings per minute can he inspect for an 8-hour shift so as to be acceptable according to NIOSH guidelines?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Draw the the following views of the figure. Thank you.
when calculating the hc, why are adding the x as well ?
Question Sketch the graphe о T2 Tand т
How to draw 4/5 × 2/3 on a model
Dimensions and magnitude mean size, for example the diameter of the wheels of a mountain bike etc. Select one: True False
Given the top and front view create a section view.
y is the angle an absolute value?
5. According to the given 2 views, try to make the front full sectional view (7') and the left-side half sectional view A-A (8'). (only 2 required views) A-A | A
Below are the front and side views of the objects. Use these views to create the top view.
Compute the degree of freedom.
Orthographics: Add missing lines and complete any missing views. Draw the isometric