The front and top views are given. Use this to create the missing side view. Note the front view is missing for C as it has none of the missing lines.

Section view 1- The front and top views of an object are shown below. Freehand sketch the full section view of the front view. The cutting plane should pass through the centers of the holes in top view. Hatch the full sections view by hand. Indicate the location and the direction of the cutting plane and label the section view. Place the section view below the front view 11

FOR THE FOLLOWING FIGURES ISOMETRIC VIEW IS NEEDED  Sketch theisometric view using the below following (top front nd side) orthographic view  Note : use autocad 2017 version to sketch the following , no hand drawing  Thank you

5. According to the given 2 views, try to make the front full sectional view (7') and the left-side half sectional view A-A (8'). (only 2 required views) A-A | A

Q2. Write the full details of AutoCAD commands to create the three-dimensional solid model shown in the following figure using features technique. Make two vertical viewports to draw front view and SE-isometric? 20 TO 20 Y 10 30 25 07

Draw the orthographic projection of given object with proper dimensioning .

Sketch the orthographic projection of the given isometric sketch Front view Top view Side view No hand drawings Use CATIA V5 software to

Q4

None

(Compute) What is line OA's direction cosine angle, in degrees, from the x-axis (θx)? Note that direction cosine angles are also known as coordinate direction angles.