A square hole is made in a circular lamina, the diagonal of the square is equal to the radius of the circle as shown in below figure the shift in the centre of gravity is Or (-0.75)/(-0.5) Or(-0.25)/(-0.75) Or(-0.5)/(-0.25) Or (-0.5)/(-0.75)

A square hole is made in a circular lamina, the diagonal of the square is equal to the radius of the circle as shown in below figure the shift in the centre of gravity is Or (-0.75)/(-0.5) Or(-0.25)/(-0.75) Or(-0.5)/(-0.25) Or (-0.5)/(-0.75)

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter6: Beams And Cables

Section: Chapter Questions

Problem 6.20P: The equation of the parabolic arch is y=(36x2)/6, where x and y are measured in feet. Compute the...

See similar textbooks

Related questions

Q: Q1 The screw of the shaft straightener exerts a load of 3000Kg. The screw-type is square threaded of…

Q: 10sqrt(2) ms ². Calculate the angular acceleration, in rad/s², of the connecting bar when theta = 45…

A: Length of slider L = 2mVelocity of slider V = 10 m/sAcceleration of slider a = 10 sqrt( 2) m/s2Find…

Q: The pipe assembly is supported by three smooth journal bearings (ball bearings contained within a…

A: Consider the origin is at point A. Thus, coordinates are .Consider point of application of load as…

Q: 1. The heat equation describes the flow of thermal energy (heat) in materials. The temperature V…

Q: 3. The rigid surface shown on the left side of the figure has a vertical section and an inclined…

Q: Problem 1: Determine the internal torque in the shaft shown at A, B, and C. Show the free-body…

Q: 3.5 Consider the nonlinear equation U where u is a constant. a. Is this equation in conservative…

A: The following equation is not conservative since it includes both the variable's derivative term and…

Q: 3.6.45 (WP) Oil of specific gravity 0.83 flows in the pipe shown in Fig. P3.6.45. If viscous effects…

Q: A floor hoist supports an engine of weight WE 2.9 kN. As illustrated in the figure below, the floor…

A: The value are .The weight of the engine is The angle is

Q: linear resonant actuator used for haptic vibration cues in phones - a device that might produce the…

A: Given:To find:

Q: Problem 77. The pilot of a 90,000 lb airplane which is originally flying horizontally at a speed of…

A: Given:To find:Time average drag force, D.

Q: R A body with a weight of 5 pounds force hangs from a spring with constant 8/5 Ib/ft. The medium in…

A: The weight of body is .The spring constant is .The friction force is The initial condition are

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

Q: Calculate the resistance coefficient K for a check valve swing type placed in a 6 inch schedule 40…

Q: 3. Two masses, mA = 2.0 kg and mB = 7.0 kg, are on inclines as shown and are connected by a massless…

Q: For this question can i see the working out through linear interpolation becuase i tried it myself…

Q: Find an expression for the total differential of enthalpy as a function of P and V. a) dH ӘР ӘР ӘР =…

A: B) is the correct option.

Q: QUESTION 1 An ideal gas undergoes isentropic expansion in a turbine from 520 0C. The initial…

A: To solve this problem, we will follow a step-by-step approach:The connection between temperature…

Q: An air parcel at 950 mb has a temperature of 14°C and a mixing ratio of 8 g/kg. What is the wet-bulb…

Q: m₂g(M+m₁+m₂) 5. Considering the buggy shown below, prove that the force applied is m1 given that the…

A: Mass of blocks are m1 and m2.Mass of cart is M.To prove-

Q: Determine the enthalpy change Ah of carbon monoxide, in kJ/kg, as it is heated from 300K to 1000 K,…

A: Note: As per the policy, we can solve the first three subparts. Please resubmit the remaining part.

Q: The state of stress at point 0 in a bar subject to torsion is shown in Figure P2.23. X z ++ FIGURE…

A: For the solution refer below images.

Q: Choose only one of the maintenance tasks identified and describe what materials and tools will be…

A: To find:Choose a maintenance task, mention the tools required, safety measures to be taken and…

Q: 2) 1 kg of air undergoes a thermodynamic cycle consisting of three processes. Process 1-2: constant…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Determine the force along members GJ, CJ, CD, AH, and AB, and state if they are in Tension or…

A: Determine the force along members GJ, CJ, CD, AH, and AB, and state if they are in Tension or…

Q: Problem 2 Consider the two positions provided in the figure. (a) Using the graphical method to…

A: The problem you presented is a mechanical linkage system. Here is the step-by-step solution:Step…

Q: When pumping water (Q = 10 L/s, η = 60%, 10 kW shaft power), water temperature in pump rises…

Q: Your least favorite professor likes mountain climbing and plans to do some during Winter Break.…

A: Given:To find:When would the real professor reappear?

Q: Problem 83. The central attractive force F on an earth satellite can have no moment about the center…

Q: Statics of Rigid Bodies (Write the COMPLETE Solutions and FBDs legibly. No long explanation needed.…

A: Given :To find: A. Determine the Moment of Inertia about the Xo and Yo axis (____ x10^6 mm4B.…

Q: a) Coolant flowing through a radiator at the rate of 3 kg/s are cooled from 105 0C to 81 0C. The…

Q: An industrial company has factories and distribution centers and is considering finding a location…

A: Given:To find:Location of the third factory and total associated cost.

Q: Assume that specific heats vary with temperature. What is the power produced in kW? Round your…

Q: Given the velocity through the exhaust of the rocket is: Umax (1-7) ¹/7 U(r) = Umax (1 Umax is a…

A: The velocity through exhaust of the rocket is is constant. is the outside radius of exhaustr flow.

Q: 1) Geothermal Heat Pump: The equilibrium temperature a few meters below the ground is fairly…

A: Given:To find:(a) Final equilibrium temperature of the home.(b) Time taken to reach equilibrium…

Q: An ideal turbojet ingests 192 lbm/s of air at an altitude of 22,000 ft. It fliesat a Mach number of…

A: Mass flow rate of air= 192 lbm/sAltitude = 20,000 ftMach No= 0.88Compressor pressure ratio = 17the…

Q: Using the method of equations, determine the reactions, normal force, shear, moment and elastic…

A: In this, the downward R is for AB section and upward R is for BCD section.

Q: A 15-meter long beam-tank assembly supports the loading shown in addition to its weight, which is a…

A: The outer diameter of cylinder is .The inner diameter of cylinder is .

Q: 2.25 At a point in a structural member, the principal stresses are 100, 150, and -200 MPa. If the…

A: Given-A plane whose normal makes 45 with the z-axis and the projec- tion of the normal on the…

Q: This is wrong

A: Given data:For air standard diesel cycle, we haveCompression ratio = r = 16Cut off ratio = At the…

Q: En=-A/r+ B/r^n. A= 4.0 eV*nm, B= 5*10^-6 eV*nm^8, n=8. what is the r value?

A: Ans Given Now Now to find equilibrium interonic spacing where is the equilibrium interonic…

Q: A precast concrete wall section is temporarily held by two cables as shown. Knowing that t cable BD…

A: Find the position coordinates for the points B and DThe position vector of BDThe position vector…

Q: 7) Silver nanoparticles are embedded in clothing fabric to kill odor-causing bacteria. Silver…

A: Given:To find:

Q: 4-85. Two couples act on the frame. If the resultant couple moment is to be zero, determine the…

Q: can you resolve

A: Angular acceleration of link 2 (w)= 100 rad/sAngle to determine: the acceleration of point C

Q: 3. In the mechanism shown collar B slides with a constant speed up = 1 ft/sec to the right on the…

A: The dimension are The velocity of point B is constant

Q: One end of a piano wire is wrapped around a cylindrical tuning peg and the other end is fixed in…

Q: Okay I did everything you did but the only thing I didn't do was take away 10 degrees from my…

Q: Suppose that L= 8 in.in. Locate the centroid ( x- , y-) of the shaded area Express your answers…

A: For the solution refer below images.

Q: 7 At Find the expression for. dh at Of 2 Compute att if D₁ = 1. in dh T=2=C D₂ = 3 in V₁ = 3 ft/…

A: Given:To find:Find an expression for the change in water height.

Question

A square hole is made in a circular lamina, the diagonal of the square is equal to the radius of the circle as shown in below figure the shift in the
centre of gravity is
Or (-0.75)/(-0.5)
r (-0.25)/(-0.75)
Or (-0.5)/(-0.25)
r(-0.5)/(-0.75)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given data

VIEW

Step 2: Calculate the center of gravity

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

If the intensity of the line loading is w=[(40xx2)/40]lb/in., where x is measured in inches, use integration to find the resultant.
The length of the ship’s water-plane area is 70 m. The lengths of the equidistantly spaced half ordinates commencing from forward are as follows: 0, 5.2, 6.4, 7.0, 6.0, 4.9, 0.3. Find the area of the water-plane.
FeD Fic (10+A)m 10 m 4 m Im (30+B -5 m 1.5 m Two tractors pull the tree as shown by tying the rope behind the tractor and the rope behind the tractor C at 1.5 m above the ground D at 1 m above the ground. Find an angle O made between the two ropes A = 4 %3D The angle between the two ropes (Theta) is equal to (Degree).
Find the angle between the two given vectors. u = (1, -4, 1), v = (0, 2, –2) %3D Write your answer in degree measure (no need to use the degree symbol), e.g. 45
Three forces intersect at point (1, 1, 1). Their magnitude and respective second point of incidence are as follows: 450 lbs (4, -3, 7), 600lbs (-1, 5, -4), 300lbs (-3, 6, -2) 1. Compute the direction cosine on the x-axis. a. 0.394 b. 0.124 c. 0.762 d. 0. 513 2. Compute the direction cosine on the y-axis. a. 0.394 b. 0.124 c. 0.762 d. 0. 513 3. Compute the direction cosine on the x-axis. a. 0.394 b. 0.124 c. 0.762 d. 0. 513
. For the shaded area given in the figure compute for the x and y coordinates of the +1+1---2– entroid in meters.
The rectangular lamina with breadth = 40 mm, depth = 60 mm. The Ixx value is mm4 Select one: O 10.66 x 104 O 24 x 104 O 72 x 104 O 32 x 104 Friction force always acts in a direction to the direction of motion. Select one: O inear O normal O opposite O perpendicular
Point A is 40 mm above HP & 25 mm in front of VP. Draw Projections.
Show complete solution. Draw also the FBD
1 - Obtain the center of gravity of the surface area of the plane plate of constant thickness in the given set (x,y). Dimensions where a = 13 m, b = 17 m and r = 1 m, the center of the circle is at the point (2a, 1/2 b). In which of the following options are the coordinates of the center of gravity of the plate on the x and y axis correct?A) (19.94 ; 10.87)B) (17.14 ; 10.37)C) (19.94 ; 13.34)D) (19.05 ; 13.34)E) (19.05 ; 10.37)
Shown to the right is a vented tank filled to the top with ethylene glycol. The tank has a breadth (depth into your paper) of 8 ft. Note the curved surface is NOT a full quarter circle, it is a pie segment. Use the link to Efunda.com on the course home page in Angel to find the geometric properties of a pie segment. a. Determine the magnitude of the horizontal and vertical components of force acting on the curved surface. Determine the location of the center of pressure. 10' Ethylene 35⁰ 10'
Q2 \ What is the moment with respect to point O? All dimensions are in meters.