b. Q =-3KVAR ,P = 5kW %3D Determine the Complex Power, Apparent Power, Current, Voltage and Power factor and state if it is lagging or leading. Draw the current and voltage phasor diagram and the power triangle.

b. Q =-3KVAR ,P = 5kW %3D Determine the Complex Power, Apparent Power, Current, Voltage and Power factor and state if it is lagging or leading. Draw the current and voltage phasor diagram and the power triangle.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Evaluate the following integrals: S cos(TT)8(T – 3)dt L 8(T – 1)8(t –T – – 2)dr J-o N+2°(S2+3)d 00 j...

Q: Five capacitors, C1 = 3 pF, C2 = 7 pF, C3 = 2 pF, C4 = 4 pF, and C5 = 12 pF, are connected as shown ...

Q: Q3/ The following data was obtained from an investigation into the voltage /current characteristic o...

Q: Label each section from (A) to (E) in the blocks and explain its operation. Explain the function of ...

Q: Draw and explain the block diagram of the temperature measurement system using RTD.

A: RTD- RTD is the acronym for Resistance Temperature Detector. It has a positive value of temperature ...

Q: Answer the following two branches. a) Subtract the hexadecimal numbers 73F – BC. b) Express the numb...

Q: 5. a. Convert the following expressions into a sum-of-products (SOP) form: (A +B)(C+B) (A +BC)C b. C...

Q: b) Solve for VL using Norton equivalent theorem. 4 Ohm 12 Ohm 20 V VL 12 Ohm 30 V

A: Given

Q: There are four networks in series, the first network has a gain of 15dB, the second has a loss of 4d...

Q: Find I, in circuit (a) and l2 in circuit (b) 12 mA 10 mA 4 mA 3 mA 12 4 mA (a) (b)

A: a) Given circuit,

Q: Use block diagram to determine the sum generated by 5-bit parallel adder and show on the diagram the...

A: Use block diagram to determine the sum generated by 5-bit parallel adder and show on the diagram the...

Q: Prob.7. An A.C. bridge is balanced at 2 kHz with the following сотpoпеnts in each arm - Arm AB = 10 ...

Q: A thyristor controlled Full Wave rectifier outputs 400 Vdc when fired at an angle 0 deg. Find the an...

A: To solve above problem, one should know what rectifier circuit is and how it works. To charge a batt...

Q: Discuss / Explain the operational process and show flow diagram including major equipment of a solar...

A: Solar power, wind power, Hydro power and Biogas power all are the example of renewable sources of en...

Q: Q (3): A coaxial cable having an inner radius of 1 mm and an outer radius of 2 mm. The space between...

Q: Two 115-V incandescent lamps A and B are connected in series across a 230 V source. If lamp A is ra...

A: According to question diagram will be,

Q: Simplify the following expression (i) A. B + A. B (ii) (A + A)

A: i) Given expression: A.B+A.B¯

Q: 2. The manufacturer of a 9[V] flashlight battery says that the battery will deliver 20[mA] for 80 co...

Q: Three loads are connected in parallel across a 250Vrms line. Load 1 absorbs 16kW and +18KVAR. Load 2...

Q: 1.a. A fiber optic cable has a minimum bend radius of 8 cm and will be mounted in an expansion loop ...

Q: A certain communication system is composed of 16 different symbols or messages. The probability of e...

A: According to the question, the probability of he 16- different messages are given as M1– 1/128 M...

Q: Which one of the following is not a subsystem of solar energy plant? O a. Power generation from wate...

A: Solar energy- The energy regarding the solar power is known as solar energy.

Q: Use Karnaugh map method to implement the minimum SOP expression for the following logic function. X=...

Q: (d) Determine the current gain Ais=lo/ls. (e) Determine the voltage gai Avs=Vo/Vs. (f) Determine Vo ...

Q: In your own words(not googled) please answer and help me understand the following a. What is a LED?...

A: Brief description: Here in the above question they are discussing about the semiconductor devices s...

Q: (c) Determine Vx. [Tentukan V,.] (d) Determine the total power absorbed by the circuit. [Tentukan ju...

A: In this question, Part 1c , find the voltage Vx as. Shown in the circuit. We are solving this ques...

Q: Q5 / Find the current in the 20 resistance of the network shown in fig.(5) 2V 4V T 3 12V lovT Les

A: A mesh is defined at a loop which does not contain any other loops within it. To app...

Q: For a three-stage system with an input power Pin= -10dBm and power gains of the three stages as Ap1=...

Q: In a CB configuration circuit , the transistor V-I output characteristic drawn by taking VCB vs. IC ...

Q: 2cos(2710t)+3cos(2.730t). We wish to transmit this signal The signal m(t) using VSB with carrier c(t...

A: The message signal is,m(t)=2cos2π10t+3cos2π30tThe carrier signal is,c(t)=5cos2π500t The VSB filter r...

Q: 1. Enumerate the circuiting guidelines. 2. Enumerate good practices in círcuiting. 3. How to prevent...

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are...

Q: 3) Design and develop an equivalent circuit for a transformer in which the reistance and leakage rea...

A: FIND: develop an equivalent circuit for a transformer

Q: charge distribution with spherical symmetry has density p pala C/m' in KrKa and p-0 for ra, determin...

Q: Q4:A. Design common-base configuration circuit. IE= 1.3 mA and Av= 250.

A: The Common Base Amplifier is a bipolar junction transistor (BJT) architecture with a common base ter...

Q: A.An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When a current of 0.5...

A: In this question , we will find inductance of iron core coil with given length , area , permeabilit...

Q: A magnetic coil produces 100,000 maxwells with 2,000 turns and with a current of 2 amperes. The curr...

Q: Draw the circuit for the following output. Show your complete analysis. v. = +E, v. = -E2-

Q: ANALYZE CAREPULLY SOLVE EACH GINEN PROBLEMS . I. FOR THE GIVEN CKT., USE ALL NETWORK ANALYSIS TO SOŁ...

Q: Electrical Power. Create ten electrical energy questions and answer it.

A: Electrical power- Electrical Power is define as the rate of electrical energy transmit through an el...

Q: find the pou wer suppliek by R YMA current SGurce R R (YMA) R=12 le

Q: 12.41 Find f(t) for each of the following functions. 280 a) F(s) = s2 + 14s + 245 -s2 + 52s + 445 b)...

A: Since you have asked multiple questions in a single request, we will be answering only the first thr...

Q: 8 GHz police Radar measures a Doppler frequency of 1788Hz from a car approaching in stationary polic...

A: Here, we have given Doppler frequency from a car. The speed limit is 80 km/h. Typically, the speed o...

Q: For a 220V, 60Hz single phase voltage controller is used for controlling flow of power in to a circu...

A: Given: A 220V, 60Hz single phase voltage controller. Load XL=12 Ω and R=5 Ω

Q: Consider the following block diagram: U(s) 2 Y) K s²(s + 1)(s + 2) 1. Find the closed-loop transfer ...

A: Given circuit,

Q: The semiconductors is a materials whose conductivity and resistivity is more than conductors and ins...

A: False Option A

Q: Identify the different farming activities that use electricity. Discuss the impact of using electric...

A: Electricity become essential for agriculture because it increases efficiency of a farmer. Without el...

Q: Question 4-) The linear electron-concentration profile shown in the figure below has been establishe...

A: GIVEN: n0=1017/cm3W=4μmDn=35cm2/s diffusion current=1mA FIND: (A) Current ...

Q: A coil has X, = 1000 Q and 5 N internal resistance. Its Q is equal to ?

A: The quality factor of an inductive coil is given by : Q = XL/R

Q: 10. The terminal voltage ve(t), and the terminal current is(t), for the device shown in Figure P1.4a...

A: We have given the following problem

Q: Consider a unity feedback system with forward path transfer function: 360 360 G(s) = (s + 3)(s + 6)(...

A: Brief description: State space representation is not unique depending upon the requirement we can r...

Concept explainers

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).

Question

b. Q = -3KVAR ,P = 5kW
Determine the Complex Power, Apparent Power, Current, Voltage and Power factor and
state if it is lagging or leading.
Draw the current and voltage phasor diagram and the power triangle.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the average Power at maximum resistance? Why? What is the effect to the voltage and current when increasing the load resistance?
3-9 An rms ac voltmeter and a peak-to-peak-reading ac voltmeter are to be used to determine whether three ac signals are sinusoidal. Deter. mine whether the signals are sinusoidal if the following readings are obtained First signal Second signal Third signal peak-to-peak reading = 35.26 V rms reading. - 12.00 V peak-to-peak reading - 11.31 V rms reading = 4.00 V peak-to-peak reading = 25.00 V rms reading -8.83 V
1 Calculate average and RMS value of the voltage waveform given in Figure. 4V %3D t(ms)- 4V
Draw the waveform of voltage and current under the following conditions: A current which lags the voltage by 60°. A current which leads the voltage by 60°. A current which is in phase with the voltage
What is the rms value of V0 voltage?
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Draw the phasor diagram. Find magnitudes and positions of all the quantities. Please show complete solution and round off answers up to the 3rd decimal place. Thank you!
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS NEEDED. ANSWER IN 2 DECIMAL PLACES. BOX THE FINAL ANSWER.) A current of (120-j150) A flows through a circuit when applied voltage is (8 + j12) V. A. What is the magnitude of the circuit impedance: a. 0.0635 ohm b. 0.0256 ohm c. 1.52 ohm d. 1.325 ohm B. What is the reactive power? a. 825.75 VAR b. 525.68 VAR c. 639.75 VAR d. 438.72 VAR
Another name for reactive power is?
Determine the rms current I as shown in figure 3. Source voltage is already in RMS value(Answer must be in polar formand should be in 4 decimal places).