I need an answer in 15 minutes University of AnbarCallege of EngineeringCivil Engineering Departm entIraq Ram adiExample 3A sample of saturated soil with o = 14 % and Gs = 2.7.Find void ratio, total unit weight, and dry unit weight

1)Water content: weight of water/weight of soil solids 2)Specific gravity: Density of fluid/Density…

Answered: A sample of saturated soil with o = 14…

Engineering

Civil Engineering

A sample of saturated soil with o = 14 % and Gs = 2.7. %3D Find void ratio, total unit weight, and dry unit weight

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter3: Weight–volume Relationships

Section: Chapter Questions

Problem 3.5P

See similar textbooks

Related questions

Q: Three samples of loose sand were tested under consolidated undrained (CU) conditions. The failure…

Q: A CLAY SAMPLE HAS UNIT WEIGH OF 20.06KN/m3 WITH MOISTURE CONTENT OF 8.2%. THE SATURATED UNIT WEIGHT…

Q: Assume that the compressible soil shown in Figure 1 consists of a clay layer 10 ft thick. A…

A: Initial void ratio (eo) = 1.10Saturated Densityνsat = 115 lb/ft2Existing over burden pressure(po) =…

Q: The void ratio of a 10 mm thick soil sample is 1.8. What would its new thickness be if its void…

Q: 8. For a normally consolidated clay specimen, the results of a drained triaxial test are as follows:…

A: Given data: The total axial stress at failure will be major principal stress at failure and is…

Q: The compression curve (void ratio, e vs. effective stress, o) for a certain clayey soil is a…

Q: A sample of saturated sand has a dry unit weight of 18 kN/m3 and a specific gravity of 2.7. If…

Q: A clay stratum Sm thick has initial void ratio of 1.50 and effective overburden pressure of 120…

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

Q: For normal stress of 142kPa, the value of void ratio is 0.6. Determine the amount of normal stress…

Q: A site associated with an excavation project is underlain by a 6m thick sand layer with unit weights…

A: Time factor T is calculated as ; T = Cv td2 where ; Cv = Coefficient of consolidation = 0.018 m2…

Q: An undisturbed soil sample, 2 cm thick undergoes a change in thickness of 0.2 mm when subjected to a…

Q: A consolidated drained triaxial test was conducted on a normally consolidated clay. Following are…

Q: SIT S. The results of two-drained tri-axial tests on a saturated clay are recorded as follows:…

Q: An undisturbed sample of clay has a wet mass of 30 kg, a dry mas of 25 kg, and a total volume of…

A: Given: Wet mass of clay = 30 kg Dry mass of clay = 25 kg Total volume = 0.014 m3 Specific gravity =…

Q: A soil sample has a bulk unit weight of 9.62kN/m^3 and a dry unit weight of 17.66 kN/m^ 3 .Given…

Q: A normally consolidated clay sample is subjected to a tri-axial test where pore water measurements…

A: We have to find the value of pore water pressure u in kpa.

Q: Three samples of loose sand were tested under consolidated undrained (CU) conditions. The failure…

A: Given Cell Pressure = 218 kPa Deviator Stress = 130 kPa Pore Water Pressure = 97 kPa

Q: During a consolidation test, a sample of fully saturated clay 3 cm thick is consolidated under a…

A: Given: The initial thickness of clay sample is 3 cm. The applied pressure is 4500 lb/ft2. The…

Q: For normal stress of 150kPa, the value of void ratio is 0.5. Determine the amount of normal stress…

A: Given: First Normal stress, σ1 = 150 kPa First Void ratio, e1 = 0.5 Second Void ratio, e2 = 0.45…

Q: A compacted earth fill is constructed on a soft, saturated clay (figure below). The fill was…

A: For different structural designing undertakings like street work, water system waterway project,…

Q: ) A clay stratum 5 m thick has the initial void ration of 1.50 and an effective overburden pressure…

Q: A consolidated-undrained test on a normally consolidate clay yield the following results: Confining…

Q: an initial void ratio of 1.11. It is compressed and the void ratio changed to 0.82. Determine

Q: an undisturbed 1200 cm^3 sample of sand weighs 19.5 N when dry. The void ratios at the maximum and…

Q: a soil sample has a porosity of 39.8% and a specific gravity of 2.75. a) calculate the void ratio.…

A: Given data: n=39.8% n=0.398 Gs =2.75

Q: Situation: The results of a consolidated drained triaxial shear test conducted on a consolidated…

Q: A saturated undisturbed sample from clay strata has moisture content of 22.22% and specific weight…

Q: The dry unit weight of a soil sample is 14.8 kN/m3. Given that Gs = 2.72 and w=17%, determine: a.…

A: Introduction : In this question we are provided with value of specific gravity , water content , dry…

Q: The unit weight of a compacted sand backfill was determined by field measurement to be 1738 kg/m3.…

Q: A clay stratum 5m thick has the initial voids ratio of 1.50 and the effective overburden pressure of…

A: co-efficient of volume compressibility is the volume decrease of a unit volume of soil per unit…

Q: soil

Q: A A soil sample has a void ratio of 0.81, degree of saturation of 84 % and specific gravity of 2.71.…

Q: A soil specimen has a volume of 0.05 m³ and a mass of 87.5 kg. Given: w=15%, G,= 2.68. Determine a.…

A: It is asked to find void ratio.

Q: A soil sample has a compression index of 0.3. If the void ratio e at a stress of 2940 lb/ft2 is 0.5,…

A: Solved

Q: A layered soil is shown with the corresponding values of K1, K2 and K3. Compute the ratio of the…

A: We know kV=H1+H2+H3H1k1+H2k2+H3k3kV=3+4+532×10-4+43.2×10-2+54.1×10-4kv=4.3923×10-4cms

Q: * in the Standard Proctor Test, the number of soil layers equals to 3 O 5 O 6 O 2 O 8 O

Q: A dry sand sample of (1350 gm) was subjected to compression stress (198.6 kPa) of (0.9 kN) force. If…

Q: For a normally consolidated clay specimen, the results of a drained triaxial test are as follows: •…

A: Given ,Chamber confining pressure = 125kN/m2Deviatpr stress at failure = 175 kN/m2σ'3 = 125…

Q: Use 10 kN/m³ for the unit weight of water. Question 10 A site associated with an excavation project…

A: Stress at middle of clay layer is given by ; σ'o = γsat - γwSand×6 + γsat - γwclay×3 σ'o = 20 -10×6…

Q: 2. The results of a consolidated-drained triaxial test conducted on a normally consolidated clay are…

Q: The following data are obtained for a soil specimen: Mt=221gm, Ms=128gm, Gs=2.70 and S=75%. Find the…

A: Given: The total mass of the soil (Mt) is 221 gm. The mass of the dry soil (Ms) is 128 gm. The…

Q: An undisturbed soil sample, 2 cm thick undergoes a change in thickness of 0.2 mm when subjected to a…

Q: The normal stress of a soil sample is165 kPa at void ratio of 0.66. If the compression index of the…

A: Given: First normal stress, σ1 = 165 kPa First void ratio, e1 = 0.66 Second void ratio, e2 = 0.56…

Q: 2. A soil sample has a unit weight of 16 kN/m^3 and a saturation of 40%. When the saturation is…

A: Given data in question Unit weight is 16 kN/m3 when S = 40% Unit weight is 120 kN/m3 when S = 90%…

Q: A soil excavated from a borrow pit has an in-situ dry unit weight of 18.59 kN/m3. In the laboratory,…

Q: Q2: A soil specimen has a volume of 0.1 m³ and a mass of 100 kg. If the water content is 20% and…

Concept explainers

Pressure and Stress

Question

I need an answer in 15 minutes

University of Anbar
Callege of Engineering
Civil Engineering Departm ent
Iraq Ram adi
Example 3
A sample of saturated soil with o = 14 % and Gs = 2.7.
Find void ratio, total unit weight, and dry unit weight

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Terms used

VIEW

Given

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

a. Write down the four Factors that effects the Behavior of Soil. b. A soil specimen with volume of 0.60x10-4 m3 , weighs 0.105 kg. Its dry weight is 0.0802 kg, and Gs is 2.65. Compute • Water content m, % • Void ratio e and porosity n • Degree of saturation Sr, % Kindly answer this question as soon as possible.
Ciectical Cnyineers GToup as Cv= 40.32% The following data represent the results obtained from the specific gravity (S.G.) test performed ina soil laboratory including * ?for sand samples. Find the mode Number of Specific Gravity 2.30-2.39 Samples 2.40-2.49 4 2.50-2.59 6. 12 2.60-2.69 2.70-2.79 14 2.80-2.89 3.35-3.40 2.10-2.15 2.20-2.25 2.70-2.75 2.80-2.85 2.30-2.35 2,60-2.65 2.40-2,45 2.50-2.55 2.90-2.95 ارفع اجابتك بشكل ملف wdf او صورة 1O 0O O O O O O
A cylindrical soil sample prepared for laboratory testing has a diameter of 71 mm, aheight of 142 mm, and weighs 10.675 x10^-3 kN. If the degree of saturation is 93%and the specific gravity of soil solids is 2.71, determine the void ratio,and water content. Please this asap. For upvote. Thanks
Given: wet soil sample weight 45.6 lbs volume of soil before drying 0.40 cubic ft dry sample wt. 37.8 lbs specific gravity of solids 2.65 MUST include a Phase Diagram - draw & label. Find 1 2 3 545 water content unit weight of moist soil void ratio (hint, need Vw and Vs) porosity degree of saturation
The following data were obtained by conducting liquid limit and plastic limit tests on a soil collected from the site. Liquid limit tests: Plastic limit test: PL = 19.3% a. Draw the flow curve and determine the liquid limit. b. Using the Casagrande plasticity chart (Figure 4.21), determine the soil type.
B. ( A Soil Specimen has the following characteristics: % passing No.4 sieve = 85 % passing No.200 sieve = 11 D60 = 2 mm D30 = 0.35 mm D10 = 70 μm L.L = 36% P.L = 31% D8 = 2 μm 1. Classify the specimen according to the Unified Soil Classification System (USCS). Assign the group name and the group symbol. 2. Determine the soil activity. 3. Determine the soil Liquidity index and consistency index if we = 26%. J
Determine the liquid limit of a soil given the result of a liquid limit test below: # of blovs (water content%) --> 48 (32.1%), 38(35.9%), 29(40.7%), 20(46.1%) and 14(52.8%) *
5.5 The modified Proctor test (ASTM D 698, method C) was performed for a soil with G, = 2.70, and the results are as follows: Moist Weight Content, % in Mold, gf Water 6.5 3250 9.3 3826 12.6 4293 14.9 4362 17.2 4035 18.6 3685 (a) Plot the Ya versus w relation. (b) Determine Ya,max and wopt- (c) Calculate S and e at the maximum dry unit weight point.
1. A sample of saturated clay was placed in a container and weighed. The weight was 6 N. The clay withcontainer was oven dried for 24 hours at 105C and weighed again as 5N. if the weight of the containeris 1 N, and specific gravity of soil solids is 2.70, determine the a) water content b) void ratio c) bulk unitweight d) dry unit weight, e) saturated unit weight f) submerged unit weight. This is the question of Soil Mechanics.
5.5 The modified Proctor test (ASTM D 698, method C) was performed for a soil with G, = 2.70, and the results are as follows: Moist Weight in Mold, gf Water Content, % 6.5 3250 9.3 3826 12.6 4293 14.9 4362 17.2 4035 18.6 3685 (a) Plot the Ya versus w relation. (b) Determine Ya,max and wopt- (c) Calculate S and e at the maximum dry unit weight point. (d) What is Y, at Wopt? What is the range of water content if the relative compaction (R.C.) is required to be 95% of the modified Proctor Ya.max?