A resistor of 6 ohms and an unknown impedance coil in series draws 12A from a 120V, 60 HZ line. if the real power taken from the line is 1,152W. What is the coil impedance?

Q: 18. A MOSFET differs from a JFET mainly because (a) of the power rating (b) the MOSFET has two gates…

A: 18) C 19) A 20) B 21) A 22) A 23) B 24) C 25) C

Q: For the given circuit below, if the diode is ideal.compute for the voltage across the load…

A: We need to find out voltage across diode for given circuit

Q: A device that reduces input power. a.Inverter b.Attenuator c.Amplifier d.Rectifier

A: Inverter is use to convert DC into AC. As we know DC can be stored. There are different types of…

Q: A series circuit consists of a reactor of 0.1 henry inductance and 5 ohms resistance and a capacitor…

A: In this question,   We need to determine the resonance frequency and percentage change in the…

Q: Part 1:- SYNCHRONOUS GENERATOR 1. List the types of synchronous generators. 2. Explain the working…

A:

Q: Amplification in the ac domain cannot be obtained without the application of dc biasing level.…

A: Answer:C.True

Q: Use the superposition theorem the 40 resistor of the circuit shown. , find the current in 202 SO V…

A:

Q: The distinction between an insulator and a conductor can be explained in terms of a semiconductor,…

A: An insulator is a material that does not conduct electricity. A conductor is a material that does…

Q: 13.) Calculate the inductance or capacitance in series for the impedance 7.5z-53.13° ohms. Assume…

A:

Q: Summarize the differences between passive filter and active filter in terms of gain, cost and…

A: You have asked multiple independent questions. We are authorized to answer one question at a time.…

Q: Convolution has the following propertises V communtative distributive V associative V time-shift

A: In this question we need to choose a correct option

Q: Q3) Use Karnaugh map to minimize the following expression to minimum SOP form. ABCD + ACD + BCD +…

A:

Q: random variables with the following PMFs: PX(k) = ⎧⎪⎪⎪⎪⎪⎪⎪⎪⎪⎪ ⎨ ⎪⎪⎪⎪⎪⎪⎪⎪⎪⎪⎩ for k = 1 for k = 2 for…

A:

Q: In a CE configuration, the voltage gain is __________ . a.always positive b.negative c.almost zero…

A: In this question,   We need to choose the correct options   In a CE configuration, the voltage gain…

Q: The bridge circuit as shown in Fig. 1 is balanced when R1= 1502, R2= 200N, R3= 3002. The bridge is…

A: The solution is given below

Q: A d.c. series motor draws 25 A from a 260 V line while running at 900 rpm. It has an armature…

A: In this question we need to find a value of the diverter resistance Rd .

Q: Calculate the induced

A:

Q: Draw the equivalent circuit if you are going to perform Short cuit Test(SCT)(at terminals a-b, with…

A:

Q: Find the final value of y(t), where Y(s)=6(s+4)/(s³+s2+2s)

A:

Q: Q/ Name a Schottky diode that operates at small frequencies

A: In this question we will write Schottky diode which operate at small frequencies...

Q: Given the main frequency of the wideband channel to be 250MHZ with a bandwidth of 200MHZ, what will…

A: Given,For a wideband channel,The main frequency is,f=250 MHzThe bandwidth of the channel is,BW=200…

Q: 2.) Two sinusoidal currents are given by, i1 = 20 sin (w t + Tt/4) and i2 = 25 sin (w t + Tt/5). %3D…

A:

Q: Astable multivibrator was designed using a 555 timer. The periodic time of the output signal should…

A:

Q: (c) Sketch a circuit diagram of a complete power conversion circuit that would be used to connect a…

A: Types of stages for feeding PV Power to Grid Single stage control ( Inverter is used to convert DC…

Q: Question 9 Comstruet a NOR-gate circuit, similar to the figure below, which implements a…

A: A D flip-flop is a single input flip flop the output depends on the clock pulse if the clock pulse…

Q: A 300-watt, 220-volt lamp and a inductance of 100 mH are connected in parallel. If a 220-volt, 60 Hz…

A: Given that; Voltage Supply=220voltsfrequency f=60 Hzinductance L=100 mHFor lamp P=300 wattV=220…

Q: carrier signal is c(t) = 4cos(10000tt). Determine the modulating signal m(t).

A:

Q: Fill in the correct Q values for the following T Flip-Flop exoitation table: Q' 1. 1. 1. 1.

A:

Q: A continuous-time signal is composed of in-phase sinusoids with periods of 0.8 ms, 1 ms, and 1.2 ms.…

A: The solution is given below

Q: In your own words, differentiate a series circuit from a parallel circuit. Provide examples and…

A:

Q: roll two dice and observe two numbers X and Y . If Z = X − Y , find the range and PMF of Z.

A:

Q: 8. In a certain FET circuit, VGs = 0 V, VDD = 15 V, Ipss = 15 mA, and Rp = 470 N. If Rp is decreased…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost the other…

Q: Q2: Determine the particular solution of the difference equation y(n) = y(n – 1) -y(n – 2) + x(n)…

A:

Q: Using the measured values, calculate the following: - a. power supplied by the power supply, Pin b.…

A: Power is the time rate of change of energy. Its SI unit is watt. It is the product of voltage and…

Q: Vcc = 16 V 3.9 k2 39 kM 1 µF 1 µF B = 100 ,=50 kQ %3D 4.7 k2 (1.2 k2 10 μF

A: We need to find out voltage gain for given circuit

Q: A discrete-time signal x(n) is shown in Fig. P2.2. Sketch and label carefully each of the following…

A:

Q: The image shows a coaxial cable (two nested cylinders) of length l, inner radius a and outer radius…

A: given charge on inner cylinder = + Q charge on outer cylinder = - Q To find, Poynting vector S in…

Q: Using τ from above and the value of the resistor, calculate the value of the inductance L. Consider…

A: The solution is given below

Q: and aerodynamic friction, but mostly from the back emf of the DC drive motor. The equations of…

A:

Q: 2) The amplitude of the emf in the below circuit is 150V, while the angular frequency is 60x. The…

A:

Q: In a CE configuration, the output voltage is __________ with the input voltage. a.out-of-phase by…

A:

Q: Draw the Thevenin and Norton equivalent circuits and reconnect the load resistor R1. 2i, I 500Ω )…

A: We need to find out thevenin equivalent circuit across point a and b.

Q: In the circuit shown, 3Ω b а 7 V 2 V|+ 5Ω h 6 V+ |4 V + f e Determine Vhe-

A:

Q: 2.)For the p-type semiconductor doped with Na = 101°cm-3 at T = 300K, no light was applied before t…

A:

Q: Determine the gain (Av) Vcc = 12 V Rc = 1 kQ +Vcc R1 = 33 KQ R2 = 6.8 KQ Rc Ca R RE1 = 300 Q RE2 =…

A:

Q: o+15 V 18 kn. Ip = 3 mA VaSOFF = -4 V 1 kN RL 2 kN C2 12 k. 2.7 kN

A: We need to find out voltage gain and output impedance for given circuit

Q: A conductor 2 m long moves at a speed of 60 km/h through a magnetic field having a flux density of…

A:

Q: delivered by the source. Express in rectangular form. -j25 Q j15 0 12020° V 30 Q 15 Q ww

A:

Q: A conductor 2 m long moves at a speed of 60 km/h through a magnetic field having a flux density of…

A: Given data: L=2mSpeed, U= 60km/h =60×518=16.66 m/sFlux density, B=0.6T

Q: Consider the following signal: 57 x(n) = 3"+2 sin(: n- Ju(n) 1.1 Determine the z-transform X(z) of…

A: Consider the following signal: x(n)=3n+2sin5π6n-π3u(n) 1. We need to z-transform X(z) of the signal…