a program asks the ser to temperature grades for the last ten days with their units. Then the program will calculate the average of these entries and print it in a Celsius degree. (note: the following formula is used to convert Celsius degree to Fahrenheit F = 9/5 (° C) + 32). Assume the entered temperatures might be either in Celsius or Fahrenheit degrees.

a program asks the ser to temperature grades for the last ten days with their units. Then the program will calculate the average of these entries and print it in a Celsius degree. (note: the following formula is used to convert Celsius degree to Fahrenheit F = 9/5 (° C) + 32). Assume the entered temperatures might be either in Celsius or Fahrenheit degrees.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 6P

See similar textbooks

Similar questions

A weather person states that the barometric pressure is 40 inches of mercury. Convert the pressure to kPa. Do not write the unit. You will only input the númerical answer in the space provided. Unit of the Correct Answer: kPa Decimal Places required in the final answer: 3
The pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Mercury having a sp.gr of 13.6? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 3
What is the equivalent value of T = 120° F in kelvins?
Alcohol thermometers can measure temperatures in the range of 100 F to 200 F Determine the temperature at which an alcohol thermometer with a Fahrenheit scale will read the same number as a thermometer with a Celsius scale.
The pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Oil having a sp.gr of 0.85? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 3
A 30 m steel tape is 2 mm long at 20 degrees Celsius with a pull of 55 N. A rectangle is measured with this The sides are recorded at 144.95 m and 113.00 m. The average temperature during the measurement is 30 degrees Celsius with a pull of 55 N. Use coefficient of expansion of steel tape as a 0.0000116 per degree Celsius. Compute the actual length of tape during measurement What is the true area? What is the error in sq.m?
1-41. The constants B = 1.357(10-6) N-s/(m² -K!/2) and C = 78.84 K have been used in the empirical Sutherland equation to determine the viscosity of air at standard atmospheric pressure. With these constants, compare the results of using this equation with those tabulated in Appendix A for temperatures of T = 10°C and T = 80°C. %3D
A 30 meter tape is 2mm too long at 20℃ with a pull of 55N. A rectangle is measured with this tape. The ideas are recorded as 144.95 meter and 113.00 meter. The average temperature during the measurement is 30℃ with a pull of 55N. Use coefficient of expansion of steel tape as a 0.0000116/℃. Compute the actual length of tape during measurement. What is the true area. What is the error in area in sq.meter.
On a sealed tank showed, calculate the pressure of the air
PROBLEM 2: The manometer contains air in pipe A and water in pipe B. The air pressure in the pipe at A is 300 kPa. (unit weight of air = 12.017 N/m^3) 0.5m 0.3m- 0.2m 0.4m -0.35m- Determine the water pressure in the pipe at B. * (Final answer until 3-decimal places only. Indicate the unit) Your answer
d) Calculate the change in temperature. Indicate increase or decrease in temperature.
A 50-m steel tape standardized at 20° was found to be 50.16 m long. This tape was held horizontal to measure a line from A to B in three segments. The data listed in the following table were recorded. Apply corrections for tape length and temperature change to determine the correct length of the line. The coefficient of thermal expansion and contraction of the tape is 0.000116 /unit length/degree Celsius. Section Measured distance (m) Temperature (C°) 35 I 50.00 II 50.00 37 III 31.215 40