A Pelton wheel turbine is a type of turbine that transforms the kinetic energy of water jet to rotational energy. A Pelton wheel turbine was used in a hydroelectric power plant. Water enters the turbine nozzles at 607 kPa absolute with a low velocity. If the nozzle outlets are exposed to atmospheric pressure of 116.58 kPa, determine the maximum velocity (in meter per second) to which water can be accelerated by the nozzles before striking the turbine blades

Q: In a certain process, energy entering is 1500 KJ/kg and 150 m/s. If the energy leaving is 1200…

A:

Q: Q3:-The velocity, pressure and temperature of air flow upstream of a normal shock are 500 m/s, 100…

A:

Q: A jet of water moving with a velocity of 20 m/s impinges on a curved vane, which is moving with a…

A:

Q: Water flowing steadily at a rate of 0.17 m3/s is deflected downward by an angled elbow and exits to…

A: Given: ρ=1000kg/m3D=30cm=0.3md=10cm=0.1mh=50cm=0.5mVelbow=0.03m3Q=0.17m3/s

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: The minimum power needed by a water pump that increases the pressure of 4 kg/s from 100 kPa to 6 MPa…

A: Given data,  P=100 KPa  p=6 MPa = 6000 KPa  Mass flow rate is 4kg/s  Let's density of water is 1000…

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: 2. Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 74 m/s and leaves the same stage…

A:

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg. the steam…

A:

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves at the same stage…

A:

Q: Water is flowing through a large circular conduit with inside radius R and a velocity profile given…

A:

Q: the exhaust of a turboject engine the nozzle is operating steadily and heat loss is assumed…

A:

Q: If it takes 50 s to fill the 10 - gallon bucket with water by a garden hose attached with a nozzle.…

A: As per given Question  Volume =50gallon Time=50 s Inner diameter =2cm Reduce diameter =0.75cm We…

Q: determine the velocity of gas jet at exit from the nozzle.

A:

Q: How does the Bernoulli’s Theorem Apparatus show the relationship between the kinetic and potential…

A: According to Bernoulli's theorem, total energy (in the head form) remains constant. Assuming there…

Q: Water enters the radial turbine at 30⁰ absolute flow angle with the flow rate of 3.5 m3/s and leaves…

A:

Q: Air is expanded adiabatically in a horizontal nozzle from an initial pressure of 1.0 MPa, and a…

A: Given:P1=1 MPaT1=800 KP2=101 KPaV1=100 m/svelocity of sound,c=343 m/s1) Inlet Mach…

Q: A wind turbine has a blade length of 30 m. In a given day, average speed of wind for 5 hours is 9…

A:

Q: In a gas turbine , the flow rate of air is 4 kg/sec . The velocity and enthalpy of air at the…

A:

Q: A 15-hp (shaft) pump is used to raise water to a 42-m higher elevation. If the mechanical efficiency…

A: Given: The pump power, P = 15 hp The height h = 42 m The mechanical efficiency = 0.82

Q: The entropy of steam entering the turbine at temperature 800°C and Pressure 1600 kPa is

A: Steam temperature, T=800oC Steam pressure, P=1600 kPa

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg . the steam…

A:

Q: 4. In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A: It is required to deterrmine the diameter of the nozzle at inlet.

Q: If the used turbine converts only three-quarters of the energy that the fluid will lose after…

A: Given data: E is the total energy supplied.

Q: In a reaction stage of a stecam turbine the nozzle angle is 20 and the absolute velocity 1.7 of the…

A:

Q: If you know that the change in entropy of a system where heat was added is 12 J/K, and that the…

A: To Find :  The amount of heat added to the system . Given : The change in entropy is ∆s=12 Jk. The…

Q: In a Francis turbine, the pressure gage in the turbine casing reads 394 kpa. The elevation above…

A:

Q: At the exhaust of a turboject engine the nozzle is operating steadily and heat loss is assumed…

A:

Q: Consider water flow through a horizontal, short garden hose at a rate of 30 kg/min. The velocity at…

A: Given, mass flow rate of water, m˙=30 kg/min=0.5 kg/s Velocity of the flow at inlet and outlet of a…

Q: In a power plant, the inlet water has a velocity of 100 ft/s and an elevation of 80 ft above the…

A:

Q: enthalpy of 3828 kJ/kg at 70m/s and leaves the same stage with an enthalpy: 2846 kJ/kg and a…

A:

Q: Water at 200 kPa and 355K (H=343.3 kJ/kg) enters the straight horizontal pipe at velocity 3 m/s…

A: Heat supplied is the heat supplied for power generation or for the useful work of a machine. This…

Q: The thrust developed by the engine of a Boeing 777 is about 380 kN. Assuming choked flow in the…

A: Given: The thrust developed by the engine is F=380 kN. The ambient temperature is T=215 K. The…

Q: In a turbo-jet engine the momentum of the gases leaving the nozzle produces the propulsive force.…

A:

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg. the steam…

A:

Q: A hydroelectric power plant uses Pelton-type turbines, in which multiple nozzles are used to…

A: Given data:

Q: A Pelton wheel has a diameter of 2 m and develops 500 kW when rotating 180 rpm. What is the average…

A: Givenpelton wheel turbined=2mP=500kWN=180rpmoperating at maximum efficiency

Q: The type of steady flow system in which, two streams of fluids m1 and m2 are entering and one stream…

A:

Q: Steam enter a turbine stage with an enthalphy of 3628 kJ/kg at 70m/s and leaves the same stage with…

A:

Q: Q3. In the gas turbine unit, the gas flow through the turbine at 13 kg/s and the power developed by…

A: Given that,

Q: A certain weight lifting machine of velocity ratio 30 can lift a load of 1500 N with the help of 125…

A: Given Data: Velocity ratio, Vr=30

Q: . The mass flow rate of the gas in a gas turbine is 40 kg/s. The specific enthalpy and velocity in…

A: Given Data  Mass flow rate of the gas, m=40 Kg/s h1=1300 KJ/kg v1=160 m/s h2=350 Kj/Kg v2=50 m/s…

Q: 2. Air flows in a steady manner through a converging tube. At the inlet there are 690kPaa and…

A: AS PER GIUDELINES I HAVE TO SOLVE ONLY 1ST QUESTION

Q: A wind turbine has a blade length of 20 m. In a given day, average speed of wind for 4 hours is 7…

A:

Q: . A converging nozzle is fed with air from a large reservoir where the pressure and temperature are…

A:

Q: An air compressor takes air at 99 kpa and compress it isentropically at 700 kpag. If volume flow at…

A:

Q: Consider a turbojet powered airplane flying at a standard altitude of 8.5 km at a velocity of 108…

A: