In an adiabatic turbine, this steam flow is 50 kg / s. The power produced by the turbine is 29 MW. Steam enters the turbine with a pressure of 50 bar and a speed of 60 m / s. At the outlet, at a pressure of 0.06 bar It comes out as saturated water with a speed of 130 m / s. Accordingly, the heat lost by the turbine and Find the turbine inlet and outlet temperatures of steam

Q: Air enters the compressor of a gas turbine power plant at a pressure of 100 kPa and a temperature of…

A: The inlet and exit enthalpies of the air in turbine are:

Q: Water steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4…

A: Write the inlet and exit properties of water steam.

Q: Air flows into a turbine at a rate 30 [m 3 /s], a temperature of 1100 [K] and a pressure of 300…

A: Write the properties of air at the entry of the turbine ( P3=300 kPa, T3=1100 K).   h3=1162.28…

Q: motor-pump system with 90% efficiency is designed to increase the pressure of was from 101kPa to 250…

A: Hh

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Derive the steady flow energy equation (SFEE) from the first principles. You are required to show…

A: Part 1: From mass conservation∑inletm˙i=∑outletm˙oFrom energy conservation,E˙in=dEcvdt+Eout˙For…

Q: (0.1 kg/s) of water enters a boiler at (323°K & 5 Mpa), and leaves as steam at (673°K & 5 Mpa). For…

A:

Q: : Determine the total turbine power output ? in the adiabatic turbine receives the water at (15000…

A:

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves at the same stage…

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A: Option a is correct.

Q: Water vapor enters the steam turbine at 4000 kPa pressure, 500 ° C temperature and 6 m3 / h volume…

A: Given data, P1 = Pressure at state 1 = 4000 KPa T1 = Temperature at state 1 = 500°C Q1` = Volume…

Q: For a gas turbine jet propulsion unit, the pressure and temperature entering the compressor are 1…

A:

Q: A centrifugal compressor draws in 240 m^3/min of air pressure of 96kPaa and a temperature of 15.6C.…

A:

Q: In a gas turbine unit, the gases flow through the turbine at 13 kg/s and the power developed by the…

A: Given data: Mass flow rate of gas (m.)=13 kg/s The power developed by the turbine (P)=14000 kW The…

Q: 9. A turbine receives steam at 2778.1 kJ/kg enthalpy and then converts it to shaft work. The steam…

A: To determine the power produced by the turbine.

Q: Steam enters an adiabatic turbine at 6MPa pressure, 530C temperature, 2.5MPa pressure and 420C also…

A: Given: Inlet condition of turbineP1=6MPaT1=530°COutlet condition of the turbineP2=2.5MPaT2=420°C…

Q: In a gas turbine , the flow rate of air is 4 kg/sec . The velocity and enthalpy of air at the…

A:

Q: Refrigerant-134a enters an adiabatic compressor at 15 psia and 20°F with a volume flow rate of 10…

A: The initial pressure of the refrigerant is P1=15 psia. The initial temperature of the refrigerant is…

Q: 2000 kg/h of waste materials with enthalpy of 100 kJ/kg entered a turbine and exited with 20 m/s…

A: L

Q: Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg . the steam…

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Water vapor enters the steam turbine at 4000 kPa pressure, 500 ° C temperature and 6 m 3 / s volume…

A: Given information: The pressure of vapor at inlet 1 (Pi) = 4000 kpa = 4 Mpa The inlet temperature of…

Q: A steam turbine developed 2372.20 hp when its inlet condition is 1300 BTU/lb enthalpy and 400 ft/s…

A: Given data,  W= 2372.2 hp. = 1768.94924 kW  h1=1300 BTU/lb.= 3023.8 kJ/kg h2=800 BTU/lb.= 1860.8 kJ/…

Q: mass flow rate of the air (lbm/s).

A: Given data as per the question For a compressor work-done = 10hp =-5500 lbf ft/s (-ve sign represent…

Q: A 0.5 kg of saturated liquid water at 1.0 MPa flows through a pump isentropically. If the required…

A: Write the value of the entropy of saturated water at 1.0 MPa using the saturation properties table.…

Q: 3. Steam enters the turbine at the rate of 1.5 kg/s with enthalpy of 2300 kJ/kg and exhaust enthalpy…

A: Given that ,  m'=1.5kg/sh1=2300kJ/kgh2=2570kJ/kgh3=1200kJ/kg

Q: Q.) A gas turbine expands air at 1300 Kpa and 500°C to 100 Kpa and 127°C. A heat loss of 750 KW is…

A:

Q: The work required for compressing gas from an initial condition of 100 kPa and 300K to a final…

A: Heat supplied is the heat supplied for power generation or for the useful work of a machine. This…

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves the same stage with…

A: Given Data⇒ Properties of steam at entry of turbine : h1=3628KJkgv1=70ms Properties of steam at exit…

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: Air at the rate of 25 kg/min is compressed in a centrifugal compressor from 1 bar to 2 bar. The…

A: Given that,     m˙=25 kg/min=2560 kg/sp1=1 bar=100 kPa  ;  p2=2 bar=200 kPaT1=15°C=288 K ;…

Q: Two pounds per second steam enters the turbine at 500 ft/s with 600 btu/lb enthalpy and leaves at…

A: Write the given values with the suitable variables. m˙=2 pounds/sv1=500 ft/sh1=600 btu/lbv2=200…

Q: 600 kPa at 578 K and exits the turbine at a temperature of 428 K and a pressure of 100 kPa

A: apply first law of thermodynamics at inlet and outlet,here assume that air is an ideal gas.

Q: The work required for compressing a gas from an initial condition of 100 kPa and 300 K to a final…

A: Given data: Let us consider that the nozzle is adiabatic.

Q: Two pounds per second steam enters the turbine at 500 ft/s with 600 BTU/lb enthalpy and leaves at…

A: Dear student,                     According to the guidelines I am allowed to answer only one…

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: Steam enters the turbine at a speed of 10 kg/s. The pressure at the inlet is 100 bar and the…

A:

Q: Determine the mass flow rate of a steam turbine if the inlet conditions are as follow T= 400 C and P…

A:

Q: Air enters a gas turbine systenm with a velocity of 105 m/s and has a specific volume of 0.8m/kg.…

A: Air inlet velocity, V1=105 m/s Specific volume of air at inlet, v1=0.8 m3/kg Inlet area of gas…

Q: 4. A converging nozzle is fed with air from a large reservoir where the. pressure and temperature…

A:

Q: . The mass flow rate of the gas in a gas turbine is 40 kg/s. The specific enthalpy and velocity in…

A: Given Data  Mass flow rate of the gas, m=40 Kg/s h1=1300 KJ/kg v1=160 m/s h2=350 Kj/Kg v2=50 m/s…

Q: Q5: A-Steam enters a turbine with a velocity of 47 m/s and specific enthalpy 2690 kJ/kg. the steam…

A:

Q: DETERMINE THE TURBINE WORK AND ENGINE EFFICIENCY IF THE INLET PRESSURE AND TEMPERATURE ARE 23MPA AND…

A:

Q: man purchases a turbine for use in his factory. He sets it up so that there is steam entering at…

A:

Q: steam at 2778.1 kJ/kg enthalpy and then converts it to shaft work. The steam

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A: