A lossless 60-2 line is terminated by a 60 + j60-N load. If Z, = 120 - j60 , how far (in terms of wavelengths) is the load from the generator? Solve this without using the Smith chart. calculate reflection coefficient and standing wave ratio.

A lossless 60-2 line is terminated by a 60 + j60-N load. If Z, = 120 - j60 , how far (in terms of wavelengths) is the load from the generator? Solve this without using the Smith chart. calculate reflection coefficient and standing wave ratio.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.35MCQ: The affect of the earth plane is to slightly increase the capacitance, and as the line height...

See similar textbooks

Related questions

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Z0 of T.L =50 ohm Standing wave ratio (s)=2.0The distance between succesive voltage minimum…

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: GMR stands for geometric mean radius which is also known as self GMD it is mean of the distance of…

Q: [3] which produces a voltage reflection coefficient Fx = 0.52 angle -320 at a point X on the line…

A: A transmission line with no line resistance and no dielectric loss is known as a lossless line. This…

Q: A 50-N lossless line is terminated in Z, = 40 – j30 N. Determine the following: (a) the reflection…

A: A 50Ω lossless line is terminated in Z1=40-j30Ω. Now, to determine the reflection coefficient at the…

Q: A lossless transmission with characteristic impedance of ?0 = 100Ω and length = 52cm The line was…

A: Given:Characteristic impedance,Z0=100ΩLoad impedance, ZL=30 +j50Ω

Q: A 30-m-long lossless transmission line with Z, = 50 2 operating at 2 MHz is terminated with a load…

Q: The two wire lines shown in the figure below are lossless and have Zo=200 Ω. Find d and shorted…

A: Calculate the impedance at load side i.e. Za. Za=z02ZL=2002100=400 Ω Now, calculate Zb.…

Q: A lossless transmission line has a capacitance per unit length of 64pF/m and an inductance per unit…

Q: For a lossless trabsmisison line, the characteristic impedance is 80 ohm. If the capacitance per…

A: A transmission line can be characterized by 4 parameters: 1. Resistance per unit length (R) in ohm/m…

Q: lossless transmission line has a characteristic impedance of Zo=40N, load reflection coefficient is…

Q: When a lossless transmission line is terminated by a resistance equal to surge impedance, then what…

A: Given, A lossless transmission line is terminated by a resistance equal to surge impedance. Load…

Q: The capacitance per unit length and the inductance per unit length for a lossless transmission line…

A: Characteristic impedance (Z0) of a transmission line is defined as the impedance of the transmission…

Q: The observed standing wave ratio on a 100 Ω lossless line is 8. If the first voltage maximum occurs…

A: Given: Z0=100 Ω Standing wave ratio, S = 8 First maximum (n = 1) occur at dmax=0.3λ

Q: Show that current and voltage satisty wave equation in transmission lines?

A: v+∆v = v-R∆xi-L∆xδiδt This is the voltage wave equation for the transmission line. i+∆i…

Q: A transmission line is not properly terminated thereby causing a a reflection coefficient magnitude…

A: In this question we need to find a impedance of the termination.

Q: A transmission line has characteristic impedance of 75 Ω and it is connected to receiver with…

A: According to the question we have to find the value of i. Reflection Coefficient; ii. VSWR

Q: characteristic impedance of Zo=302, load reflection coefficient is 0.5 .What is the load impedance?

Q: A lossless 1000 line is terminated with an inductance L=2mH. At w=25×10³rad/s, what is the…

A: In this question, We need to determine the reflection coefficient at the end of the line If…

Q: Why is the Geometric Mean Distance (GMD) of two different conductors the same in a transmission line…

A: We have given the following problem

Q: 2. The phasor voltage on a terminated transmission line is given by 1 -e-j2nz + +j2nz What is the…

Q: Please help with this conceptual electromagnetic question. A length of transmission line that is…

A: A length of transmission line that is terminated with a short. is it always inductive, or always…

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: The observed standing wave ratio on a 100 Ω lossless line is 8. If the first voltage maximum occurs…

A: Given Z0 = 100 ohm, s = 8, θτ-2βl=0θτ=2βlθτ=22πλ(0.3λ)θτ=4πλ(0.3λ)θτ=216°

Q: A lossless 500 transmission line was terminated with a load of = 17.7 + j11.80. The length of the…

A: we need to calculate the reflection coefficient at the entrance.

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: We have to derive formula of sag for equal height poles in a transmission line.

Q: c. A lossless 502line is terminated by a load Zı = 75 + j60 2. Using a Smith chart, determine (a)…

A: Given Zo = 50 ohm ZL = 75+j60 ohm

Q: sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of…

Q: 4. For a lossless coaxial transmission line of characteristic impedance 502 and wave phase velocity…

A: For a lossless coaxial transmission line of characteristic impedance 50 Ω and a wave phase velocity…

Q: A 60 n lossless line has a maximum impedance Z, = (180 + p) N at a %3! distance of /24 from the…

A: Reflection coefficients determine how much wave is reflected at discontinuity of medium.It is given…

Q: The return loss for a Transmission line is 20 dB. What will be the value of the corresponding VSWR…

A: During transmission of signal through a transmission line, some portion of the signal always gets…

Q: A 100Ω lossless line connects a matched signal of 100kHz to a load of 25Ω. Calculate the reflection…

Q: Antenna with impedance 40 +j30 2 is to be matched to a 100 Q lossless line with a shorted stub.…

A: Antenna with impedance 40+j30Ω is to be matched to a 100 Ω lossless line with a shorted…

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Zo= 50 ohm Standing wave ratio=2.0 The distance between successive voltage minima of 25 cm…

Q: A lossless transmission line has 100 ? characteristic impedance. The line is terminated in a load…

A: Load impedance given is ZL=R-jXC which means it comprises a resistor and a capacitor. The circuit…

Q: A 90 N lossless line is 0.6A long, If S = 1.9 and 6, = -68°, use the Smith chart to find the load…

Q: line is terminated in -10 volts, use Smith A lossless T.L of 10.25m long with Z-50 2. The…

Q: A lossless transmission with characteristic impedance of Z0 = 1002 and length = 52cm The line was…

Q: A 50Ω lossless transmission line is terminated in a load (50+j100) Ω. Using a smith chart, determine…

A: Given, Impedance, Z0=50ΩLoad Impedance, ZL =(50+j100)Ω

Q: A 219-2 lossless air transmission line is connected to a complex load composed of a 579-Nresistor in…

Q: QUESTION.2. A lossless air transmission line with Z, = 50 N is connected to a complex load composed…

Q: A 75 Ω lossless line is terminated in error with a 93 Ω resistor. A generator sends 100 mW down the…

Q: A losless line assumed to be infinitely long and of unknown characteristic impedance Z,, when…

A: We are given a lossless line to be infinitely long, and it has characteristic impedance of Zx. (1)…

Q: An extra high voltage transmission line of length 300 km can be approximated by a lossless line…

A: Given, An extra high voltage transmission line of length, l = 300 km Propgation constant, β=…

Q: A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100…

Q: A lossless 60-2 line is terminated by a 60 + j60-2 load. If Zin = 120 - j60 N, how far (in terms of…

A: The wave is function of space and time. The EM wave is formed when electric field is in contact with…

Q: A 60 a lossless line has a maximum impedance Z, = (180 + j0) Q at a distance of /24 from the load.…

A: The EM wave is formed when electric field is in contact with magnetic field. A transmission line is…

Q: [Q6] Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz.…

Q: The distance from the load to the source moving on a lossless transmission line is 2.5 revolutions…

A: The transmission lines are used for power transmission from one place to another. The power system…

Question

A lossless 60-0 line is terminated by a 60 + j60-2 load.
If Zin = 120 - j60 N, how far (in terms of wavelengths) is the load
from the generator? Solve this without using the Smith chart.
calculate reflection coefficient and standing
wave ratio.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the circuit shown in figure 1: 1 By using Smith Chart, compute: 1. The impedance at the length equal to 0.12. - 2. The voltage standing wave ratio. 3. The load reflection coefficient. Figure 1 4. From the load, compute the reflection coefficient at the length equal to 0.12. € 0.12. Z₁ = 500 ore on E Z₁ Z₂ =5+j25 [02]
What is total admittance and impedance from source side.
7- DC Chopper with output voltage of 120V and input voltage of 80V and output power of 240W. Assume lossless chopper. The average inductance current IL is * 2.6 A 3.0A 4.3A
A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is 0.0452 ft. Determine 16' 16' a b 22' c' b' a'
For, z=0.1 and Wn= 5: Peak amplitude = 1.53 Settling time * 7.6 seconds true O False
For b) what is Vry, Vbr, Vyb? Why is Vyb phase -90 degrees and Vby phase 90 degrees?
A sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of position appears as shown below. From this plot, the phase constant B= Voltage 25 20 15 10 -10 -15 -20 -25 10 20 30 40 50 60 70 80 90 100 Meters 0.562 0.314 0.625 0.489
Example 4 A lossles TL having Zo= 400 a borking at. 123m. By using Crank dragram, draw the standing wave at volta and current for 5m from the reciever end when. a) The Load ZR is short circuit and current equal to 1 Arms b) The load ZR is open circuit and the voltage equal to 400 Vin
A three phase system with Dab Dbc one conductor per phase as shown in the figure. The conductors are stranded and spaced as shown, (Dab=Dbc=4m). The outside diameter of the phase conductor is 2cm. The GMR of the phase conductor is 0.7788 cm. The value of inductance per phase is: Select one: O a. (1.2445 * 10A-3) mH/km O b. (1.1559 * 10^-6) H/m O c. (1.4562 * 10A-6) H/m O d. (1.2945 * 10A-6) H/m O e. (1.2445 * 10A-6) H/m
What is the capacitance per kilometer per phase of a single circuit, two bundle conductor line with horizontal configuration? The distance between the bundled conductors is 30 cm and the diameter of each conductor is 5cm. The distance between the centers of the bundle is 5mChoices: 0.0132uF/km 0.0126 uF/km 0.0143uf/km 0.0116uF/km Please in typing format please
IN rectangular waveguide, we know that in TM mode field, Ez (longitudinal field) is out f phase by 90 degree, why is it?
A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a TV antenna which has an impedance of 75 Ohm. What fraction of the signal (in terms of power) can be coupled into the antenna?