Answered: A load consists of XL=30 Q and Xc=120 Q…

A load consists of XL=30 Q and Xc=120 Q are connected in parallel across 120 Volt supply. The reactive pow of the circuit is Reactive Power VAR

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: What would be the inducesd voltage for a conductor moving at a speed of 25 km/h and having a length…

A: Given data, Speed of conductor, v=25 km/h Length, L=1 m Magnetic flux density, B=0.6 T

Q: Design a circuit with an op amp that provides a gain of 7.5 having a Rin resistor of 12k2. What…

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

Q: 2. You should measure DC power dissipated in a resistive load indirectly using a DC voltmeter and…

A: Given- Voltage reading= 10V Current reading= 1 A Voltage error=±0.4 V Current error= ±0.08 A To…

Q: (a) What current lo is flowing, and what must the values of Rp and Rs be? (b) What is the largest…

A: Given: VTN=0.4 V, kn=4 mAV2, and λ=0VS=-0.6 V and VD=0.2 V

Q: Use DeMorgan's theorems to simplify the expression for the output of below Figure... Figure 도

A: Given, Logic circuit,

Q: Why is the following situation impossible? The LC circuit as shown has L = 30.0 μH and C = 50.0 μF.…

A: The energy stored in the capacitor is given by the expression as shown below: E=12CV2 The voltage…

Q: The switch closes at t = 0 after being open for a long time. Given that R = 7 k. Find an expression…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: A certain waveform has a form factor of 2.3 and a peak factor of 3.5. If the maximum value is 100…

Q: Find Zah, (Z-Thevenin) for the following circ 50/30° V j20 12 m 1052 wwa -1022

A: Given data, Circuit diagram is given as,

Q: Using Mesh Analysis, determine the current "I" in the circuit. Also, determine the power absorbed by…

A: The required current I can be calculated by applying kirchhoff's voltage law to the meshes and then…

Q: Part 2. Determine the z-transform and ROC of x(n) = 3¹u(n-2)-n7"u(-n-1) Let x₁ (n) = 3"u(n − 2).…

A: Since you have posted the multiple questions so we are supposed to answer the 1st questions.

Q: 1. What is the total resistance of the circuit below when: Both switches are open; Switch SW1 is…

A: Given circuit,

Q: In the system shown in Figure P5, an incident wave of voltage V+ strikes the discontinuity from…

Q: Which memory storage is widely used in PCs and Embedded Systems?

A: The correct option along with the explanation is provided in the following section.

Q: Calculate the response of the signal below:

A: Given- x[n] =3δ(n-1)+2δ(n)-δ(n+2)h[n]=2u[n+1]-r[n+1]+u[n]+2r[n-1]-3u [n-1]-r[n-3] To find- Response…

Q: Which of the following is true regarding the relative permittivity of the dielectric used for the…

Q: 752. See Figure 752. D=5. The Bode gain and phase plots for a RC circuit are shown in the fig.…

Q: A transformer may be used to provide maximum power transfer between two AC circuits that have…

A: Given: A transformer may be used to provide maximum power transfer between two AC circuits that have…

Q: 50 V 10Ω a 12Ω b D 40 Ω 20 Ω (8A 40 V

Q: 8a. Using Kirchhoff's rules, calculate the current I₁ in resistor R₁, using the directions indicated…

Q: vo resistors R₁ and R₂ (where R₁ = R₂) are connected in series to an ideal battery. Which of the…

A: The total resistance= R1+R2 = 2R1=2R2 The total resistance is…

Q: Two wattmeters have been used to measure the power input to a 130 kW, 400 V, 3-phase slip ring…

Q: e) a[n], where the (complex) discrete time signal =-{ n f) Za[n] g) x(t)]², where x(t) = 2-¹/jt h)…

Q: Electrical Engineering 1) Design a PID control so that the system follows the reference given by the…

A: The most precise and reliable controllers are PID (proportional integral derivative) controllers,…

Q: A 1.31-coulomb and 1.01-kilogram particle is going to be launched at an initial velocity 4.39 meters…

Q: _et x[n] = 0.8¹u[n − 1] & h[n] = 0.4”u[n]. Find their convolution. Answer: (2(0.8¹) — 2(0.4″))u[n −…

Q: Three circuits A, B and C are connected in series across a 200 V supply. The voltage across circuit…

A: We got an Series Circuit of A,B,C with, Supply Voltage = 200 V = 200 Sin (ωt) Voltage across circuit…

Q: 1. Write an expression for the output in each circuit below. a) A- Ja Out b) A 3-0 B Out

A: a) Given data, Logic circuit,

Q: A 110-V, 40-W lamp is connected to 240 V, 50 Hz supply with a capacitor in series with the lamp so…

Q: What does OS X has?

A: The solution is provided in the following section.

Q: Taking R = 1.00 kΩ and ε = 250 V as shown, determine the direction and magnitude of the current in…

A: The required current value can be calculated by using the mesh analysis method. The mesh equation…

Q: Two coils A and B are kept in parallel planes, such that 70% of the flux produced by coil A links…

A: We have two coils coil A and coil B in parallel planes. KA = ФAФB = 0.7 Number of turns(NA) = 10,000…

Q: You are given five light bulbs designed to operate on 160 mA current at 3.0 V (rms values), arid…

A: a) The circuit diagram consisting of the AC power source, transformer, and five resistors connected…

Q: A separately excited dc generator when running at 1200 rpm supplies 200 A at 125 V to a circuit of…

Q: In the circuit below, what is the value of the current 13? A 25 Ω F 0.52 A O 0.19 A O 0.71 A O 0.25…

Q: If the pu impedance of a single-phase transformer is 0.01 + j0.05, then its regulation at p.f. of…

A: Given, The pu impedance of a 1-φ transformer, Z=R+jX=0.01+j0.05 pu Power factor, cosφ=0.8 lagging…

Q: Q5. Design Problem: Q5. Design a Voltage-divider D-MOSFET circuit that produces a voltage gain of -…

A: Given, R1=11×R2 , ID(Q)=7.6mA=7.6×10-3A VGS(Q)=0.35V , VDD=18V V1=1.5mv=1.5×10-3V, rd=30kΩ=30×103Ω…

Q: A Y-connected generator rated at 300MVA, 33kV, has a reactance of 1.24 p.u. Find the ohmic value of…

A: Given: A Y-connected generator rated at 300 MVA, 33 kV. Base values, S=300 MVAV=33 kV Reactance,…

Q: 4 A. X(z) of -n7"u(-n-1) = 1+72-1 B. X(2) of -n7"u(-n-1)= -1 1-7z C. X(z) of -n7"u(-n-1)= D. X(z) of…

A: You have asked only 6th question So i answered only this question.

Q: Apply KVL to find find the voltage V₂ in the circuit shown below given : E = 48 V, V₁= 12V, V₁= 24V.…

A: Given circuit,

Q: 1 0 8 (t) t

Q: Why is the following situation impossible? A technician is testing a circuit that contains a…

A: Given: 3 resistors Resistance of a single resistor is 'R'. The desired resistance is 73R.

Q: 1 0 8 (t) t

Q: 2) For a given short-circuit calculation utilizing the per unit method, a base voltage of 480 V and…

Q: A 3-phase induction motor is wound for 6 poles and is supplied from a 60 Hz supply. Calculate the…

A: Given a 3-phase induction motor has, Number of poles, P = 6 Supplied frequency, f = 60 Hz Rotor…

Q: voltage of v(t) = 4 cos(2π 43 t) volts is applied across the 33-ohm resistor. Find the total charge,…

Q: A conductor 0.5 m long is moved at right angle to a uniform field strength of 0.12 Wb/m^2 at a speed…

Q: 2. Prove that the sum of the readings of the two wattmeter used to measure power in a 3 wire, Wye…

Question

A load consists of XL=30 Q and Xc=120 Q are connected in parallel across 120 Volt supply. The reactive power
of the circuit is
Reactive Power VAR

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
a resistor and and capacitor are connected in parallel to a 277 v 60 hz power source. the resistor has a value of 50 ohms and the capacitor has a value of 40 uf what is the circuit power factor.
4. Design the network in the figure to have the following characteristics: i. BW - 500 Hz ii. Qp = 30 iii. Vemax = 1.8 V 0.2 mA Z0° C7 R, = 0 N
Determine the DC currents (B. Ic and le) and de juncion voltages (VBE, VCE and Vca) mA. Ic ma, E mA VBE= V. VCE Vand VCB Use 2 decimal places. RB Use the following values: VBB = 3V RB = 4 kQ Rc = 166 0 Vcc = 19 V BDC = 70 %3D %3D VCC RC VBB
6. What is the effect of load inductance on the ripple current? 7. i effect of chonnine Bock and boost 8. Wh 9 What chopping 10. At what duty evcle does the load current rinnle current he
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
In case RL load, it is desired to get an average load voltage of 75 V. Determine the firing angle if the ac supply voltage is 200V per phase. If the load resistance is 302, calculate the average load current and power. Design the thyristor. 4-
Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.
True power can be determined by measuring voltage and current in a. R-L series circuit b. Purely resistive ac circuit c. Purely capacitive circuit d. Purely inductive circuit
a capacitor and a resistor are connected in parellel to a 120 v 60 hz line the resistor has a resistance of 40 ohms and the capacitor has a capacitance of 132.6 uf what is the total current flow through the circuit. what is the impedence and the power factor and how many degrees out of phase are the current and voltage out phase with eachother.