Answered: True power can be determined by…

True power can be determined by measuring voltage and current in a. R-L series circuit b. Purely resistive ac circuit c. Purely capacitive circuit d. Purely inductive circuit

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 90 %.…

A: String efficiency= 90% Nearest branch voltage =9kV Phase voltage 66kV

Q: What would be the same results of this quesiton if the circuit was single phase 1000v?

A: If True power is single phase i.e.,P1ϕ=10kWV1ϕ=1000VI1ϕ=12.33 A

Q: Why the tranformer rattigs are mentioned in KVA. Discuss in brief.

A: The transformer is a device which is use to transfer the power from one portion to the other…

Q: A Cockcroft-Walton type voltage multiplier has ten stages with capacitances, all equal to 0.1 μF.…

A: Given data C=0.1×10-6 FVmax=100 KVf=60 HzI= 5 mAn=10 (a) % ripple Formula for % ripple is given…

Q: Q20. The section bus-bars A and B as shown in Figure B5 are linked by a bus-bar reactors each rated…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: A power transmission line of 11kV (maximum) carries a maximum current of 200A is connecting the two…

A: Given: A power transmission line of 11kV (maximum) carries a maximum current of 200A is connecting…

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 85 %,…

A: In this answer let us find the no.of disc insulators in a suspension type insulators setup as shown…

Q: 230V Primary, 12v Secondary T1= 250mA stepdown transformer 12 D5 230V AC IN T1 1A Bridge IC2 7812…

A: Single-phase Bridge circuit: It produces the DC output and takes AC input. This is a type of…

Q: Q4: A single-phase AC voltage controller is used to control the power flow from 110 V, 60 Hz source…

Q: Frequency of operation for category '6' cable is a. 100MHz b. 250MHz c. 200MHz d. 250KHz

A: category 6 cable is example of twisted pair cable used to transmit data in network. The maximum…

Q: what do you call an equipment that changes the voltage higher or lower without changing the…

A: => Capacitor bank :- It is used to improve the power factor of the system. => Switchgear…

Q: Which among these is the advantage of synchronous condensers a. Very expensive b. Helps in achieving…

A: In the given question the advantages of a synchronous condenser has been asked. 1. When you observe…

Q: Three Phase Systems and Electrical Measurement Distinguish between a feeder and a distributor.

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 85 %,…

Q: Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material…

A: The circuit diagram for the question is as follows The electrical gradient in a cable is given by…

Q: Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material…

A: SINGLE CORE CABLE DESIGN FOR 25KV. THE RADIUS OF CONDUCTOR IS 0.5 Cm . the insulation material…

Q: what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc…

A: To find minimum size feeder conductor THHW 75 degrees motor generator arc welders = 4 numbers , 30…

Q: What is the magnitude of the impedance of this circuit element?

Q: A resistor and capacitor are connected in parallel to a 277-V, 60-Hz power source. The resistor has…

Q: A microwave with ratings shown in Figure 2 is being supplied with a single phase 120 VAC, 60 Hz…

A: As per the guidelines, we supposed to answer the first three-part of the question at a time so…

Q: 8. Junction 9. Loop 10. Circuit

A: 8. Junction : Junction in an electrical circuit is the point where a number of conductors or may be…

Q: (b) Based on part (a), illustrate the phasor diagram

Q: Provide brief answer only. Define a fixed DC source alomg with it's symbol and applications.

A: According to the given question, it is required to determine the definition of a fixed DC source…

Q: State two advantages of a three phase Ac supply over a single phase Ac supply

A: Single phase supply: The power is supplied through two wires called Phase and neutral and the…

Q: WHAT IS THE POSSIBLE OBSERVATION AND CONCLUSION ABOUT SERIES–PARALLEL CIRCUIT AND DELTA WYE…

Q: NEC identifies ____ types of rigid PVC conduit. Select one: A. FIVE B. TEN C. THREE D. TWO

A: To discuss the types of rigid PVC conduit identified by NEC.

Q: A power transformer with standard insulation class of 69 kv will withstand an rms test voltage of…

A: Given , a power transformer of standard insulation 69kV

Q: 16. Three phase, 50 Hz, 30 MVA, 20 kV, delta connected alternator. Neglecting saturation, The…

A: Given, Three phase, 50 Hz, 30 MVA, 20 kV, delta connected alternator. Required excitation current,…

Q: Electromagnetic interference .controls voltage at all level scarry inrush current for short period…

A: Electromagnetic interference=disturbance of frequency around 10MH Reactive power compensation=shunt…

Q: The rating of generator is expressed in terms of kVA Select one: True False

A: The rating of generator is in Apparent power kVA.because the power factor is varied for different…

Q: APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT .

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 90 %,…

A: In this question , we will find no of disc insulator with given data..

Q: Each phase of delta connected load comprises a resistor of 50 ohm and a series capacitor of 50 µF.…

A: Given 3 phase delta connected load comprises a resistor of 50 ohm and a series capacitor of 50 µF…

Q: Why do we need to clip a certain amount of voltage in positive or negative or on both sides? What is…

A: The explanation is as follows.

Q: supply system does not require neutral wire ...... O a. Three phase three wire O b. Single phase two…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material…

A: Potential difference is given V = 25 KV, Radius of conductor 0.5 cm. Now, drawing the diagram for…

Q: acitance of

Q: The units of admittance, conductance, and susceptance are siemens. (a) True

A: Since, The admittance is the reciprocal of the impedance and it is denoted by Siemens(S). The…

Q: 6.) . The NTD fuse rating for a 230 V, 3Ø, 50 hp synchronous motor with an 80 % power factor using…

Q: 4) Corona discharge can also cause voltage transients on the mains power supply. This occurs when…

A: AS there are two different questions above and you have not mentioned which question to do. So we…

Q: Safety considerations require that the CT has to be short circuited (or the primary circuit switched…

A: Current transformers are useful to measure higher ac currents. This is due to the unavailability of…

Q: Lighting arresters are used in power system to protect electrical equipment against a. Direct stokes…

Q: Single core cable design for 25 kV. The radius of conductor is 0.5 cm. The insulation material…

A: According to question : r=0.5 cmr1=2.5 cmR = 4.5 cmV1=20 KVV2=5 KV

Q: The term "____" is defined in NEC® Article 100 as "connected to establish electrical continuity and…

A: Given, The term "____" is defined in NEC® Article 100 as "connected to establish electrical…

Q: With the help of mathematical expression and wave forms prove the following. a. V and I are in the…

Q: 47. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The…

Q: Explain with illustrations the following dynamic performance terms as applied to measument systems…

A: Explain with illustration of following 1. Rise time 2. Time constant 3. Setting time

Q: Define Wye and Delta Connection in AC Motor - Define Three Phase AC Motor

A: To define wye and delta connection, To define three phase ac motor

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

True power can be determined by measuring voltage and current in

R-L series circuit

Purely resistive ac circuit

Purely capacitive circuit

Purely inductive circuit

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

please write introduction about AC Circuits and Parallel Circuits
Question: Using The Three Rules For Series Circuits And Ohms Law, Solve For The Missing Values
An ac resistance is higher than a dc resistance. True False
Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l3l4RTR182kR275kR356kR462kPT3.436WP1P2P3P4
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
5. Determine RL voltage waveform for the circuit as shown in Figure 4.
What is the relationship between R, L, and C components in a series AC circuit?
Question 1.) Fill in the blanks with proper wording a.) For a purely resistive circuit, the voltage and current phasors are b.) For a purely inductive circuit, the voltage and current phasors are c.) For a purely capacitive circuit, the voltage and current phasors are
Please show you detailed solution Number 10 A voltage of 250 volts at 50 Hz is impressed on a circuit having a 60-ohm resistor, 35-?F capacitor, and a 0.25-henry inductor in series. Determine power factor. A. 0.979 C. 0.924 B. 0.862 D. 0.707
3. The secondary voltage can rise above its rated value when the load is a. resistive. b. capacitive. C. inductive. d. an RL series combination.
Determine the DC currents (la. lc and I) and dc junction voltages (Var Ver and Vca) la-Blank 1 mA, le-Blank 2 mA, I-Blank 3 mA, Var Blank 4 V, Vcr Blank 5 V and VcB - Blank 6 V Use 2 decimal places. Use the following values. VBB= 3V RB= 5kOhms Rc=232 ohms Vcc =18 V BDC=65
In a series AC resistive circuit: a) voltage leads current by 90°(degrees). O b) current leads voltage by 90°(degrees). © current and voltage are in phase. d) d current and voltage cancel.