a) Explain briefly how electricity can be sold to a grid by use solarenergy.b) Wind farm consist of ten wind turbines with nominal capacity of2MWper turbine, has a total of 20 MW for farm as a whole, in year2020, the farm produced a total energy 43416MWH, find a capacityfactor.

As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Answered: a) Explain briefly how electricity can…

Engineering

Electrical Engineering

a) Explain briefly how electricity can be sold to a grid by use solar energy.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: which of the following best describes renewable energy ? a. energy from fossil fuels b. energy…

A: Renewable Energy: It is derived from renewable resources that are replenished naturally on a human…

Q: explain thy type of tariff

A: Step 1: There are total 6 type of tariff, in which each tariff is dependent on the load, type…

Q: Why it is fun to compute problems about ohms law I need personal answer

Q: List four farming operations requiring electrical power. Discuss the advantages and disadvantages of…

A: Electrical power is a basic need nowadays in every field. Every field is equipped with electrical…

Q: cells is referred to as "clean energy." Describe what it is and the significance it holds.

A: Fuel cell are very similar to the conventional batteries bit there is a major difference that is…

Q: 1. Compare Solar energy and wind Energy with a neat diagram. a) Availability and technical…

A: The connectivity of multiple components, from the producing station to various loads is power…

Q: Power Electronics. Write necessity of power supply and briefly describe different types of SMPS…

A: Power supply: It is an electronic device that supplies electric energy to an electric loads the…

Q: 2. Explain the difference of power and energy.

A: IMPORTANCE OF OHMS LAW: Ohm’s law is vitally necessary to describing electrical circuits as a…

Q: a) In a Power System, Define the following (i) Peak Load (ii) Spinning Reserve

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Knowing the most economical combination of power plants to supply the demand is crucial to the…

A: Nuclear power plants Using a nuclear fission reaction and uranium as fuel, nuclear power plants…

Q: Discuss three ways in which power can be used

A: Power is generated by various means like through thermal plant , hydro plant , nuclear plant .For…

Q: Compute the power absorbed or supplied by each component of the circuit

A: Power is the multiplication of the voltage and the current.

Q: State the 6 restrictions that may arise during the day-to-day operations of a power system

A: Generation, Transmission, and distribution network makes power system network very vast and complex.…

Q: 2. Calculate the electricity consumption cost of your home.

A: Once you have your data, calculate the cost of use with this formula: Multiply the device’s…

Q: 1. List energy conversion systems and devices found in your home or generally found in residential…

A: Note: We are authorized to answer the one question at a time. Please submit a new question…

Q: 1. Is hydro power a renewable Energy? Draw a schematic diagram to explain the Electricity generation…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: Electric power supply based on the type of power transmission may be classified as AC system and Dc…

A: The power supply unit is the part of the hardware that is used to convert the power provided from…

Q: What must be the distance from a transmission line if the voltage is 1 kV? The diameter of the…

Q: Use data from a trustworthy source to compare historic and current energy usage and then apply this…

A: Energy has unique and a crucial function in this world; no action can happen without the flow of…

Q: solar

Q: . How is Power implemented? 2. How does power operate? 3. How is history recorded?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: How we can improve the overall efficiency of a steam power plant? please type and explain well…

A: In order to understand how we can increase the overall efficiency of Steam Power Plant, we must…

Q: 2- What are the components of the mobile power circuit (the power circuit)?

A: The answer given as below:

Q: A 250 ft long span separates a dc power supply from a lamp which draws 25 A of current. If 14 AWG…

A: Current from the wire i = 25 A length of the wire = 250 ft for the 14SWG wire resistance is 2.52 ohm…

Q: Discuss the various method of electricity distribution. Provide an illustration of how electricity…

A: Distribution system: In the power system, the distribution of the electricity or power to…

Q: 100 MW solar farm, build cost is $0.8/W, lifetime is 25 years, ITC = 25%, Capacity Factor is 24%,…

A: P=100MW BUILD COST=$1.1/W LIFE=25 YEARS ITC=25% CAPACITY FACTOR=40% O&M=$30/kw-YR INTEREST…

Q: Explain the term self-sustaining.

A: Self sustaining is a broader term and refers to the ability of a person , a community or nation to…

Q: a) Explain the working principle of a geothermal power plant with a neat diagram. I b) Mention the…

A: Geothermal power plant use hydrothermal energy i.e. energy from both water and heat. Resources like…

Q: "The Physics of Electricity Generation" discuss the nature of the electricity you receive from your…

A: The most common method of the generation of electric power is from mechanical power. In power…

Q: In which of the following Geothermal Energy power plant system, comparatively low temperature water…

A: Dry power plant The dry system power plant use underground water steam resources. Hence, the high…

Q: lectrical power is distributed and consumed in AC or DC. Discuss the reasons that resulted in AC…

A: The transmission and distribution of electrical power is only in AC form but in some applications…

Q: 1. In your own opinion. What will happen if Electric Circuit Board hasn't been invented?

A: Circuit boards aren’t that important. If we couldn’t use them there are other ways to connect…

Q: Advantages and Disadvantages of using solar energy.

Q: (a) If element X of the circuit is an independent current source, with the arrow pointing upward,…

Q: Solar energy provides more energy per acre of land than wind or hydropower True False

Q: How do we maintain the levels of the internal resistance of power supplies?

A: Power is the foundation of any electronic framework and the force supply is the thing that takes…

Q: If a 20 W light bulb runs for 8 hours per day, then how many units of electricity it will consume?…

A: The power rating of the given light bulb is P=20 W If the light bulb runs continuously for 8 hours…

Q: What kind of solar technology does the country of Ghana have

A: Ghana is rich in an array of renewable energy resources, including biomass, solar, wind, and…

Q: a) In a Power System, Define the following (i) Peak Load (ii) Spinning Reserve

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Calculate the current of the 40 ohms resistance , put the result in mA

A: In this question we have to find out current through 40 ohm resistance with the help of kcl..

Q: How does electrical energy improves the life of the people?

A: Electrical energy is very important everyones life. Because without electricity there cannot be any…

Q: POWER GENERATION Identify the different farming activities that use electricity. Discuss the…

A: Electricity become essential for agriculture because it increases efficiency of a farmer. Without…

Q: A power Source is a device which converts mechanical, chemical, thermal or some other form of energy…

A: Need to find correct answer

Q: Suppose a voltage surge produce 280V at a moment. At what percentage to its power output of a 240V,…

A: Given data, Voltage, V1 = 280 V. Voltage, V2 = 240 V. Power, P2 = 110 W. The expression for power…

Q: The Power dissipated by a device is 40 Watts. How long will it take to deliver 640 Joules?

A: We know that power of an entity is defias the amount of work done or energy spent per unit time i,e.…

Q: A 470 ohm resistor has 18.8 volts across it. What is the power consumed by that resistor? Enter your…

A: Given, Resistance, R = 470 ohm Voltage across it, V = 18.8 volts

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

a) Explain briefly how electricity can be sold to a grid by use solar
energy.
b) Wind farm consist of ten wind turbines with nominal capacity of
2MWper turbine, has a total of 20 MW for farm as a whole, in year
2020, the farm produced a total energy 43416MWH, find a capacity
factor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Discuss wind power in future power system
What is the purpose of power factor correction to a given load? O To reduce the amount of voltage to the load. O To reduce the amount of dependence on automated machinery. O To reduce the amount of current to the load. O To reduce the amount of resistance of the load.
Define conventional energy resources. Name any one of them and mention its disadvantage. A- B
Advantages of using per unit system in power system studies is O a. None of these O b. Both more informative and calculations are easy. O c. More informative O d. Calculations are easy
A generator operating at 50 Hz delivers 1 p.u. power to an infinite bus through a transmission circuit in which resistance is ignored. A fault takes place reducing the maximum power transferable to 0.5 p.u. Where as before the fault, this power was 2.5 p.u. and after the clearance of the fault, it is 2 p.u. The value of 8 is max
The incremental fuel costs, in dollars per megawatthour, for two units in a plant are given by dF dP, dR dP, Select one: = 0.007P, +7 and During a 24-h period the load on each unit varies between 100 MW and 500 MW, whereas the plant output varies from 200 MW to 700 MW. (a) At what power level should unit 2 begin to take on all the additional load for the most economic operation of the plant? (b) What is the power output of the plant at this point? Neglect losses. a. a: 122.22MW. b: 222.22KW b. a: 222.22MW, b: 122.22KW ca: 122.22MW, b: 222.22MW d. a: 222.22MW, b: 122.22MW = 0.009P₂ +6
What is Energy crisis? What are the causes of energy crisis? Explain the consequences and possible solutions of the energy crisis. Please write the sources
describe how you will make use of green technology to sustain the electricity supply in North coast( KZN)
If the wind is blowing at 10 meters/second, what is the maximum power that can begenerated from the wind hitting the wind turbine 30m blades. Assume the wind turbine isat sea level.
Discuss typical structure of the modern electrical grid. Include all elements and provide short description of their role in the system
Why in high voltage system, we prefer direct or small resistance? How to define the classes of load? Why we should to do such classification??(find answer from website) what are the main load curves of the power system? What is the maximum load utilization hours? What are the applications of load curve and annual load curve in the design and operation of power system? (find answer from website)
Discuss the challenges of Renewable Energy