A) Calculate FA for the uniform cantilever shown in the figure whose mass is 1250 kg .(Figure 1) Assume xA = 21.0 m and xB = 28.0 m . Express your answer with the appropriate units.   B) Calculate FB. Express your answer with the appropriate units.

Q: Modelled after problem 5 in the Problems_Torque_Statics: A 16.19-m-high and 11.44-m-long wall under…

A:

Q: Bobina and Bob are on the seesaw down at the elementary school playground and decide to see if they…

A: Weight of Bobina , W1 = 400 N Weight of Bob, W2 = 450 N Distance of Bobina from the fulcrum , R1 = 2…

Q: Priya and her friend Fei opened up a tea shop that serves tea from around the world. For their new…

A: At the hinge point, two forces act. One is in the upward direction and the other is in the rightward…

Q: children decide to make a crane for their dogs bone (Picture attached). The boom (a piece of wood)…

A: Given: Weight of wood is 10 N Weight of bone is 5N Tension is 30.15N To find: the magnitude of the…

Q: Select one: O a. O b. P O C. Pivot Pt. 250.m N (CW) 405.m N (CW) 250. m N (CCW) Od. 405. m N (CCW) A…

A:

Q: A house painter stands 3.00 m above the ground on a 5.00-m-long ladder that leans against the wall…

A:

Q: An individual leans forwards to pick up a box of 100 N. The weight of his upper body has a magnitude…

A:

Q: A worker of weight 758.6 kg stands on the end of a beam of weight 1651 N and length L= 109.2 m,…

A: Given  Mass of worker m=758.6kg Weight if beam =1651N L=109.2m X=29.2m

Q: L.

A:

Q: 7. A uniform ladder of mass (m) and length (L) leans against a frictionless wall, see figure. If the…

A: The mass of the ladder: The length of the ladder: The inclination angle: The coefficient of static…

Q: You want to suspend a 2.8 kg 0.8 m long rod in place so that when your brother enters the room it…

A:

Q: A bar weighs 8 N and is 5 m in length. What is the weight needed (M) to balance the bar? Don't…

A:

Q: A uniform rod has weight 4.0 N and length 1.0 m.   It is resting on two supports – the left support…

A: Given: The weight of the rod is 4 N. The length of the rod is 1 m. The position of the left support…

Q: A worker of weight 756.5 kg stands on the end of a beam of weight 1699 N and length L= 118.7 m,…

A: Given  Mass of worker =756.5kg Weight of beam =1699N L=118.7m X=26.7m

Q: A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 58.0-gram…

A:

Q: A 79 kg adult sits at one end of a 9.0m long board. His 21 kg child sits on the other end. Part A…

A:

Q: Question 17 A beam 6 m in length is placed on a support so that it pivots at the point of the…

A:

Q: A beam resting on two pivots has a length of L = 6.00 m and mass M = 92.0 kg.The pivot under the…

A: (a) Condition for rotational equilibrium τnet=0n2l-mgx-MgL2=0n2=mgx+MgL2l

Q: 2 children decide to make a crane for their dogs bone (Picture attached). The boom (a piece of wood)…

A: Consider the following diagram:

Q: A weight of 6 N is located 11 cm from the fulcrum on the beam of a simple balance. What weight…

A: Weight located on one of the side of the fulcrum (W1)=6 N Distance of weight from the fulcrum…

Q: uniform beam of weight 58 N and length 6.0 m is mounted by a small hinge on a wall at it left end.…

A:

Q: Sam and Joe are carrying a 400 N uniform beam when Cheetah (Tarzan's pet chimp having a mass of 33.0…

A:

Q: You are preparing for a balancing act. A 50-kg, 7.0-m horizontal beam is supported by a fulcrum at a…

A: Torque = force × perpendicular distance

Q: In exercise physiology studies, it is sometimes important to determine the location of a person's…

A: Consider that there are three forces at the location of the center of gravity. The balancing forces…

Q: The uniform 7.9-m pole has a mass of 145 kg and is supported as shown. Calculate the force Prequired…

A:

Q: Shown is a lightweight plank supported at its right end by a 7.0-mm-diameter rope with a tensile…

A: Given data: The diameter of the rope is: d = 7 mm The tensile strength of the rope is: T = 6.0×107…

Q: A horizontal beam of mass 90.2 kg and length 25.0 m rest on two supports A and B as shown. The…

A: Since both the reactions are positive, this is a stable position.

Q: Two people are carrying a uniform wooden board that is 3.20 m long and weighs 180 N . 1) If one…

A:

Q: A 5.00 m–long uniform diving board that weighs 250.0 N is supported by two pillars. One pillar is at…

A: The free-body diagram of the board is shown below.

Q: The uniform beam has a mass of 55 kg per meter of length. Determine the reactions at the supports.…

A:

Q: 4. A 20 m long uniform bridE ends. An 800kg block is locat apply to the bridge. (F1 and F

A:

Q: no ai please. it will be wrong

A: Please see the attached image for the solution.If there are queries or if the image is not loading,…

Q: A uniform plank has mass M = 9 kg and length L = 4.0 m. A box of mass m = 2.2 kg rests on it at a…

A: Given data: The mass of the uniform plank, M=9 kg. The length of the plank, L=4.0 m. The mass of…

Q: A 8.08m long rigid beam with a mass of 145.4kg is supported at each end. A 66.0kg student stands…

A: Length of beam                             L = 8.08 m Mass of rigid beam…

Q: A uniform beam of length L = 7.65 m and weight 545 N is carried by two men, Sam and Joe, as shown in…

A:

Q: A bridge of length 50.0 m and mass 7.60 * 10^4 kg is supported on a smooth pier at each end as shown…

A:

Q: Question 18 A bar weighs 2 N and is 5 m in length What is the weight needed (M) to balance the bar?…

A: The weight  of the bar is 2 N.The length of the bar is 5 m.The hinged point from the left side the 3…

Q: Question 19 A beam 8 m 0000 length is placed on a support so that it pivots at the point of the…

A:

Q: Modeled after problem 5 in the Problems_Torque_Statics: A 13.98-m-high and 12.18-m-long wall under…

A:

Q: A bucket crane consists of a uniform boom of mass M = 201 kg and length L = 59.81 ft that pivots at…

A:

Q: 4.0 m

A: Given Weight of beam = 13 N Length of beam = 6 m Rope is join with beam at 2 m from the hinge

Q: gymnast with a mass of 54 kg stands on the end of a uniform balance beam as shown in the figure.…

A:

Q: Hi I needed help with this question. As shown in the figure below, a uniform beam is supported by a…

A:

Center of Gravity of a system

The centre of gravity is a property that is based on the geometry of a rigid body or any particle. It is described as an equilibrium point or a hypothetical location where the total weight of the body is concentrated.